ANKER A1643 MagGo Power Bank User Guide
- June 17, 2024
- Anker
Table of Contents
A1643 Mago Power Bank
User Guide
A1643 Mag Go Power Bank
Anker Mag Go Power Bank (6.6K)
QUICK START GUIDE
PAP22
Raccolta Carta
Product Number: A1643
51005004214 V02
- This wireless charger is not compatible with non-Magsafe phone cases, such as Otter box Defender cases.
- Do not use an adapter with an output of 5V/1A (5W) or less.
- High temperatures will reduce charging speed and restrict power, which is something that happens to all wireless chargers. It is recommended that you charge your device in environments with temperatures below 25°C / 77°F.
Important Safety Instructions
When using this product, basic precautions should always be followed:
-
Use of a power supply or charger not recommended or sold by the product manufacturer may result in a risk of fire or personal injury.
-
Operating temperature should be between 0°C to 35°C / 32°F to 95°F.
-
Do not disassemble this product. Take it to a qualified service person when service or repair is required. Incorrect reassembly may result in a risk of fire or personal injury.
-
CAUTION: Risk of explosion if the battery is replaced by an incorrect type.
-
To reduce the risk of injury, close supervision is necessary when the product is used near children.
-
Do not expose power bank to rain or snow.
-
Do not use the power bank that is damaged or modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire. explosion or risk of injury.
-
Do not expose a power pack to fire or excessive temperature.
Exposure to fire or temperature above 100°C may cause explosion. -
Switch off the power bank when not in use.
-
CAUTION: Risk of Fire and Burns. Do Not Open, Crush or Incinerate. Follow Manufacturer’s Instructions.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable Protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be
determined by turning the equipment o and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit diferent from that to
which the receiver is connected.
(4) Consult the dealer or an experienced radio / TV technician for help.
Radiation Exposure Statement
This equipment complies with FCC Radiation exposure limits set forth for an
uncontrolled environment. This equipment can be used in portable exposure
condition.
The following importer is the responsible party (for FCC matters only).
Company Name: Fantasia Trading LLC
Address: 5350 Ontario Mills Pkwy, Suite 100, Ontario, CA 91764
Telephone: +1 800 988 7973
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation,
Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
RF Exposure Statement
IC RF exposure statement:
This equipment complies with IC Radiation exposure limits set forth for an
uncontrolled environment. This equipment can be used in portable exposure
condition.
Declaration of Conformity
This product complies with the radio interference requirements of the European
Community.
Hereby, Anker Innovations Limited declares that this product is in compliance
with Directives 2014/53/EU & 2011/65/EU. The full text of the EU declaration
of conformity is available at the following internet address:
https://www.anker.com.
This symbol indicates that this product shall not be treated as household
waste.
Instead, it shall be handed over to the applicable collection point for the
recycling of electrical and electronic equipment.
The following importers are the responsible parties (contract for EU and UK
matters) Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Ltd
GNR8, 49 Clarendon Road, Watford, Hertfordshire, WD17 1HP, United Kingdom
(a) frequency band(s) in which the radio equipment operates;
(b) maximum radio-frequency power transmitted in the frequency band(s) in
which the radio equipment operates.
| Radiated H-Field | -12.53 dBuA/m@10m |
|---|---|
| TX/RX frequency range | 111-360KHz |
For tutorial videos, FAQs, manuals, and more information, please visit:
https://support.anker.com
Or scan the QR code below:
|
---|---
https://rainbowbridge.anker.com/qrscan?key=anker-221202
|
https://rainbowbridge.anker.com/qrscan?key=Anker_A1643_UG
| |
---|---|---
@anker_official @anker_jp| @AnkerDeutschland
@AnkerJapan
@Anker| @AnkerOfficial
@Anker_JP
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>