XGIMI Floor Stand Ultra User Manual
- June 17, 2024
- XGIMI
Table of Contents
XGIMI Floor Stand Ultra
User Guide
- Please carefully read the product specifications as well as the operating precautions before using this product.
- We highly appreciate you purchasing and using products produced by XGIMI Tech Co., Ltd.
(also known as “XGIMI Tech” or “XGIMI”).
- Before using this product, please read the product specifications for your safety and benefit. XGIMI Technology will not be aocountable for any personal injury, property damage,
- or other losses resulting from your failure to comply with these terms.
- About the Product Specifications (also known as “the specification”)
- XGIMI Technology has reserved all of the specifications·
- copyrights. All of the trademarks and brands mentioned in the specification belong to their respective owners.
- If there is any inconsistency between the specification and the actual product, the actual product will prevail.
- Any objections to any content or clause found within the specification should be reported in writing to XGIMI Technology within 7 days after the purchase. Otherwise, it will be assumed that you agree with, understand, and accept all the specification’s content.
Product Components
- Gimbal Support Rod x 1
- Quick Release Gimbal (Module A) x 1
- Auxiliary Threader x 1
- Basexl
Installation
-
Rotate the base cover counterclockwise as indicated on the base itself and remove the cover.
-
Pull the DC power cord (connected to the device) through hole A.
-
Place the power adapter into the slot (shown in the image) and secure it.
-
Pull the power cord (socket end) through the slot and out from hole B
-
Pull the DC cord through the base cover hole. Place the base cover on top and rotate it clockwise as indicated on the base itself to secure it..
-
Insert the DC cord into the auxiliary threader.
-
With the gimbal support rod unextended, pull the DC cord in from inside the rod (starting at the bottom) and out its opening (at the top).
-
Align and insert the gimbal support rod into the base hole. Twist the fastening knob clockwise to tighten.
-
Loosen the height adjustment ring. Then, adjust the gimbal support rod head to the proper height. After, tighten the height adjustment ring.
-
Align the threaded hole at the bottom of the projector with the screw on module A and screw it clockwise to tighten.
-
Secure module A into module B, located on the quick release gimbal. Screw module A into module B clockwise to finish the installation.
-
Adjust gimbal module C to achieve an appropriate projected image (based on your needs). Tighten the knob clockwise to finish adjustment.
- XGIMI Technology Co., Ltd.
- Building A4, No. 1129 Century City Road, New and High-tech
- zones, Chengdu City China
- service@xgimi.com www.xgimi.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>