AS-VERTERE-SABREMM High-End Moving Magnet Cartridge User Manual
- June 4, 2024
- Sabre
Table of Contents
AS-VERTERE-SABREMM High-End Moving Magnet Cartridge
Introduction
Vertere Sabre Hi-End Moving Magnet Phono Cartridge is designed & manufactured in the UK to exacting standards to provide you with many years of musical enjoyment.
Installation
It is important to handle the cartridge with care and to have it correctly
installed for optimum performance. Extreme care must be taken when fitting the
tonearm cartridge tags to the Sabre output pins. Please observe polarity and
colour.
Mount the cartridge to the tonearm head-shell using the Vertere thumb screws
provided. Please ensure the stylus guard is on to protect the stylus and the
cantilever while handling or fitting the cartridge. Hold the cartridge body
when fitting the screws in place and take care not to drop the cartridge
accidentally. Do not fully tighten these yet to assist final alignment. Remove
and fit the stylus guard as shown. Holding from the sides and gently rocking
the guard to release the four locking pins. IMPORTANT
Sabre’s generator fixing screws shown in the picture are factory fitted and
critically adjusted.
DO NOT touch or attempt to adjust these four generator fixing screws.
Generator Fixing Screws
Always follow the tonearm manufacturer’s instructions and use their
supplied alignment protractor. Set the tracking weight initially to
approximately 1.9/2.0g and adjust the VTA so that the head-shell/cartridge are
parallel to the surface of the record. Using the tonearm alignment
protractor, check the cartridge alignment and adjust as required and finally
tighten the thumb screws. Recheck and reset the tracking weight to 2.0g and
apply anti-skate force as required.
NOTE
VTA, tracking weight and anti-skate force settings can be fined tuned using a suitable Test Record and listening. However, final settings should not fall outside of Vertere’s recommended ranges – If in doubt, consult your authorised Vertere re distributor, retailer or Vertere.
Specifications
- Generator Type : Moving Magnet
- Output : 4.0mV (@ 1kHz, 5cm/sec.)
- Recommended : 47kQ
- Phono Input Load : 1OOpF – 220pF
- Recommended : 2.0g –
- Tracking Weight : (1.9g – 2.lg)
- Frequency Response : 15Hz – 25kHz
- Channel Separation : Minimum 22dB
- Coil Resistance : 1 kQ (Per Channel)
- Dynamic compliance : 10 x 10-5 cm/dyne
- Stylus : Elliptical Diamond (7.5 X 15.5 µm)
- Cantilever : Aluminium Alloy Tube
- Mounting : Special Tri-Point Contact With M2.5 Threaded Fixing Holes
- Generator Fixing : Special Quad-Point Contact With Four Stainless ‘Spike’ Screws
- Net Weight : 10.3g
Warranty
Your Sabre Cartridge is guaranteed against any defect in materials and workmanship for a period of two years from the date of purchase. You can extend this period to three years by registering your warranty on the Vertere website – vertereacoustics.com
Disposal of Old Electrical & Electronic Equipment
Applicable in European countries with separate collection systems
This symbol on the product or on its packaging indicates that this product
shall not be treated as household waste. Instead it shall be handed over to
the applicable collection point for the recycling of electrical and electronic
equipment. By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and human health,
which could otherwise be caused by inappropriate waste handling of this
product. The recycling of materials will help to conserve natural resources.
For more detailed information about recycling of this product please contact
your local city office, your household waste disposal service or the shop
where you purchased the product.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>