KUZOR Bathroom Faucets Matte Black Instruction Manual
- June 17, 2024
- KUZOR
Table of Contents
KUZOR Bathroom Faucets Matte Black
Specifications
| Dimension | Measurement |
|---|---|
| Height | 6-5/16″ (160mm) |
| Spout Reach | 4-5/16″ (110mm) |
| Spout Height | 4-1/8″ (105mm) |
| Handle Width | 2-1/16″ (52mm) |
You May Need
- Adjustable wrench
- Phillips screwdriver
- Flat screwdriver
- Plumber’s tape
- Utility knife
- Flashlight
- Allen wrench
Troubleshooting
| Problem | Cause | Action |
|---|---|---|
| Leaks underneath the handle. | The cartridge has come loose. | Tighten the |
cartridge.
The aerator leaks or has an inconsistent water flow pattern.| An aerator is
dirty or worn out or misfitted.| Unscrew the aerator to clean or replace
washer, or replace the aerator.
The water will not shut off completely.| Dirty or worn-out washer in
cartridge.| Remove handle and cartridge to check if the washer is damaged
permanently or dirty. Re-install cartridge.
Installation Procedures
- Clean all the dirts from valve outlets. Turn off the water supply valves. Remove the faucet from the sink and clean the sink surface thoroughly.
- If necessary, you can install it with a deck plate. Place deck plate over the three holes of sink.
- Remove the rubber washer, metal washer and mounting nut that are pre-installed on the bottom of the faucet. Then pass the hoses through the mounting hole of the sink.
- Position the faucet on the sink properly. From the underside sink, fit the rubber washer and metal washer then tighten the mounting nut.
- Connect hot and cold water supply lines to the water supply valves. After installation, tighten the nut to fix the faucet.
- Unscrew the locking nut. Make sure the rubber washer is aligned with the sink drain hole. Then insert the pop-up drain into the sink drain hole. From underneath, tighten with the lockset.
- After the installation is complete, press down to check whether it can be used normally.
- Lift the handle up, the cartridge will be activated allowing water to flow. The water flow will increase by continuing to rotate handle. By rotating the handle to the right, the water temperature will decrease to cold flow only. By rotating the handle to the left, the water temperature will increase to hot flow only.
- After installation is complete, rotate handle to the closed position. Turn on the water supply valves, and check all connections for a leak. Turn on your faucet and allow both hot and cold water to run at least one minute each.
Notification
Long-term use of the water outlet will form scale, wipe it with a soft towel. Prohibit the use of hard objects cleaning products.
FAQ
- What should I do if the faucet leaks underneath the handle?
- You should tighten the cartridge to resolve this issue.
- How can I fix an aerator that leaks or has an inconsistent water flow?
- The aerator may need to be cleaned or replaced, along with the washer if it’s dirty or worn out.
- What action should I take if the water doesn’t shut off completely?
- Remove the handle and cartridge to check for a damaged washer, clean or replace as necessary, and then re-install the cartridge.
- How do I start up the faucet after installation?
- Rotate the handle to the closed position, turn on the water supply valves, check for leaks, and allow water to run for at least one minute for both hot and cold settings.
Read User Manual Online (PDF format)
Loading......