LOKBY LB-SH-HH-1.1 6 Setting Hand Held Showerhead Instruction Manual

: June 17, 2024
: LOKBY

Table of Contents

DIMENSION
prior to installation
installation
care & cleaning
TROUBLESHOOTING GUIDE
CUSTOMER SUPPORT
Read User Manual Online (PDF format)
Download This Manual (PDF format)

LOKBY LB-SH-HH-1.1 6 Setting Hand Held Showerhead

DIMENSION

Dimension

Thank you for purchasing the Lokby 6-setting hand held shower head. This manual gives you the information you need for a quick and easy installation. You are minutes away f rom enjoying a luxurious shower experience.

prior to installation

prior to installation unscrew the old shower head and remove all pipe tape as well.
ensure that the gasket from the old shower is not inside the shower pipe. Use a thin utensil to check inside the shower pipe for gaskets, such as a pencil or screwdriver. Do not check with your fingers.
you shouldn’t need any tools to unscrew the old shower head, but if the connection is too tight to turn by hand, try to use a crescent wrench to get a better grip

installation

Insert a rubber washer with a mesh screen into the ball connector. Screw the shower head bracket into the J-pipe Hand-tighten clockwise to a snug fit. **Do not overtighten.

**

Insert a rubber washer into the conical nut of the hose and push it down flat. Connect it to the bracket, then hand-tighten.
Insert a rubber washer into the other end of the hose and push it down flat. Connect the conic1al nut to the handheld showerhead, then hand-tighten.
Place a handheld shower in the bracket holder. Rotate the bracket forward or back to adjust the spray angle. Turn on the water to t 1est for leaks. If you notice any leakage, it is necessary to slightly tighten the connection.
If leakage does not stop by retightening the connections, use the Teflon tape to create a watertight seal. Wrap the threads in 2-3 passes of Teflon tape from the box. Remember to apply the t!3pe in a clockwise d1rect1on to avoid unwrapping it. Press the shower head tape firmly into the threads with your fingers with each wrap-around so that you can start to see them through the tape. Follow Step 2 under installation to reinstall the shower head.

how to use Spray selector:
spray selector allows you to select from various spray patterns.

warnings

To avoid hot water dangers and conserve even more energy, make sure your water heater ;5 set at 48.9 °C (120 °F) or below.
Test the tub or shower with your hand before bathing,
Do not pull on or tug on the flexible hose. This may result ;n the shower head coming loose and falling
For external use only. The potentially deadly amoeba, Naegleria Fowleri, may be present in some tap water or unchlorinated water.

care & cleaning

To maintain proper working conditions, cleaning Is required when mineral deposits appear on the spray orifices.

To remove mineral deposits. gently rub the noz-les on the face of the shower head to dislodge them.
To clean heavier deposits, remove the showerhead and soak it race down in 1-2 cups of white vinegar {use white vinegar only) for about 2-3 hours. 0therwise, it may damage the outer finish. If you want to soak rt for longer, you can dilute the vinegar with water ~ratio 1·1). Screw into the shower head and run In each mode to flush out vie gar.
Do not clean or rinse any part with harsh chemicals, heavy-duty cleaners. or abrasives; this may damage parts or the finish and will void the warranty.