CMS Electracom Echo Series Single Indesk Unit Instruction Manual
- June 17, 2024
- CMS Electracom
Table of Contents
CMS Electracom Echo Series Single Indesk Unit
Product Specifications:
- Model : ECHO SINGLE INDESK UNIT
- Part Numbers: ECBSN , ECBSF5
- Compatible with: EC1E, EC01, ECW, ECUAC3
- Regions: Australia, New Zealand, Asia-Pacific, United Kingdom, United States
Product Usage Instructions:
Installation Instructions:
- Determine the desired orientation of the product and cut a hole into the desktop or joinery. Ensure the notch is parallel to the GPO in a horizontal position. Refer to the provided drawing for guidance.
- Fold the clamps into the provision within the housing. Align the dimple on the housing with the notch in the cutout and insert the housing into the desk.
- Screw through the plastic housing and clamps so that they rotate out of the housing. Tighten the screws until the assembly clamps down securely. The clamps will grip the underside of the desk. Do not over-tighten; tighten by hand only.
- Align the guide and clips on the underside of the cover with provisions in the housing. Secure the top cover and push down above where the clips are positioned.
- Plug the unit into a power source.
(FAQ):
- Q: Can this product be used in other regions outside those listed?
- A: The product is designed for use in Australia, New Zealand, Asia-Pacific, the United Kingdom, and the United States. Use in other regions may require additional adapters or converters.
- Q: How do I clean and maintain the ECHO SINGLE INDESK UNIT?
- A: To clean, use a soft, damp cloth to wipe down the unit. Avoid using harsh chemicals or abrasive materials that may damage the surface. Regular maintenance includes checking for loose screws and ensuring proper alignment for optimal performance.
PARTS NUMBER
Installation Instructions
-
STEP 1 – CUT OUT
Determine the desired orientation of the product and cut the hole into the desktop or joinery. The notch will be parallel to the GPO in a horizontal position. REFER TO DRAWING. -
STEP 2 – INSERT UNIT INTO CUTOUT
Fold clamps into provision within the housing. Align the dimple on the housing with a notch in the cutout and insert the housing into the desk. -
STEP 3 – TIGHTEN SCREWS
Screw through the plastic housing and clamps so that they rotate out of the housing. Tighten screws until the assembly clamps down and is secure. The clamps will grip into the underside of the desk. DO NOT OVER-TIGHTEN – TIGHTEN BY HAND ONLY. -
STEP 4 – CLIP-ON COVER
Align the guide and clips on the underside of the cover with provisions in housing. Secure the top cover and push down above where the clips are positioned. -
STEP 5 – POWER DEVICE Plug unit into power source.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>