Dimplex HLM20 Helmsdale Optiflame Inset Electric Fire User Manual
- June 17, 2024
- Dimplex
Table of Contents
Dimplex Optiflame Inset Fire
Helmsdale HLM20
HLM20 Helmsdale Optiflame Inset Electric Fire
How do | install my Helmsdale Inset Fire?
Ensure that all packing items are removed (read any warning labels carefully). Retain all packing for possible future use e.g. in the event of moving or returning the appliance to your supplier. 1. Clean the area where the fire will be installed e.g. remove ash residue from an existing fireplace. 2. Hold the fire by the sides of surround and gently manoeuvre into position. 3. Plug the fire into a 13amp/240 volt outlet. Ensure that the supply cable is not trapped under the fire such that it might cause it to be damaged
What are all the buttons on my remote control?
A-Power button B — Flame Effect — 3 flame effect options C -Sleep timer — 8 hour run-back timer D - Set heater — low, high, cool blow and off E-— Temperature control Down — in 2°C increments F — Temperature control Up — set up to 30° C G — Flame colour — turns on colour accents H — Top light - turn on/off as desired For full instructions, refer to the product instructions.
What battery does the remote use?
It takes a CR2025. There is one included with your fire to get you started.
How do | look after my Helmsdale Inset Fire?
Before commencing cleaning, unplug the heater and allow it to cool. The surfaces of the heater should be given an occasional wipe with a dry soft cloth. Do not use detergents, abrasive cleaning powder or furniture polish as this can damage the surface finish of the product. The glass screen should be cleaned carefully with a chamois leather. Do not use proprietary cleaners. To remove any accumulation of dust or fluff, the soft brush attachment of a vacuum cleaner should occasionally be used to clean the outlet grille of the fan heater located under the canopy. To clean the fuel effect, remove the coal/pebbles and wash in warm water. The plastic tray should be wiped clean with a damp cloth. When dry replace the coal/pebbles and arrange for best effect.
Do the bulbs need to be changed?
No. This fire is fitted with LED (Light Emitting Diode) lamps in place of traditional incandescent bulbs. These generate the same light levels as traditional bulbs but use a fraction of the energy consumed. These lamps cannot be replaced.
What happens if my fire develops a fault?
Your product is guaranteed for one year from the date of purchase. Within this period, we undertake to repair or exchange this product free of charge provided it has been installed and operated in accordance with these instructions. Your rights under this guarantee are additional to your statutory rights, which in turn are not affected by this guarantee.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>