Joydeem JD-376B Electric Food Processor Instruction Manual

Joydeem JD-376B Electric Food Processor

Safety Precautions

Please read this handbook carefully before using this product. In order to avoid personal injury caused by improper use of appliances, please strictly observe the instructions.

1. Check that the voltage you are using matches the voltage rating of the
2. The cover of the bowl may not be opened until the blade stops
3. The knife assembly is very sharp. Take care when taking down the protective sleeve and cleaning and maintaining, prevent cutting.
4. When removing the plug, grasp the plug and pull out the power cord, and do not pull the cord.
5. The host of the product configuration cannot be used for other
6. Before cleaning the product, be sure to unplug the power cord; After the normal temperature is restored, the components can be removed or cleaned.
7. Ensure that the power cord is not hung on the edge of the table or counter, or on the surface of the high temperature component.
8. Can not be placed in or near gas cooker, induction cooker, hot oven,
9. During the process of crushing food, the hand or tableware should not touch the blade to avoid a safety risk, resulting in personal injury or damage to the product; If you need to use the blade, you must ensure that the product is stopped before it can be
10. Do not immerse the power cord, plug, mainframe in water or other liquids to avoid the risk of fire, leakage of electricity or personal injury.
11. If children are operated on or near to use this product, they must be accompanied by parents for guidance and supervision.
12. Children should be supervised to ensure that they do not play with the appliance.
13. Avoid contact with moving
14. The use of non-factory recommended or sold accessories may cause risks of fire, electricity leakage or personal
15. If the power cord is damaged, it must be replaced by professionals of the manufacturer, its maintenance department or similar departments in order to avoid
16. Appliances can not be used by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe
17. In the absence of supervision, the cleaning and maintenance work should not be done by the child.
18. The equipment shall be used according to the instruction manual, not for use by others, and not for outdoor use.
19. Before use, please make sure the mainframe is firmly fixed.
20. Do not attempt to shield the safety interlock of the bowl lid.
21. Appliance must not be immersed in water.
22. Please save this manual.

Warning:

This product is limited to family use only!

To avoid danger of injury, do not take off the main engine and open the bowl cover before the knife assembly stops.

After the food is finished, remove the knife components and deal with the food. Do not use the hand to handle the food before they are removed.

Warning

1. After the food is chopped, first remove the plug, take out the main machine, bowl cover, and then take out the knife assembly, and then deal with the chopped food, and then clean it. Remember that before the knife assembly is taken out, do not handle the food by hand. (see Figure 1)

2. This product uses the resettable temperature control device. When the product runs for a long time, the temperature of the main engine rises. When the temperature exceeds the upper limit of the temperature insurance device, the product automatically stops working. When the temperature naturally drops to the set temperature value , unplug the plug and plug it in again to continue When the product stops working, please remove the plug to avoid the danger of misoperation.

3. Do not open the blade until it stops rotating.

4. When taking the cover, remember not to touch the blade, because it is very sharp.

5. When cleaning the knife assembly, it needs to be wiped with a cleaning cloth, and hands cannot touch the blade, because it is very sharp. (see Figure 1)
   

6.  After the work is completed, please do not turn over the knife assembly and insert it on the main engine. Please wipe the main engine with a clean cloth. It is forbidden to flush water.(see Figure 2)
   

7. After use, the knife assembly should be put on the knife protection cover and put into the bowl to avoid hand injury. (see Figure 3)
   

Warning: Do not open the blade before it stops rotating; the product is only for daily home use

Product introduction

THE CIRCUIT DIAGRAM

FIRST USE

1. Before using this product for the first time, please clean the stainless steel small bowl, medium bowl, large bowl and knife components with soap solution and dry them thoroughly; the stainless steel small bowl, medium bowl and large bowl can be used for dishwasher cleaning; the main engine is wiped with wet cloth and cannot be soaked in water; the knife components can be washed. (see Figure 6)
2. After cleaning the machine, first put the knife assembly into the bowl, then add the required ingredients to the bowl, cover the bowl cover, plug in the plug power supply, and finally press the switch button down by hand, so that the food ingredients can be cut.

HOW TO CHOP FOOD

Small stainless steel bowl (see Figure 6)

1. Place the small stainless steel bowl on the bowl pad, and then install the knife assembly on the main shaft at the bottom of the small stainless steel bowl; pay attention not to touch the blade part, because it is very sharp.

2. Put cooked food into a small stainless steel bowl. Please refer to the shredding instructions for ideal food condition. Cooked food needs to be cooled.

3. Cover the bowl cover, then place the main engine on the corresponding position of the bowl cover, and adjust the alignment with reference to the alignment dots on the main engine and the bowl cover until the main engine and the bowl cover dot mark are aligned.

