BLITZSHARK SRK-A01 Ride on ATV Super Fast Electric Vehicle User Guide

June 10, 2024
BLITZSHARK

BLITZSHARK SRK-A01 Ride on ATV Super Fast Electric Vehicle

INTRODUCTION

Note Icon

  • Please in stall this ride-on car according n to this instruction.
  • The installation video on the Blitzshark product front page of your purchase channel(e.g. Amazon) will also be very helpful. We strongly recommend you to watch and follow it.
  • Please do not tear off the protective plastic films outside the shock absorbers to avoid pinching the child’s hands.
  • Please pay attention to the use of tools to avoid scratching the seat surface.

Charge for 4-6 hrs before initial use.

After initial charge, follow the normal recommended charging time.

SAFETY

NOTE

| For best performance, we recommend using this vehicle on flat and hard surfaces
---|---

AGE RANGE

| 3 to 8 years old (We recommend the high-speed mode for 5+ years old only)

WEIGHT CAPACITY

| 80LBS(36.4KG) is the maximum weight for 1 rider

MUST READ BEFORE USE


  • Before switching into the Lighting-mode, we strongly recommend you make sure your kid is
    proficient in driving skills under low & middle speed. This includes, but is not limited to: starting and
    braking, slowing down to turn, avoiding obstacles, avoiding steep slopes, etc.

  • Always make sure that your kid does not use this toy in any place where an actual vehicle may be
    present.

  • Always put on the protective gear(included).

Warning Icon

  • Never open the battery. Batteries contain lead and lead compounds(acids).

  • Limbs, hair and clothing can get caught in moving parts. Always wear shoes, keep limbs away from moving parts and do not wear loose clothing while operating this vhicle.

  • This vehicle does not have separate braking system. Do not leave a child unattended during operation. Do not use it in a location that may require emergency stop function as this could result in loss of control, which may cause serious injury or death.

  • Use of this vehicle near streets, motor vehicles, steps, bodies of water, sloped surfaces, hills, wet areas, flammable vapors, in alleys, at night or in the dark could result in an unexpected accident.

  • Use of this vehicle in unsafe conditions such as snow, rain, loose dirt, mud, sand or gravel may result in an unexpected accident such as tipping over and could damage the electrical system or battery.

  • Do not operate this vehicle in an unsafe manner. Examples include but are not limited to:

    • Pulling the vehicle with another vehicle or similar device

    • Allowing more than one children to ride

    • Pushing the user

    • Traveling at an unsafe speed

Warning Icon

  • Use of a battery or charger other than the supplied rechargeable battery and charger may cause a fire or explosion. Only use the supplied battery and charger.
  • Use of the rechargeable battery and charger for any other product may result in overheating, fire or explosion.
  • Never use the supplied rechargeable battery and charger with another product.
  • Explosive gases are created during charging. Charge the battery in a well ventilated area. Do not charge the battery near heat or flammable materials.
  • Contact between the positive and negative terminals may result in fire or explosion. Avoid direct contact between the terminals. Picking up the battery by the wires or charger can cause damage to the battery and may result in a fire. Always pick up the battery by its case or handles.
  • Liquids on the battery may cause fire or electric shock. Always keep all liquids away from the battery and keep the battery dry. Contact or exposure to battery leakage (lead acid) may cause serious injury. If contact or exposure occurs immediately call your physician. If the chemical is on the skin or in the eyes, flush with cool water for 15 minutes. If the chemical was swallowed, immediately give the person water or milk. Do not give water or milk if the patient is vomiting or has a decreased level of alertness. Do not induce vomiting.
  • Battery posts, terminals and related accessories contain lead and lead compounds(acid).
  • Tampering or modifying the electric circuit system may cause a shock, fire or explosion and permanently damage the system. Exposed wiring and circuitry in the charger may cause electric shock. Always keep the charger housing closed.

Warning Icon

  • Never leave a child unattended.
  • Always sit in the seat when using this vehicle.
  • Keep your hands, hair and clothes away from moving part.
  • Always wear shoes when operating this vehicle. Children under 3 years of age cannot use the vehicle.
  • Only drive on level ground.
  • Do not go near swimming pools or other bodies of water, drop-offs or up and down steep inclines.
  • Do not drive the vehicle into loose dirt, mud, sand, fine gravel or on wet surfaces.
  •  Do not drive the vehicle on streets or near cars.
Item SRK-A01
Batteries 24V 10AH
Motor 24V #550
Age 3-8 years
Max Weight 80LBS(36.4KG}
Dimension 42.527.629.1lNCH( 1087074CM)
Speed 1.8-5MPH (3-8KM/H}
Play Time 1-2.5 hours/ recharger time 8-12 hours
Charger Output DC 24V

