MIGHTY BRIGHT REV200 LED Task Light & Magnifier User Guide

: June 17, 2024
: MIGHTY BRIGHT

Table of Contents

ATTENTION:
ASSEMBLY STEPS
OPERATION
Documents / Resources

MIGHTY BRIGHT REV200 LED Task Light & Magnifier LED Task Light & Magnifier
Assembly Instructions & User Guide

ATTENTION:

Please review all the instructions and diagrams carefully before assembling the lamp. This will reduce assembly time and avoid damage.
Do not force parts. Do not apply excessive force to wires during assembly.
Remove all the packing materials before use.

WARNING:

Do not look directly into the LED’s and do not shine them into the eyes of others. As with other high intensity light sources, eye damage may occur.
To avoid the risk of damage or fi re, do not leave the magnifi er in direct sunlight or allow sunlight to pass through the lens.
Do not look through the lens directly at the sun or other bright lights, as eye damage may occur.

ASSEMBLY STEPS

Remove the recyclable paper tray from the recyclable carton. Carefully remove the flexible arm with the magnifying Lamp from the tray. Gently lay them on a large, clean work surface.
Open the clip and insert into the notch in the weighted base. The light can be used with or without the base by clipping onto any suitable, stable surface.
Plug in the supplied AC adapter to the DC jack on the back of the clip. The lamp is now ready for use.

AC/DC Adapter specs:

Input : 100-240VAC, 50 – 60 HZ
Output : 12V DC 500mA
The AC/DC jack is located on the back of the lamp base.

OPERATION

The power switch is located on the top of the lamp head next to the magnifying lens. Press it once to turn on the light. Press again to cycle through the other brightness levels (High, Med, Low, Off). If the light fails to operate after turning the switch on, check that the AC power supply is fully plugged in.
The color temperature selector is also located on the top of the lamp head. The touch-activated selector continuously cycles between cool (5,000K) and warm (3,000K) color temperatures. Press and hold the sensor to select the ideal color temperature for your needs.
The flexible arm is intended as a convenient means of adjusting the lamp. Properly handled it will provide a lifetime of service. Do not abuse the flexible arm by bending it severely, abruptly, or forcefully.
Do not attempt to remove or replace the LED’s.
Magnification: 5” diameter lens is 2X power with a 5X spot lens.
Care: Clean the lens with a lint-free soft cloth or with a non-abrasive lens cloth. Never use a chemical cleanser.

Visit us at:www.mightybright.com
REV200

Documents / Resources

| MIGHTY BRIGHT REV200 LED Task Light & Magnifier [pdf] User Guide
REV200 LED Task Light Magnifier, REV200, LED Task Light Magnifier, Task Light Magnifier, Light Magnifier, Magnifier
---|---