BRAYER BR1142 Coffee Maker Instruction Manual

June 4, 2024
BRAYER

Instruction manual

COFFEE MAKER BR1142

[email protected]
The unit is intended for making Turkish coffee.

DESCRIPTION

  1. Coff ee maker body
  2. Flask
  3. On button « **** »
  4. Temperature sensor
  5. Flask handle
  6. Measuring spoon

ATTENTION!
For additional protection it is reasonable to install a residual current device (RCD) with a nominal operating current not exceeding 30 mA, to install RCD, contact a specialist.

SAFETY MEASURES AND OPERATION RECOMMENDATIONS

Read the operation instructions carefully before using the coffee maker and keep them for future reference.

  • Use the coffee maker for its intended purpose only, as specified in this manual.

  • Mishandling the unit can lead to its breakage and cause harm to the user or damage to the user’s property, which is not covered by a warranty.

  • The coffee maker is intended for making coffee, heating and boiling drinking water, do not heat or boiling any other liquids.

  • Make sure that the operating voltage of the coffee maker indicated on the label corresponds to your home mains voltage.

  • The power plug is equipped with a grounding contact, plug it into the socket with reliable grounding contact.
    In the case of a short circuit, the grounding reduces the risk of electric shock.

  • Contact an electrical technician, if you are not sure that your sockets are installed properly and grounded.

  • To prevent fire do not use adapters designed for connecting the plug to the mains socket without grounding contact.

  • In case of sparking in the mains socket and occurrence of the smell of burning, unplug the unit and apply to the organization maintaining your home mains.

  • If smoke appears from the unit body, unplug the unit and take measures to prevent fire from spreading.

  • Apply to the service center for inspection or repairing the coffee maker.

  • Do not use the coffee maker outdoors.

  • It is not recommended to use the unit during lightning storms.

  • Protect the unit from impacts, falling, vibrations, and other mechanical stress.

  • Never leave the plugged-in coffee maker unattended.

  • Do not use the coffee maker in proximity to the kitchen sink, in bathrooms, near swimming pools, or in other containers filled with water.

  • If the unit is dropped into water, unplug it immediately, and only then you can take the unit out of water.

  • Do not use the coffee maker near heating appliances, heat sources, or open flame.

  • Do not use the unit in places where aerosols are used or sprayed, and in proximity to inflammable liquids.

  • Place the coffee maker on a flat stable surface; do not place it on the edge of a table.

  • Do not let the power cord hang from the edge of the table and make sure it does not touch hot surfaces or sharp edges of furniture.

  • Do not use the coffee maker near furniture or interior items, which can be damaged by moisture or hot steam.

  • Do not touch the power cord and the power plug with wet hands.

  • Do not switch the flask on if the water tank is empty.

  • Ensure that the water level in the coffee maker is not above the maximal mark. If the water level exceeds the maximal mark, boiling water can splash out during boiling.

  • To avoid burns from hot steam, do not bend over the coffee maker.

  • The flask body surface and the heating element may have rather high temperatures. Be cautious and careful when in contact with heated surfaces of the coffee maker.

  • Be careful when carrying the coffee maker with ready coffee. Pour the ready coffee carefully, do not tilt the coffee maker sharply. In case of careless use, you may have been burned by hot water or coffee.

  • Unplug the flask before cleaning or when you are not using it. When unplugging the flask hold only the power cord plug and carefully remove it from the main socket, do not pull the power cord — this can lead to damage to the power cord or the socket or cause a short circuit.

  • To avoid electric shock do not immerse the coffee maker in water or any other liquids.

  • Do not wash the coffee maker in a dishwashing machine.

  • For children’s safety reasons do not leave polyethylene bags, used as packaging, unattended.

ATTENTION!
Do not allow children to play with polyethylene bags or packaging film. The danger of suffocation!

  • The coffee maker is not intended for usage by children.
  • Do not leave children unattended to prevent using the unit as a toy.
  • Do not allow children to touch the unit and the power cord during the coffee maker operation.
  • Place the unit out of reach of children during the operation and cool down.
  • This unit is not intended for usage by physically or mentally disabled persons (including children) or
  • by persons lacking experience or knowledge if they are not under the supervision of a person who is responsible for their safety or if they are not instructed by this person on the usage of the unit.
  • Check the integrity of the power cord, the power plug, and the coffee maker body periodically.
  • If the power cord is damaged, it should be replaced by the manufacturer, a maintenance service, or similarly qualified personnel to avoid danger.
  • Do not repair the unit by yourself. Do not disassemble the unit by yourself, if any malfunction is detected, and after it was dropped, unplug the unit and apply to the service center.
  • Transport the coffee maker in the original package.
  • Keep the unit out of reach of children and disabled persons.

THE UNIT IS INTENDED FOR HOUSEHOLD USE
ONLY, DO NOT USE THE UNIT FOR COMMERCIAL OR LABORATORY PURPOSES
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low temperature, it is necessary to keep it for at least three hours at room temperature.

  • Unpack the coffee maker and remove all the packaging materials.
  • Keep the original package.
  • Read the safety measures and operating recommendations.
  • Check the delivery set.
  • Examine the coffee maker for damages, in case of damage do not plug it into the mains.
  • Make sure that the specifications of power supply voltage are specified on the lower panel of the unit to correspond to the specifications of your mains. When the unit is used in the mains with a 60 Hz frequency, it does not need any additional settings.
  • Wipe the outer surface of the unit body (1) with a clean, slightly damp cloth to remove dust.
  • Place the body (1) on a solid steady flat and non-slip non-metal surface away from heat sources as far as possible from the edge of the surface.
  • Do not place and do not use the coffee maker in closed space, for example, in the cupboard or in closed structures — this can lead to its breakage, cause harm to the user, or damage to his/her property.
  • Grasp the handle (5), slightly lift and remove the flask (2) from the coffee maker body (1).
  • Wash the inner surface of the flask (2) using neutral detergents, rinse, and dry, do not let the detergent come into contact with the flask contact group (2).
  • Wipe the outer surface of the unit body (1) with a slightly damp cloth and then wipe it dry. Do not use abrasives or coarse scourers for this.
  • Before connecting the coffee maker, make sure that there are no moisture drops on the unit body (1), the power cord, and the power plug.
  • Fill the flask with water up to the maximal level mark.
  • Set the coffee maker filled with water.
  • Insert the power plug into the main socket.
  • Set the power switch and press the « » button (3), you will hear a sound signal and the backlight of the « » button (3) will turn red.

ATTENTION!
To avoid burns from hot steam, do not bend over the coffee maker.

  • When water starts boiling, you will hear sound signals, the coffee maker will turn off, and the backlight of the « ****» button (3) will turn white. Pour out the water and repeat the water boiling procedure several times.
  • Hot water resulting from the first boilings is not recommended to consume, you may use it for domestic needs.
  • The coffee maker is ready for usage.

USING THE COFFEE MAKER

ATTENTION!

– To avoid damage to the coffee maker does not switch it in without water.
– To avoid scaling use filtered water.
– Depending on your taste you can add the necessary amount of ground coffee, sugar, and spices to the coffee maker.

  • Place the coffee maker body (1) on a solid and steady flat surface away from heat sources as far as possible from the edge of the surface.
  • Make sure that the « » button (3) is always easily accessible and is not blocked by foreign objects.
  • Grasp the handle (5), slightly lift and remove the flask (2).
  • Fill the flask (2) with water, do not exceed the maximum level mark, pour the required amount of ground coffee, sugar, and spices into the coffee maker and stir the ingredients (see the table).

Notes: use ground coffee intended for brewing in the coffee maker.
Approximate amount of ingredients for 1 cup of coffee

| Water (100 ml)| Ground coffee| Sugar
---|---|---|---
Black coffee| 1 cup of coffee| 1 measuring spoon| Without sugar
Slightly sweet coffee| 1 cup of coffee| 1 measuring spoon| Half a sugar cube, half a teaspoon of
powdered sugar
Coffee with a little sugar| 1 cup of coffee| 1 measuring spoon| 1 sugar cube, 1 teaspoon of powdered sugar
Sweet coffee| 1 cup of coffee| 1 measuring spoon| 2 sugar cubes, 2 teaspoons of powdered sugar

  • Insert the power plug into the main socket.
  • Place the flask (2) filled with water in the coffee maker body (1).
  • To turn the coffee maker on press the « » button (3), you will hear a sound signal and the backlight of the « » button (3) will turn red.

Note: the preparation time for the first coffee portion depends on the volume of water in the flask (2) and the temperature of the flask (2); when preparing the next coffee portion, the preparation time may be slightly shorter since the flask (2) will be warmer.

