vtech Switch and Go T-Rex Terrain Truck Instruction Manual

: June 17, 2024
: vtech

Table of Contents

vtech Switch and Go T-Rex Terrain Truck
INTRODUCTION
INCLUDED IN THE PACKAGE
GETTING STARTED
PRODUCT FEATURES
SWITCHING FROM DINO TO VEHICLE
SWITCHING FROM VEHICLE TO DINO
CARE & MAINTENANCE
TROUBLESHOOTING
FCC STATEMENT
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

vtech Switch and Go T-Rex Terrain Truck

INTRODUCTION

Time for some roaring fun with Switch & Go® T-Rex Terrain Truck. One-touch transformation switches this rugged off-road vehicle into a tough and cool T-Rex. Press the Voice Button to hear fun phrases and cool sound effects.

vtech-Switch-and-Go-T-Rex-Terrain-Truck-FIG-1

INCLUDED IN THE PACKAGE

One Switch & Go® T-Rex Terrain Truck
One Quick Start Guide

WARNING
All packing materials such as tape, plastic sheets, packaging locks, removable tags, cable ties, cords, and packaging screws are not part of this toy and should be discarded for your child’s safety.

NOTE:
Please save this Instruction Manual as it contains important information.

GETTING STARTED

Battery Removal and Installation

Make sure the unit is turned Off.
Find the battery cover located on the bottom of the unit, use a screwdriver to loosen the screw, and then open the battery cover.
Remove the old battery by pulling up on one end of each battery.
Install 1 new AAA (LR03/AM-4) battery following the diagram inside the battery box. (For best performance, alkaline batteries or fully charged Ni-MH rechargeable batteries are recommended.)
Replace the battery cover and tighten the screw to secure it.

Note: If there is no response when the T-Rex is switched on, please install a brand-new battery and try switching the T-Rex on again.

WARNING
Adult assembly required for battery installation. Keep batteries out of reach of children.

IMPORTANT: BATTERY INFORMATION

Insert batteries with the correct polarity (+ and -).
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
Only batteries of the same or equivalent type as recommended are to be used.
Do not short-circuit the supply terminals.
Remove batteries during long periods of non-use.
Remove exhausted batteries from the toy.
Dispose of batteries safely. Do not dispose of batteries in fire.

RECHARGEABLE BATTERIES

Remove rechargeable batteries (if removable) from the toy before charging.
Rechargeable batteries are only to be charged under adult supervision.
Do not charge non-rechargeable batteries.

PRODUCT FEATURES

OFF / LOW VOLUME / HIGH VOLUME SWITCH
To turn the unit On or to adjust the volume, slide the switch to the Low or High Volume position. To turn the unit Off, slide the switch to the Off O position.

VOICE BUTTON
Press Voice Button to hear fun phrases and cool dinosaur sounds in Dino mode. In Vehicle mode, press theVoice Button to hear fun phrases and great vehicle sounds.

TRANSFORMATION BUTTON
In Vehicle mode, push the Transformation Button to trigger automatic switching from Vehicle mode to Dino mode.

LED LIGHTS
The LED Lights will flash along with the sounds in Dino mode and Vehicle mode.

AUTOMATIC SHUT-OFF
To preserve battery life, the unit will automatically shut off after approximately 20 seconds without input. T-Rex Terrain Truck can be woken up again by pressing the Voice Button.

Note: If the unit powers down or if the light flashes 3 times without sounds during play, please install a new battery.

SWITCHING FROM DINO TO VEHICLE

vtech-Switch-and-Go-T-Rex-Terrain-Truck-FIG-10

In Dino mode, flip the tail up toward the head.
Flip the feet up.
Simultaneously push both exhaust pipes firmly into the body until you hear a click.
The unit is now in Vehicle mode.

SWITCHING FROM VEHICLE TO DINO

vtech-Switch-and-Go-T-Rex-Terrain-Truck-FIG-12

Push the Transformation Button to switch automatically from Vehicle to Dino mode.

Note : For optimal transformation from Vehicle to Dino mode, please ensure that the exhaust pipes have been pushed into the vehicle body until you hear a clicking sound.

CARE & MAINTENANCE

Keep the unit clean by wiping it with a slightly damp cloth.
Keep the unit out of direct sunlight and away from any direct heat source.
Remove the battery if the unit will not be in use for an extended period of time.
Do not drop the unit on hard surfaces and do not expose the unit to moisture or water.
If the unit is not working properly, install a new battery.

TROUBLESHOOTING

If for some reason the unit stops working or malfunctions, please follow these steps:

Turn the unit Off.
Interrupt the power supply by removing the battery.
Let the unit stand for a few minutes, then replace the battery.
Turn the unit back On. The unit should now be ready to use again.
If the unit still does not work, insert a new battery.

IMPORTANT NOTE:
If the problem persists, please call our Consumer Services Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in Canada, or go to our website vtechkids.com and filling out our Contact Us form located under the Customer Support link. Creating and developing VTech products is accompanied by a responsibility that we take very seriously. We make every effort to ensure the accuracy of the information, which forms the value of our products. However, errors sometimes can occur. It is important for you to know that we stand behind our products and encourage you to contact us with any problems and/or suggestions you might have. A service representative will be happy to help you.

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. CAN ICES-3 (B)/NMB-3(B)

FCC STATEMENT

NOTE

This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used under the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.

CAUTION
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information

Trade Name : VTech®
Model : 5693
Product Name : Switch & Go® T-Rex Terrain Truck
Responsible Party : VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200 Arlington Heights, IL 60004
Website: vtechkids.com

Visit our website for more information about our products, downloads, resources, and more. vtechkids.com vtechkids.ca Read our complete warranty policy online at