LAPP 44423228 MHB Coax Instruction Manual
- June 17, 2024
- LAPP
Table of Contents
LAPP 44423228 MHB Coax
Product Information
Specifications
- Material Description: H-D SCEM AG 0.14-0.37
- Contact Type: Female
- Number of Working Contacts: 4 + Shielding
- Recommended Ethernet Configuration: 10BASE-T, 100BASE-TX Rx + Rx Tx Tx +
Product Usage Instructions
Prepare Cable End
- Strip the cable to approximately 20mm.
- Fold back the shielding braid and secure it with a heat shrink tube.
Crimp Contacts
Crimp the contacts by inserting them into the contact carrier until they
snap in.
Pin Arrangement
Observe the pin arrangement for proper connection:
| Contact | 1 | 2 | 3 | 4 |
|---|---|---|---|---|
| 10BASE-T | white | green | orange | white / orange |
Coding
Tighten the 8 PE screws with 1.2 Nm torque.
Disassembling Contacts
- To disassemble contacts, use the extraction tool from the backside of the insulation body in the contact chamber.
- Push back the contact lock and pull out the contact from the chamber.
Frequently Asked Questions (FAQ)
Q: How do I disassemble the contacts?
A: To disassemble the contacts, use the extraction tool provided. Slide it
from the back side of the insulation body in the contact chamber. Pay
attention to the correct alignment.
Q: What is the recommended Ethernet configuration for this product?
A: The recommended Ethernet configuration is 10BASE-T, 100BASE-TX Rx + Rx
Tx Tx + with specific color coding for each contact.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>