Schuller 373378D Dimmable Item Instruction Manual
- June 17, 2024
- Schuller
Table of Contents
Schuller 373378D Dimmable Item
Product Information
- Specifications
- Model: Dimmable
- Includes LEDS with 0-10V or PWM dimming capabilities
- Recommended to use special screws provided for installation
- Requires attention to earth wire marked with a green line
- Includes set of 3 capacitors in the original position
- LED driver compatible with wall dimmers supporting 0-10V or PWM dimming
- Surge protectors recommended to avoid damage to electronic components
- Product Usage Instructions
- Ensure to use the special screws provided for installation.
- Pay attention to the earth wire marked with a green line.
- If you need to shorten the wires, maintain the set of 3 capacitors in their original position.
- Use only wall dimmers compatible with 0-10V or PWM dimming to avoid damage to the LED driver.
- Ensure that the channel 1 is selected on the remote control for proper operation.
- Install surge protectors to prevent damage to electronic components.
- FAQ (Frequently Asked Questions)
- Q: Can I use any type of dimmer with this product?
- A: No, it is recommended to use only wall dimmers compatible with 0-10V or PWM dimming. Using other types may damage the LED driver.
- Q: What should I do if the electrical wire is damaged?
- A: For safety reasons, any damaged electrical wire must be repaired by qualified staff.
- Q: How can I ensure the wires are straight if twisted?
- A: Hold the bottom of the cable and use a screwdriver or metal rod to stroke the cable up and down to keep it straight.
- Q: Where can I find the complete technical data sheet of the product?
- A: You can use the provided QR code to view the complete technical data sheet of the product.
- Q: How can I contact technical support for further questions?
- A: You can contact our Technical Department via email at irodriguez@schuller.es. for any technical queries.
ASSEMBLING INSTRUCTIONS
ITEM 373378D
DIMMABLE ITEM
ATTENTION: Schuller recommends to use included special screws when installing this lamp.
ATTENTION: In case you need to shorten the wires,
- keep the set of 3 capacitors in the original position.
- Pay attention to the earth wire, it is marked with a fine green line.
- Please, make sure about this before reconnecting it.
NB: If the cable is twisted, please hold the bottom of the cable, and use
a screwdriver or a metal rod to stroke the cable up and down to keep it
straight.
NOTE: For safety reasons, if the electrical wire of this item has any
damage, it must be repaired by qualified staff
You may use the following QR code to view the complete technical data sheet of the product:
This product includes LEDS with 0-10V or PWM dimming. To use it with a wall dimmer, use just this type of dimmer. Any other type would damage the LED driver. The receiver installed in the product has channel 1 selected. Use this channel also on the remote control. SCHULLER RECOMMENDS PLACING SURGE PROTECTORS TO AVOID DAMAGE TO THE ELECTRONIC COMPONENTS OF THE LED LUMINAIRE.
Available in our catalogue
If you have any technical questions, please do not hesitate to contact our
technical Department. We are at your disposal in our email:
irodriguez@schuller.es.
Rev. 06.23
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>