4. Press and hold the switch button, the product starts to work, and the food in the bowl is chopped.(see Figure 6)
   Note: This product is equipped with a pulse button, please avoid direct continuous operation of the motor for more than 30 seconds. The longer the continuous operation, the finer the texture of the food. For coarse food, please use a short time to work.

5. Please make sure that the blade stops rotating completely before opening the bowl cover. Unplug the power plug, pick up the main engine, then grasp the plastic bracket part of the knife assembly, and lift up the knife assembly. Pick up the stainless steel bowl and pour out the food. Please do not use this stainless steel bowl for food storage.

6. At the beginning of use, please make sure that the three grooves of the bowl cover are aligned with the limit position in the bowl mouth. If not, please do not forcibly cover the bowl cover. After using the machine, the three stainless steel bowls need to be put together as small as large. Please do not forcibly put the large stainless steel bowl into the small stainless steel bowl. (see Figure 7)

CLENING AND MAINTENANCE

Please keep the power supply of the product disconnected before cleaning. After use, the stainless steel bowl and knee components can be d eaned with warm water I detergent/ dishwasher; the main machine can not be immersed in water.
please use a wet cloth to clean the main machine. Please clean it immediately AFTER Use to avoid bacteria.

Note: When cleaning the blade, do not touch the blade directly. Please use soft cleaning tools (such as cleaning cloth) to clean it. Do not use cleaning tools such as chemical agents, steel, wood or coarse materials to avoid damaging the product surface luster.

FOOD SHREDDING DUIDELINES

Small stainless steel bowl:

1. Nuts (roasted first)
2. Cookies, biscuits
3. Bread: fresh, baked
4. Baby

complementary food (chicken breast, lean meat…)

| Nuts: put up to 200g, then cut for 30 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached; Cookies, cookies: add up to 12 cookies or biscuits, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached;
Types of food| Preprocessing tips
---|---
Small stainless steel bowl:

1. Nuts (roasted first)
2. Cookies, biscuits
3. Bread: fresh, baked
4. Baby
   complementary food (chicken breast, lean meat…)

| Bread: use one piece at a time, tear it into pieces, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached; Complementary food for infants: put up to 200g, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached;
Medium stainless steel bowl:

1. Cut fresh beef or other boneless and gluten free meat into 60mm 20mm 20mm blocks.
2. Cut 2-4 garlic roots and break them into cloves.

| Beef or other boneless meat: put 500g at most, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached;
Cut the roots of 2-4 garlic and break them into cloves: cut the roots of 2-4 garlic and put the cloves into a bowl, press down the key to open and keep,peel garlic stick work for for 30-60 seconds.
Large stainless steel bowl:

1. Fruits and vegetables (canned, boiled)
2. Fresh celery, pepper and other leafy plants

| Fruits and vegetables: add up to 500g of chopped fruits or vegetables, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached;
Fresh celery, peppers and other leafy plants: wash and dry completely, then cut for 20 seconds, stop for 1 minute as a cycle, carry out several cycles of operation, until the required degree of cutting is reached;

ATTENTION ENVIRONMENT PROTECTION

Attention Environment Protection
Please obey local law: put wasted electric products and devices into proper waste recycling station.

Analysis of common faults and associated removing methods

power cord and ensure it is plugged in place
The main unit and bowl cover are not assembled in place, and there is no trigger switch connecting rod.| Please install the host and bowl cover in place before starting
The machine broke down| Contact customer service for maintenance
The food ingredients won’t break| The supply voltage is too low| Available household voltage regulators
Quantity of ingredients too many or too few| Please follow the recipe
The machine broke down| Contact customer service for maintenance
Abnormal noise| Product running in| Accidental occurrence is normal
Burning smell| Does it last for a long time| The motor is located inside the main engine because the friction and high temperature of the carbon brush lead to the vaporization of the enameled wire, but it is not a product fault.Please use it freely

CUSTOMER SERVICE

Panda Brands Inc warranties this product to be free from defects in materials or craftsmanship for a period of one year following the date\ of purchase,provided that the product is used in a home environment.
This limited warranty does not cover failure due to abusive operations, accidental damage or when repairs have been made or attempted by non professional.A defective product meeting the above warranty conditions set forth herein will be replaced or repaired at no charge if the product is purchased within 30 days.Beyond 30 days but within One year of original purchases, the product will be repaired or replaced free of charge and customer will be responsible for shipping charges.Beyond One Year of original purchases, customer will be responsible for parts,labor and shipping charges.This product is not intended for commercial use,and accordingly,such commercial usage will void this warranty.For more information,please contact the customer service at service@pandabrands.com

Imported and distributed by:Pandabrands Inc.
Email:business@pandabrands.com
Customer service:service@pandabrands.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>