MATCH UP-8DSP Audiotec Fischer Instruction Manual
- June 17, 2024
- MATCH
Table of Contents
MATCH UP-8DSP Audiotec Fischer
Product Specifications:
- Model: UP 8DSP Amplifier
- Compatibility: PP-BMW 1.7 HIFI – UP 8DSP Edition wiring harness
- Fuse Requirement: 25 A
- Website for Sound Setup Database: www.audiotec-fischer.com
Product Usage Instructions
Installation Notes:
- Set the Auto Remote switch to Off.
- Remove the side panel with the System Connector input by loosening the two Phillips screws and then pull the bottom plate to the side.
- Remove the two marked fuses by simply pulling them upward.
- Insert one of the previously removed 25 A fuses into the Fuse-Power via the System-Connector slot.
- Reassemble the amplifier.
- Attach the mounting plate to the amplifier. Fix the mounting panel with the counter-sunk screws to the bottom plate of the amplifier.
- Install a basic sound setup onto the DSP following instructions in the Sound Setup database at www.audiotec-fischer.com under Tools Sound Setups UP 8DSP with PP-BMW 1.7HiFi UP 8DSP Edition.
Frequently Asked Questions (FAQ):
-
Q: Can I use a different wiring harness with the UP 8DSP amplifier?
A: It is recommended to use the PP-BMW 1.7 HIFI – UP 8DSP Edition wiring harness for proper functionality and to prevent damage to the amplifier or vehicle. -
Q: Where can I find more information about installing a Sound Setup on the amplifier?
A: Information about installing a Sound Setup can be found in the UP 8DSP user manual or on the website www.audiotec-fischer.com under Tools Sound Setups.
INSTALLATION
When installing the UP 8DSP amplifier in combination with the PP-BMW 1.7 HIFI – UP 8DSP Edition wiring harness, it is necessary to make hardware configurations on the amplifier. This is essential to prevent damage to the amplifier or the vehicle.
Please follow these steps:
-
Set the “Auto Remote” switch to “Off”.
-
Reposition the fuses inside the amplifier.
Remove the side panel with the “System Connector” input by loosening the two Phillips screws and then pull the bottom plate to the side.
Remove the two marked fuses by simply pulling them upward
Then, insert one of the previously removed 25 A fuses into the “Fuse – Power via System-Connector” slot. -
Reassemble the amplifier.
-
Attach the mounting plate to the amplifier.
Fix the mounting panel with the counter-sunk screws (both included in delivery) to the bottom plate of the amplifier. -
Install a basic sound setup onto the DSP.
You can find this in the Sound Setup database at www.audiotec- fischer.com under Tools → Sound Setups → UP 8DSP with PP-BMW 1.7HiFi UP 8DSP Edition.
Information about the installation of a Sound Setup on the amplifier can be found in the UP 8DSP user manual.
Hünegräben 26 · 57392 Schmallenberg · Germany
Tel.: 02972 97880
Web: www.audiotec-fischer.com
References
- High-End Car Hifi & Audio - Made in Germany | Audiotec Fischer
- High-End Car Hifi & Audio - Made in Germany | Audiotec Fischer