TOOLS REQUIRED

|
---|---

2 PERSON ASSEMBLAY

|

APPROXIMATELY 45 ,IN ASSEMBLAY

  • SCREWDRIVER (BRING YOUR OWN)

  • SCISSORS (BRING YOUR OWN)

  • MS WRENCH (PROVIDED)

  • Ml0 WRENCH (PROVIDED)

  • M4*12MM

  • <P 12 GASKET

  • Ml0 NUTS

  • COTTER PIN

  • M6*12MM SCREW

  • <P 8 GASKET

  • SCREW

  • FRONT WHEELS

  • REAR WHEELS

  • WEAR WHEELS

  • STEERING WHEEL

  • FRONT PANEL

  • REAR PANEL

  • EXHAUST PIPE L/P

  • CHARGERS

  • STEERING ROD

PRODUCT ASSEMBLY



Turn the torsion bar so that the hole of the torsion bar is aligned with the hole of the front drive part, and then insert the screw. Place the 8 gasket on the screw and insert the cotter pin into the screw hole for fixing. (install the other side in the same way)

Rotate the front drive component and insert the steering rod into the iron hole of the front drive component. Then insert the cotter pin into the steering rod hole for fixation.

SMALL WHEEL

Place the front wheel, cpl2 gasket and nut on the font axle in tum.
Fix the nut with the MlO wrench and then attach the wheel hubs to the wheel.

Fix the exhaust pipe (LP)to the body of the car.
Place the rear wheel, cpl2 gasket and nut on the rear axle in turn.
Fix the nut with the MlO wrench and then attach the wheel hubs to the wheel.

Insert the front panel into the car and fix it with M4*12mm screw.

Insert the rear panel into the car and fix it with M4*12mm screw .

Install the steering wheel into the steering rod and fix it with M6*12mm screw.

Please make sure the screw is tightened

Open the seat and connect the battery wires

Find the main power cord plug of the battery and insert into the corresponding socket of the receiver.

DASHBOARD DIAGRAM

Dashboard Diagram

  1. Pedal: Press, the vehicle will move when the power is on; release on the move, the motors will generate resistance to stop the vehicle.
  2. Power Button: Long press 3 seconds, turn the vehicle on and off. Long press 1 second, the music stop, press again, music on.
  3. Power display: Clearly see the battery power, in order to charger in time.
  4. Forward button: Press it, go forward.
  5. Backward button: Press it, go backward.
  6. Speed button: Press it, choice medium speed or low speed.
  7. Wireless Technology(YX): Press the (J) button to enter, and you can hear the “Du” sound. Then select the device named “YX” on your mobile phone. The device prompts “connected,” which means the pairing is successful. After connected, the car can play music from your mobile phone.
  8. FM: Press it to enter the FM mode, and then press and hold this button for three seconds, the product will automatically search for radio stations. After searching for about one minute, you can manually switch stations by clicking buttons 11 and 12.
  9. Music Button: Play music
  10. Quick button: Press and hold for three seconds to enter the high-speed mode.
  11. Next song: Switch songs, and long press will increase volume.
  12. Last song: Switch songs, and long press will decrease volume.
  13. U
  14. Socket: Charge
  15. MP3

CHARGING INSTRUCTIONS

Charging Instructions

  1. lnsert the charger jack into the charging hole of the car.
  2. Plug the charger plug into the stable matching AC power supply as shown in the picture.
    • Charge the battery 4 to 6 hours before initial use.
    • On average, you will need to charge the battery between 8 and 12 hours. Do not charge the battery for more than 20 hours. Failure to charge the battery as directed could cause permanent damage to the battery and void the warranty.
    • Damage to the battery may occur if it is allowed to drain completely. Do not allow thebattery to drain completely.
    • Check the battery and charger (supply cord, connector) for wear and damage before charging. Do not charge the battery if damage has occurred.
    • Only an adult who has read and understood the safety warnings should handle, charge and recharge the battery.

MAINTENANCE

The vehicle should be checked for damage, missing or badly worn parts before use.

