KUZOR ‎ZV-RZ6O-UF63 Single Hole Bathroom Faucets Brushed Nickel Instruction Manual

: June 17, 2024
: KUZOR

Table of Contents

KUZOR ‎ZV-RZ6O-UF63 Single Hole Bathroom Faucets Brushed Nickel
YOU MAY NEED
DIMENSION DRAWINGS
TROUBLESHOOTING
INSTALLATION PROCEDURES
Faucet Start Up
Read User Manual Online (PDF format)
Download This Manual (PDF format)

KUZOR ‎ZV-RZ6O-UF63 Single Hole Bathroom Faucets Brushed Nickel

YOU MAY NEED

$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel- FIG-$2$$

DIMENSION DRAWINGS

$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel- FIG-$1$$

TROUBLESHOOTING

If you’ve followed the instructions carefully and your faucet still does not work properly, take these corrective steps.

$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel- FIG-$3$$

INSTALLATION PROCEDURES

$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel- FIG-$4$$

You should clean all the dirts from valve outlets. Turning off the water supply valves. This is usually found near the water meter. If you are replacing an existing faucet, remove the faucet from the sink and clean the sink surface thoroughly.
If necessary, you can install it with a deck plate. And place the deck plate over the three holes of the sink.
$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel-FIG-$5$$ Remove the hex nut on the screw and insert the screw to the bottom of the faucet. Pass the hoses and screw through the mounting hole in the sink.
From underside sink, place rubber washer and then metal washer. Then tighten the hex nut with a black plastic wrench.
Connect hot and cold water supply lines to the water supply valves. After installation, tighten the nut to fix the faucet.
$KUZOR-ZV-RZ6O-UF63-Single-Hole-Bathroom-Faucet-Brushed-Nickel-FIG-$7$$ A. Unscrew the locking nut. Make sure the rubber washer is aligned with the sink drain hole. Then insert the pop-up drain into the sink drain hole. From underneath, tighten with the lockset.
B. After the installation is complete, press down to check whether it can be used normally.
Lift the handle up, the cartridge will be activated allowing water to flow. The water flow will increase by continuing to rotate handle. By rotating the handle to the right, the water temperature will decrease to cold flow only. By rotating the handle to the left, the water temperature will increase to hot flow only.

Faucet Start Up

After installation is complete, rotate handle to the closed position. Turn on the water supply valves, and check all connections for a leak. Turn on your faucet and allow both hot and cold water to run at least one minute each.