Outwell 651241 Orion Lux Cream White Instruction Manual
- June 17, 2024
- Outwell
Table of Contents
Outwell 651241 Orion Lux Cream White
Specifications
- Model: Orion Lux
- Available Colors: Cream White (Model: 651241), Shadow Green (Model: 651242)
- Light Source: LED
- Energy Efficiency Class: E
- Power Supply: 5V, 1.5A, 7.5W
- Remote Control Power: 12W (1x12V MN21)
- Class: 3 Appliance
Removal of Light Source
- Remove the lamp lens by using a flathead screwdriver to open the four tabs.
- Unscrew the 2 screws holding the PCB with LEDs in place.
- Cut the needed wires to remove the required components for testing.
Disassembly of Lamp for Disposal
- Refer to the steps for removing the light source.
- Cut wires and remove screws to allow removal of electronics on the circuit board.
- Dispose of electronics according to local regulations.
- Dispose of remaining components according to local regulations.
Light modes
- Press the button (1.) to switch on / off the light.
- Press and hold the button to dim the light. The light can be dimmed stepless to any setting between maximum and minimum light output.
- Press the ON button on the remote (8.) to switch on the light.
- Press the OFF button on the remote (8.) to switch off the light.
- When using the remote, the dim setting selected on the (lamp) button (1.) will be remembered.
Use of the lamp
- Connect the USB plug (5.) to a reliable power source.
- To extend the lantern lampshade, grab the edge of the lampshade (6.) and push the body out from the inside, do not pull on the cord.
- To collapse the lampshade, reverse the above.
- Hang the lamp from the hanging point, and adjust the height as needed by gently moving the cord through the adjuster.
- For indoor use only.
- The lamp can be cleaned with a damp rag.
- Do not use corrosive liquids to clean the lamp.
- Do not stare into the light source
Light source: LED
- This product contains a light source of energy efficiency class E.
- The light source is not replaceable. This would introduce weak points in the construction, that could reduce the lifetime of the product.
Instruction for removal of the light source by market surveillance authorities
- Remove the lamp lens by using a flathead screwdriver to open the four tabs.
- Unscrew 2 pcs screws holding PCB with LEDs in place.
- Cut needed wires to remove the required components for testing.
- Instruction for disassembly of lamp for disposal of components when the lamp has reached the end of its usable life:
- See steps 1-2 above
- Cut wires and remove screws to allow the removal of electronics on the circuit board.
- Dispose of electronics according to local regulations.
- Dispose of remaining components according to local regulations.
Technical data (lamp)
Outwell® is a reg. trademark of Oase Outdoors ApS, EU: Kornvej 9, DK-7323
Give, Denmark
UK: One Glass Wharf, Bristol, BS2 0ZX
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>