SWEETFULL S10 Lint Remover User Manual

LINT REMOVER
User’s Manual

Thank you for purchasing and using this product. Please read the instruction manual carefully before using the instruction manual, and please keep the instruction manual properly!

Product parameter

Intensity
adjustment| Third gear
Power| 4.6W
Product Size| 15711980mm
Product List| Lint removerl, Charging Cabell, Brush1. Mantuan*1

The above parameters are all from the laboratory, and the actual parameters will vary due to products or other factors; the pictures are for reference only, please refer to the actual product!

Product overview

Instructions for use

1. Trim the hairball
   Lay the garment flat on a flat surface

Use the hairball trimmer to remove hairballs by repeatedly moving it across the garment. Note: Please arrange the clothes flat, and special attention should be paid when trimming the following parts to avoid damage to the clothes.
Protruding parts of clothing
Around buttons and zippers
Clothing interface or sewing thread end
Foreign matter stuck to clothing Soft or cracked areas
Short press the switch button, the hair ball trimmer will start, the default is 1 low-speed operation, the digital tube will display the current power, and the power symbol will light up at the same time, and the real-time power will be  displayed after three seconds; Short press the switch button again to switch to the second gear and work at medium speed, and the real-time power will be displayed after three seconds; Short press the switch button for the third  time to switch to the third-speed high-speed operation, and the real- time power will be displayed after three seconds; Short press the switch button for the fourth time, stop working, and cycle in turn.

• Clean up dander
  Pull down the cover, remove the hair ball chamber and pour out the dander. After cleaning, put the hair ball chamber back onthe handle, and push it up to fix the hair ball chamber.
  *Note: The switch key should be turned off when cleaning the hair ball compartment.
• Replace the blade
  Unscrew the knife net Close the knife net and rotate and fx it Note: The blade is sharp, it is easy to cut your hand, please be very careful when replacing the blade, be careful not to cut your hand;
  If you purchase a replacement blade, keep it out of the reach of children to prevent accidents Take out the old blade, replace with a new blade

Charging matters

1. Be sure to fully charge the product before using it for the first time.
2. This product comes with a lithium battery, which can be easily used without plugging in.
3. When in use, the digital tube will decrease according to the current power usage, and it will automatically shut down until the power shows 0%.
4. When charging, Green lightning bolt flashing, and when fully charged, the LED lights up continuously; when charging, the digital tube increases according to the charging time until it displays 100% when fully charged.
5. The product supports the function of charging and discharging at the same time. During the charging process, short press the switch button and the product can be used normally.

Product protection

1. Protection switch: After the machine is turned on, the machine detects the protection switch in realtime. After the machine head is installed, the protection switch is invalid and the machine canworknormally. can stop automatically; when the cutter head is opened, the protection switch is effective, and the motor will stop working at this time;
2. After the front cover is opened and the protection switch is invalid; if the function is reset, itis necessary to twist the front cover and restart the machine.

Show description

charged; Displays 100% when fully charged.
Full charge| Display 100% always on

Frequently asked questions

Check whether the knife net is tightened.
Check whether the blade is stuck by foreign objects, and whether there is a jamming phenomenon.
Not trimmed cleanly| Try pruning multiple times.
Try turning up the gear trim.
Check whether there is excessive accumulation of dander in the hair ball bin and clean it up in time.
Check whether the blade and knife net are installed properly.
Check the blade for excessive wear, replace the blade.

Matters needing attention

1. Please read the manual carefully when using it, and keep it properly for future reference.
2. Please strictly abide by the use of this product, ignoring or operating errors may cause major accidents or injuries.
3. Illegal operation may damage your clothing and even endanger your personal safety.
4. Do not let children operate this product, please keep it out of reach of children and keep it properly. Unsupervised use by children is prohibited.
5. This product is not recommended for use by persons with disabilities, sensory or mental disabilities, or lack of relevant experience, unless supervised and guided bay qualified person.
6. Before using this product, be sure to spread the clothes flat to avoid damage to the clothes.
7. When the product is turned on, do not open the knife net.
8. Be sure to turn off the power first when cleaning the product, cleaning dander, replacing the blade or when it is not in use, so that the product is in a shutdown state.
9. Avoid dropping, bumping or scratching the surface of the product with sharp objects to avoid damaging the product.
10. Do not charge the product near or near a heat source, and do not go out while charging, otherwise it may cause dangers such as leakage or fire due to deterioration of insulation.
11. When charging with a charger, please use a charger that has obtained CCC certification and meets the standard requirements.
12. Do not let water or other liquids flow into the product, otherwise it may cause product damage or short circuit failure.
13. Do not throw this product into fire as it may explode.
14. Do not store this product in a humid environment.
15. When the product is not used for along time, please clean the product and store it in a ventilated and dry place.
16. Continued use if the product cannot be used in an accident. Please contact the after-sales service of our company in time, and do not disassemble and repair, attempt to disassemble or change the structure of this product by yourself, so as to avoid unnecessary failure or danger.

Warning: Keep the appliance dry!
Battery warning

1. It is forbidden to disassemble, impact, squeeze or throw into fire. Do not continue to use if severe swelling occurs. Do not place in high temperature environment.
2. There is a risk of explosion if the battery is improperly replaced, and should only be replaced with the same or equivalent type of battery.
3. The battery (battery pack or combined battery) shall not be exposed to such overheating environment as sunlight, fire or similar.
4. Do not use the battery after immersion in water.
5. This product contains lithium battery, please dispose of it separately from household waste. To reduce pollution and maximize the protection of the earth’s environment, please recycle it.

Warranty card

Customer Name :————————
Contact number: ————————
ProductName :—————————-
Purchase date :—————————-
Warranty content;————————
Warranty Date:————————–
Address:———————————
Remark : ——————————–

Warranty Statement

• During the normal use of this product, if the product has a performance failure that is not artificially damaged, consumers will enjoy free warranty services from the date of purchase. The warranty period is 12 months.
• The products, specifications and information mentioned in this manual are for reference only, and the content may change with the development of technology, design and product specifications without prior notice.
• In one of the following situations, consumers cannot enjoy free warranty rights:

1. Human damage;
2. Beyond the warranty period;
3. Availed proof of purchase cannot be provided;
4. Product damage caused by not using, maintaining and maintaining as required by the instructions;
5. Unauthorized disassembly, repair of the product, or immersion of the product in water;
6. Damage caused by other force majeure;
7. This warranty will be void if the original product identification label has been altered or damaged.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>