ZOOM 5350 WiFi Wireless Portable Modem User Manual
- June 5, 2024
- Zoom
Table of Contents
ZOOM 5350 WiFi Wireless Portable Modem User Manual
1 HARDWARE
Repair/ Reset
H you ,cannot cages the web-based setup page or cannot connect to the muter:. you can press the Reiser button:
- Press and hold .seconds, and then release to repair your network.
- Press and hold for 10 seconds. and then release to lest tile router to factory settings. All user data will be cleared.
- Login and Reset
2 SETTING UP
-
Insert TF Card & Power On
When pow1m!d up, youth GL-AR75O router will broadcast two Wi-Fi signals why the SSID: GL-AR750-xxx and GL-AR750-xxx-5G -
Conned via Wi-Fi
3 Set up Router
3 INTERNET SETTING
4 OPENVPN CLIENT
FCC Statement
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. This
equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
This device complies with FCC radiation exposure limits set forth for an
uncontrolled environment and it also complies with Part 15 of the FCC RF
Rules. This equipment should be installed and operated with minimum distance
20cm between the device and your body.
Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>