CHXICO 0-10V LED Dimmer Switch User Manual
- June 17, 2024
- CHXICO
Table of Contents
User manual for 0-10V Dimmer
0-10V LED Dimmer Switch
Single Pole&3 way LED Dimmer AC 120V~277V 50~60Hz
300W for dimmable LED/CFL,1000W Max for dimmable incandescent lamps
Important Notes, Please read before installing.
- Turn off power at circuit breaker or fuse before wiring.
- Only one dimmer can be used per 3-way circuit.
- It’s normal to be warm when the dimmer is under operation.
- For supply connector, use wires rated for at least 75℃ and use copper wire only.
Caution – To reduce the risk of overheating and possible damage to other equipment, do not install to control a receptacle, a motor-operated appliance or a fluorescent lighting fixture or a transformer supplied appliance.
Installation
1.Turn power off
2.Wiring the dimmer
2.1 Dimming with On/Off Control without Power Pack
Single Pole Wiring
3-way Wiring
2.2 Dimming with ON/OFF Control using power pack
Dimming with ON/OFF Control-wallbox wiring
2.3 Dimming only wiring
Dimming only–wallbox wiring
3.Mounting Dimmer to Wallbox,intall wallplate
4.Turn power on.
Dimming Range Adjustment
- Push dimmer on and move slider down to the bottom.
- Turn knob down unitil lowest light level is achieved and light output is stable for all bulbs.
- Turn dimmer off,then back on to verify bulbs.
- Turnknowb up lightly and do step 3 again if all bulbs do not turn on.
Lights do not operate at full brightness:
Push slide down, Turn high-end knob clockwise with a screwdriver to achieve
maximum light intensite.
Light do not dim low eneough:
Push slide down. Turn the low-end knob counter-closewise to achieve minimum
light intensity.
Slider: Control light leve.
Switch: Turn lights on/off
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>