DOTLUX 5234-140240 ASSISTsensor LED Floor Lamp User Manual

: June 4, 2024
: DOTLUX

Table of Contents

DOTLUX 5234-140240 ASSISTsensor LED Floor Lamp
INSTALLATION
User manual
Maintenance/ Care
Safety Precautions
Disposal Instructions
Service Address
Symbols IP protection / Protection class
Read User Manual Online (PDF format)
Download This Manual (PDF format)

DOTLUX 5234-140240 ASSISTsensor LED Floor Lamp

DOTLUX-5234-140240-ASSISTsensor-LED-Floor-Lamp-product

Product data

DOTLUX-5234-140240-ASSISTsensor-LED-Floor-Lamp-fig-1

Scope of delivery

This product contains a light source of ener-gy efficiency class C.

Intended use
Portable luminaire for indoor use.

Conformity
DOTLUX GmbH hereby declares that this product complies with the EU Directives EMC 2014/30/EU, LVD 2014/35/EU, RoHS 2011/65/EU, and the Ecodesign Directive 2009/125/EC.

INSTALLATION

DOTLUX-5234-140240-ASSISTsensor-LED-Floor-Lamp-fig-2

NO SENSOR

DOTLUX-5234-140240-ASSISTsensor-LED-Floor-Lamp-fig-6

MOTION SENSOR

DAYLIGHT SENSOR

User manual

Before Using / Notice of Liability
Dear customer,
please unpack the products carefully and check that the delivery is complete and that the units are undamaged. Do not operate lamps with a damaged electrical part, cable or glass. In cases of damaged components, you should contact the mentioned service address (point 9) immediately. Please read these instructions carefully. Thereby mistakes are avoided that could lead to hazards or malfunctions. Keep the instructions and the installation manual in a safe place for future reference. The manual must be passed on to all subsequent owners or users of the product. Ensure that any supplements you may receive have also been appended to the manual. The manufacturer cannot accept any responsibility and/or liability for bodily injury or property damage due to:

improper installation
unauthorized modification of the product
improper use
non-compliance with these instructions

Declaration of Conformity
The full text of the EU declaration of conformity is available at the following Internet address: https://www.dotlux.de/konformitaetserk- laerungen/

Other Symbols
Always follow the symbols on the packaging and in the instructions. The characters and symbols are explained below: This manual assumes knowledge that corresponds to complete training as an electrician.

Attention! Basic safety precautions should always be followed.

The light source is not replaceable. The entire luminaire must be replaced.
The LED light source is replaceable by the end user.
The LED light source is replaceable by a qualiﬁed person.
The ballast is not replaceable.
The ballast is replaceable by the end user.
The ballast unit can be replaced by a qualiﬁed person.

Intended Use / Foreseeable Misuse

This product is for lighting. Please see the assembly drawing for further information concerning intended use. Do not expose to strong mechanical stress or heavy contamination. For safety reasons, do not modify and/or convert the product as any other use may damage the product. This could lead to hazards such as short circuits, electrical shock, or fire. When switching several luminaires, a zero-crossing switch must be used. Motion detectors must also be equipped with a zero-crossing switch.

Maintenance/ Care

Turn off the power and allow the lamp to cool down before cleaning, maintaining or replacing the lamp! Check that there is no voltage. Use a dry or moist cloth for regular cleaning (2 or 3 times per year). Chemicals or abrasives must never be used. A special stainless steel cleaning agent is recommended for cleaning stainless steel luminaires. The following environmental influences can have undesirable effects on the surface of the product: acid rain and soil, high salt content in the air, cleaning agents, fertilizer (especially in ï¬‚ower beds), de-icing salt, and other chemical substances (e.g. pesticides). Only the lamps stated on the packaging may be used.

Safety Precautions

Please observe the national installation and safety regulations during installation, operation, and maintenance. Do not install the lamp when the voltage has been applied to the lamp. Caution Danger to life! Electrical connections may only be carried out by a qualiﬁed electrician. Damaged electronic parts my only be replaced by a qualiﬁed electrician. This product and its packaging contain small parts that can be swallowed by children. For this reason, the product and its packaging must always be kept out of reach of children.

Replace any broken protective glass immediately. Always ensure that only original parts are being used.
Minimum distance to illuminated objects

Disposal Instructions

After the implementation of Euro- pean Directive 2012/19/EU and 2006/66/EG in the national legal system, the following applies: Electric and electronic devices as well as batteries must not be disposed of with household waste. Consumers are obliged by law to return electrical and electronic devices as well as batteries at the end of their service lives to the public collecting points set up for this purpose of point of sale. Details to this are deïfined by the national law of the respective country. This symbol on the product, the instruction manual or the package indicates that our product is subject to these regulations. By recycling, reusing the materials or other forms of utilizing old devices/ batteries, you are making an important contribution to protecting our environment.