ATTENTION!
– Coffee is a drink prone to quick boiling. Do not leave the coffee maker unattended during making coffee, especially when the coffee starts boiling.
– If the ready drink is splashing out, immediately unplug the coffee maker to avoid getting burnt.
– If you don’t use the coffee maker, unplug it.

  • When the coffee starts rising and boiling, you will hear sound signals, the coffee maker will turn off, and the backlight of the « ****» button (3) will turn white.
  • Remove the power plug from the main socket.
  • Note: – after each portion of coffee it is recommended to wipe the temperature sensor (4) with a slightly damp cloth.

CLEANING AND MAINTENANCE

  • Before cleaning unplugs the coffee maker, pour out the water, and let the coffee maker cool down.
  • Grasp the handle (5), slightly lift and remove the flask (2) from the coffee maker body (1).
  • Wash the inner surface of the flask (2) using neutral detergents, rinse, and dry, do not let the detergent come into contact with the flask contact group (2).
  • Wipe the temperature sensor (4) with a slightly damp cloth.
  • Wipe the outer surface of the unit body (1) with a slightly damp cloth and then wipe the unit body (1) dry.
  • Use soft detergents to remove dirt; do not use metal sponges, abrasive detergents, and solvents.
  • Do not immerse the coffee maker (1), the flask (2), and the power cord into water or any other liquids, do not wash the unit in the dishwasher.
  • Do not allow water to get on the contact block of the.

DESCALING

  • During the use of the unit some stains, scale, etc. can appear on the heating element, it is not a problem, but a result of water quality.
  • Scale, appearing inside the unit body (1), influences the water taste and disturbs the heat exchange between water and the heating element. It also risks damaging the heating element. Burning of the heating element caused by a large amount of scale in the flask (2) is not covered by warranty.
  • To remove scale, you can use special scale-removing agents, as well as household ones, for example, vinegar or citric acid.
  • To remove the scale, fill the flask (2) with water one-third full and boil it. Add vinegar (6-9%) up to the maximal mark and leave the liquid in the flask (2) for several hours. After the scale dissolves, pour out the liquid and rinse the flask (2) several times. To oust the smell of vinegar, boil water several times.
  • Dissolve 25 g of citric acid in 500 ml of hot water.
  • Fill the flask (2) with the prepared solution and leave for 15-20 minutes.
  • After the scale has dissolved, pour out the liquid and rinse the flask (2) several times, after that boil water several times.
  • You can use special detergents for electric kettles or coffee machines to remove scale, strictly following the instructions on their usage.
  • Clean the coffee maker from scale regularly.

STORAGE

  • Before taking the coffee maker away for long storage, unplug it, pour out the water and let the unit cool down.
  • Clean the flask (2), wash the coffee maker and the lid (2), and dry them.
  • Pack the coffee maker in the original package.
  • Keep the coffee maker in a dry cool place out of reach of children and disabled persons.

DELIVERY SET

  1. Coffee maker — 1 pc.
  2. Manual — 1 pc.

TECHNICAL SPECIFICATIONS

  • Supply voltage: 220-240 V, ~ 50-60 Hz
  • Rated input power: 500 W
  • Maximum water capacity: 0.5 l

RECYCLING

To prevent possible damage to the environment or harm to the health of people by uncontrolled waste disposal, after service life expiration of the unit or the batteries (if
included), do not discard them with usual household waste, deliver the unit and the batteries to specialized centers for further recycling. The waste generated during the disposal of the unit is subject to mandatory collection and consequent disposal in the prescribed manner.
For further information about recycling this product applies to a local municipal administration, a disposal service, or to the shop where you purchased this product.
The manufacturer reserves the right to change the appearance, design, and specifications not affecting the general operating principles of the unit, without prior notice.
The unit operating life is 3 years
The manufacturing date is specified in the serial number.
In case of any malfunctions promptly apply to the authorized service center.

Hergestellt für «Ruste GmbH»,
Berggasse 18/18, 1090 Wien,
Osterreich
Produced for «Ruste GmbH»,
Berggasse 18/18, 1090 Vienna, Austria
Изготовлено по заказу Русте Гмбх,
Бергассе 18/18, 1090 Вена, Австрия
Уполномоченное изготовителем
лицо: ООО «Грантэл»
143912, МО, г. Балашиха,
ш. Энтузиастов, вл. 1А
т.: +7 (495) 297-50-20,
e-mail: [email protected]
Made in China/Произведено в Китае

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

BRAYER User Manuals

Related Manuals