  • Check the tightness of the fasteners before each use.
  • Check the tightness of the wheels.
  • Ensure the battery is securely in place before use.
  • Occasionally use lightweight oil to lubricate moving parts such as wheels and steering linkage.
  • Do not use oil on plastic or nylon parts. No lubrication is required.
  • Store the vehicle indoors or cover it with a tarp to protect it from the wet weather. Keep it away from sources of heat, such as stoves and heaters.
  • Clean the vehicle with a soft, dry cloth. To restore shine to plastic parts, use a non-wax furniture polish. Do not use car wax, abrasive cleaners or wash the vehicle with soap and water. Water will damage the motor, electrical system and battery.
  • Joywhale recommend you ask professional advice from our technical team if you need maintenance or repair service. Official email address of Joywhale: [email protected]

TROUBLESHOOTING

problem                                                             possible cause|

Remedy

---|---
Vehicle does not run                                             Battery low on power| Recharge battery (see Battery : Recharge Interval and Time)
| Thermal fuse has tripped| Let the vehicle rest for 5 to 10 minutes before continuing normal operation.
Battery connector or wires are loose| Check that the battery connectors are firmly plugged into each other. If wires are loose around the motor, please contact customer service department by email: [email protected]
Battery is dead| Replace battery (Please contact customer service department by email: [email protected]for further help)
Electrical system is damaged| Please contact customer service department by email: [email protected]
Motor is damaged| Please contact customer service department by email: [email protected]
Vehicle does not run very long| Battery is under charged| Check that the battery connectors are firmly plugged into each other when recharging
Loud grinding or clicking noises coming from motor or gear box| Motor or gears are damaged| Please contact customer service department by email: [email protected]
Problem| Possible C|
---|---|---
Vehicle runs sluggishly or beeping occurs| Battery low on power| Recharge battery
Battery is old| Replace battery (Please contact customer service department by email: [email protected]for further help)
Vehicle is overloaded| Reduce weight on vehicle (see User Requirements and Safety Warnings)
Vehicle is being used in harsh conditions| Operate the vehicle level ground and firm surfaces (see User Requirements and Safety Warnings)
Vehicle needs a push to go forward| Poor contact of wires or connectors| Check that battery connectors are firmly plugged into each other. If wires are loose around the motor, please contact customer service department by email: [email protected]
“Dead Spot” on motor| A dead spot means the electric power is not being delivered to the terminal connection and the vehicle needs repair. Please contact customer service department by email: [email protected]
24V Battery will not recharge| Battery connector or adapter connector is loose| Check that battery connectors are firmly plugged into each other
Charger not plugged in| Check that battery charger is plugged into a working wall outlet
Charger is not working (lights not glowing)| Please contact customer service department by email: [email protected]
Battery bubbles or gurgles when charging| This is normal and not a cause for concern|
Charger feels warm when recharging| This is normal and not a cause for concern|

CARI NG FOR YOUR RI DE-ON

  • Park the vehicle indoors or cover it with a tarp to protect it from wet weather .
  • Do not leave the vehicle in the sun for long periods of time or fading may occur. Store in shade or cover with tarp .
  • Do not wash the vehicle with a hose .
  • Do not wash the vehicle with soap .
  • Charge battery at least once a month to prolong the life of the battery.

CARING FOR YOUR RIDE-ON

If you have any questions about the steps of installing the product or if there are any problems with the product in use, please feel free to contact the customer service of your purchase platform by email.

Warning Icon
The battery on the vehicle is not replaceable.

  • Do not mix old and new batteries.
  • Do not mix alkaline, standard(carbon-zinc) or rechargeable batteries.
  • Non-rechargeable batteries should not be charged.
  • Rechargeable batteries should be charged under adult supervision only.
  • Exhausted batteries should be removed.
  • The supply terminals should not be short-circuital
  • Do not put batteries next to or in a heat source(fire, electronic heating device, etc.).
  • Do not hit batteries against hard objects.
  • Do not submerge batteries in water.
  • Batteries should be inserted with the correct polarity.

IMPORTANT

  • Always charge battery for 4-6hrs the first time you useit.
  • Always charge battery for 8-12hrs after each use.
  • Charge the battery once a month, even if you are not using your vehicle.

Warning Icon

  • Protective equipment should be worn. Not to be used in traffic.
  • The toy should be used with caution since skill is required to avoid falls or collisions causing injury to the user or third parties.
  • To reduce the risk of injury, adult supervision is required. Never use in roadways, near motor vehicles, on or near steep inclines or steps, swimming pools or other bodies of water; always wear shoes, and never allow more than one rider.

Warning Icon
ADULT ASSEMBLY REQUIRED

Warning Icon
Not to be used in traffic

Warning Icon
CHOKING HAZARD-Small parts.
Not for children under 3yrs.
To reduce the risk of injury, adult supervision is required. Never use in roadways. Never motor vehicles, on or near steep inclines or steps, swimming poors or other bodies of water; always wear shoes, and never allow more than one rider.

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

BLITZSHARK User Manuals

Related Manuals