SYEYESCITY Filter Shower Head and Hose Set Instructions

June 17, 2024
SYEYESCITY

SYEYESCITY Filter Shower Head and Hose

SYEYESCITY Filter Shower Head and Hose Set
Instructions

Filter Shower Head Fitting Instructions

GENERAL

  • Please read all of the instructions before installation.
  • Unpack and inspect the box, if you find any shipping or packaging damages, please do not install.
  • If you need assistance while installing your new shower head, please send us a message or email.
  • Please shut off the water supply lines where the new shower head is being installed.
  • It is the responsibility of the installer to ensure a waterproof seal is achieved.
  • After installation, all connections must be checked for leaks.
  • Please note that some showers may not provide an effective shower when used with gravity-fed heated water systems or where pressures are less than 1 .5 bar at the outlet. Additionally, showers with flow rates of less than 1 0Umin may not allow the following to function correctly.
  • Please keep these instructions for future reference.

OUR PROMISE

  • 24/7 Customer Service
  • Same-day Response
  • 30-days Money Back Guarantee
  • 1-year Manufacturer’s Warranty
  • 100% Customer Satisfaction
    Our only ask is if you are experiencing any issues with your order, please communicate it to us immediately and let our customer care team do their job and resolve the issue for you.

TOOLS & MATERIALS

Hand tight all joints

Tools & Materials

Rubber washer X4

Tools & Materials

Plumber’s tape X 1

Tools & Materials

INSTALLATION DIAGRAM

This showerhead is designed to be fitted to shower hose with a female 1/.2″ BSP thread.
Please take the plumber’s tape and wrap it onto the shower thread. Hold firmly and pull away to snap the tape cleanly, 2 or 3 wraps against the thread should do the trick.
Please place a rubber washer between each connection and make sure it is sitting flush. Hand tightens clockwise until a firm fit is attained. Caution! Do not over-tighten.
Please check joint and connections for any leaks, if this occurs check the condition of the washer. Replace if necessary or reseat correctly then re- tighten.
The showerhead comes with a swivel joint providing flexible positioning of water stream. Please unscrew the swivel ball connector a little bit, rotate to find the right angle you desired.

INSTALLATION DIAGRAM

AFTERCARE INSTRUCTIONS

Over time, lime and calcium can build up on the showerhead, blocking the shower nozzles and distorting the shower spray. The spray plate must be regularly cleaned to make sure that the showerhead does not become blocked. Please use your thumb or a soft cloth to wipe any limescale from the front face of the spray plate assembly.
Many household cleaners contain abrasives and chemical substances, and should not be used for cleaning plated or plastic fittings. The safest way to clean your shower head is to wipe it with a soft damp cloth.
Stains can be cleaned with a mild washing-up detergent or soap solution and then wiped dry using a soft cloth.
All bath cleaning powders and liquids will damage the surface of your fitting. Never use abrasive detergents or disinfectants or those containing alcohol, hydrochloric acid, or phosphoric acid.
NOTE: All surface finishes will wear if not cleaned correctly.

ONE MORE TIP

Please know this shower head is heavy because of the built-in shower filter. Like any shower head too much weight will cause the holder to rotate and the head to drop. You might need a holder that screws down so it’s firmly held. To overcome this all you need to do is tighten the screw that holds the rotating holder.

Customer Service: 527466563@qq.com

Logo

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals