WINTER SHORE HS-FLTSLF1 Floating Acrylic Bathroom Shelves Instruction Manual
- June 17, 2024
- WINTER SHORE
Table of Contents
WINTER SHORE HS-FLTSLF1 Floating Acrylic Bathroom Shelves
INSTALLATION STEPS
STEP 1 →
Installing the shelf with the adhesive hooks. First, you will need to attach the shelf to the hooks before sticking to the wall to get it straight. To do this, loosen the nuts and slot the shelf over the adhesive hooks, then tighten the nuts. Leave the protective backing on the adhesive so it doesn’t stick while measuring. Now mark where you want the shelf to go. Use a level when holding the shelf up so it’s straight. Make sure to mark where each adhesive hook is once the shelf is level so you know where to stick it.
STEP 2 →
Once you are happy with the levelling and placement, remove the shelf from the hooks and take the protective backing film off one of the hooks. Press firmly in place where you measured, repeat this for each hook. Press and hold them for 60 seconds. Best to leave hooks overnight to form a strong bond to the wall before adding the shelf and items.
STEP 3 →
Now you can slot the shelf back onto the hooks and tighten each nut until the shelf is secure.
STEP 4 →
The setup is complete.
STEP 1 →
Installing the shelf with screws and wall plugs. To begin, measure out and
mark where you want the shelf to go. Use a level when holding the shelf up so
it’s straight.
STEP 2 →
Next, take a drill and drill holes where you marked (start with a smaller
drill bit as you can always make the holes bigger.)
STEP 3 →
Insert the wall plugs provided into the drilled holes. Gently tap them in with
a hammer.
STEP 4 →
Now take the screws provided and a screwdriver and attach the shelf to the
wall. The setup is complete.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>