FRANK GOODMAN Light Filtering Top Down Shades Instruction Manual
- June 17, 2024
- FRANK GOODMAN
Table of Contents
FRANK GOODMAN Light Filtering Top Down Shades
INSTALLATION INSTRUCTION
-
Drill 4 screws into points that 0.35″ from each of the four corners of the window frame. In addition, the distance between the top of the screw and the window frame is 0.1″ .
-
laser the top left and right clips into the screw.
-
Place the blind at the bottom of the window frame horizontally.
-
Untie the knots on the two cords connected to the bottom rail.
-
Pass the two cords connected to the bottom rail through the clips respectively.
-
Tighten the left and right cords,. make the bottom clip close to the bottom rail, and mark the point (make the point between bottom rail and clip) on the cord.
-
Tie a knot at the 1 mark.
-
Insert the bottom left and right chip’s into the screws.
-
Buckle the handles on the top and bottom rails of the blind.
-
After making sure that the blind can be used normally, cut off the excess part of the cords.
Tip 1 : Must tighten the cord before, tie a knot at the mark, or
honeycomb shade will fall down!
Tip 2 : For outside mount fixators need to be fixed on the wall around
the window frame.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>