aspire K Lite Regulated Mod User Manual

aspire K Lite Regulated Mod

Product Information
The K Lite Mod is a vaping device designed for adult smokers who wish to transition from traditional cigarettes to e-liquids. It is not recommended for non-smokers, individuals under the legal smoking age, pregnant or breastfeeding women, and those experiencing general ill health. This product comes with a built-in LiPo battery with a capacity of 900mAh, providing a continuous firing time of 10 seconds. The mod has optional output voltage settings ranging from 3.0V to 5.0V and supports a resistance range of 0.8-3.0 ohms. The dimensions of the K Lite Mod are 26.5mm x 75mm x 17mm.

Product Usage Instructions

Safety Precautions
Before using the K Lite Mod, it is essential to consider the following safety precautions:

• Only use nicotine-containing e-liquids if you are not allergic to nicotine or any other ingredients present in the e-liquid. Refer to the manufacturer’s label for full details.
• Always lock or switch off the device when not in use, especially when carrying it in your pocket, bag, or purse, to prevent misfiring.

Charging the Device
To charge the K Lite Mod, follow these steps:

1. Locate the micro USB charging port on the device.
2. Connect one end of the USB cable to the charging port.
3. Plug the other end of the USB cable into a compatible power source.
4. The indicator light will illuminate to indicate that the device is charging.
5. Once fully charged, the indicator light will turn off.

Operating the Device
To operate the K Lite Mod, follow these steps:

1. Ensure the device is unlocked or switched on.
2. Press and hold the fire button to activate the device.
3. Use the mode button to adjust the output voltage according to your preference. The available voltage settings are 3.0V, 3.5V, 4.0V, 4.5V, and 5.0V.

Specifications

• Optional Output Voltage: 3.0V, 3.5V, 4.0V, 4.5V, 5.0V
• Supported Resistance Range: 0.8-3.0 ohms
• Continuous Firing Time: 10 seconds
• Firmware Update: N/A
• Battery Type: Built-in LiPo
• Battery Capacity: 900mAh
• Dimensions: 26.5mm x 75mm x 17mm

FAQ

Q: Can non-smokers use the K Lite Mod?
A: No, the K Lite Mod is intended for adult smokers only and is not recommended for non-smokers.

Q: Can pregnant or breastfeeding women use this product?
A: No, this product is not recommended for pregnant or breastfeeding women.

Q: What should I do if I am allergic to nicotine?
A: If you are allergic to nicotine, do not use nicotine-containing e-liquids with this product. Refer to the manufacturer’s label for full details on the e-liquid ingredients.

Q: How long does the battery last?
A: The built-in LiPo battery has a capacity of 900mAh, providing a continuous firing time of 10 seconds. The battery life may vary depending on usage.

Q: Can I adjust the output voltage?
A: Yes, the K Lite Mod allows you to adjust the output voltage. Use the mode button to select from the available voltage settings:3.0V, 3.5V, 4.0V, 4.5V, and 5.0V.

Read this information leaflet fully before you start using this product as it contains important information. The notes below relate to when the device is filled with e-liquid that contains nicotine.

This product is intended for adult smokers. This product is not recommended for non-smokers, young people under the legal age, pregnant or breastfeeding women, and those experiencing general ill health.

FEATURES

Contents

• 1* K Lite mod
• 1* USB cable
• 1* Warranty card
• 1* User manual

Mod Specifications

• Optional output voltage: 3.0V, 3.5V, 4.0V, 4.5V, 5.0V
• Supported resistance range: 0.8-3.0Ω
• Continuous firing time: 10 seconds
• Firmware update: N/A
• Battery type: Built-in LiPo
• Battery capacity: 900mAh
• Dimensions: 26.57517mm

Instructions

Power on/off
Pressing the fire button 5 times within 2 seconds will turn the device on or off. The indicator light will flash white 3 times to indicate on or off.

Vaping
When the device is on, press the fire button, the indicator light will indicate your device’s current charge. When its current charge is above 3.8 volts (60-100%), the indicator light will be green. When the charge is between 3.5 and 3.8 volts (30-60%), the light will be blue. When the charge drops below 3.5 volts (0-30%), the light will then turn red to remind you tthat it is time to charge the device.

Set the output voltage
Press the mode button to adjust the output voltage. The voltage display will turn on for 3 seconds to indicate the value of the corresponding output voltage: 3.0V, 3.5V, 4.0V, 4.5V, 5.0V.

Protection Features

• Automatic cutoff: The preset continuous fire time is 10 seconds, after 10 seconds of continuous firing, the indicator light will flash pink 10 times and the device will stop firing.
• Short circuit protection: When the device detects a short, it will stop firing, and the indicator light will flash pink 3 times.
• Low voltage protection: When the battery level drops below 3.0V, the device will not function and the indicator light will flash red 15 times to remind you to charge the device.
• Overcharge protection: When the device is fully charged, it will stop charging to prevent overcharging of your battery.
• Overheat protection: When the temperature of the chip is above 75 °C/167 °F, the indicator light will be yellow for 3 seconds and the device will cut off.

Charging Instructions

• Charging the device via a Micro USB charging port, the maximum current can reach up to 1A, and the recommended charging voltage is 5.0V.
• When the USB cable is attached, the indicator light will flash red 3 times. While charging, the indicator light will indicate the device’s current charge status: 3.5 volts or less (0-30%) = red light; 3.5 to 3.8 volts (30-60%) = blue light; 3.8 volts and above(60-100%) = green light. When the device is fully charged, the indicator light will flash green 20 times then remain off. When unplug the USB cable, the indicator light will flash green 3 times.

IMPORTANT INFORMATION ABOUT USING NICOTINE CONTAINING E-LIQUIDS

Before using nicotine-containing e-liquids the user should read the following information carefully.

NICOTINE CONTAINING E-LIQUIDS:
Do not use if you are allergic to nicotine or any of the other ingredients contained within the e-liquid (see manufacturer’s label for full details).

WARNINGS AND PRECAUTIONS
Nicotine containing e-liquids are not recommended for:

• Non-smokers
• Young people under the legal age;
• Pregnant or breastfeeding women; as nicotine is known to cross the placenta and to be excreted in breast milk;
• Those experiencing general ill health; such as heart disease, stomach and duodenal ulcers, liver or kidney problems, long term throat disease or difficulty breathing due to bronchitis, emphysema or asthma;
• Those who have an overactive thyroid gland or have a phaeochromocytoma (a tumour of the adrenal gland Bthat can affect high blood pressure);
• For those who have diabetes, as nicotine may affect your blood sugar levels.
• Those taking the following medication;
• Theophylline (to treat breathing problems)
• Ropinirole (to treat restless leg syndrome)
• Clozapine (to treat schizophrenia)

POSSIBLE SIDE EFFECTS

If you inhale too much nicotine or use the product too much you may experience one or more of the following effects:

• Feeling faint;
• Nausea (feeling sick)
• Headache
• Coughing
• Irritation of the mouth or throat
• Dizziness
• Stomach discomfort
• Hiccups
• Nasal congestion
• Vomiting (being sick)
• Heart palpitations
• Abnormal heart rate

If you experience any of these side effects; including any possible side effects not listed in this leaflet, discontinue using the product, if the effect(s) continue after you stop using, consult your doctor or healthcare professional and bring this leaflet to their attention

Safety note:
To avoid misfiring always ensure you either lock or switch off your device when it is not in use. Especially when carrying your device in your pocket, bag, or purse.

• To learn more about your products and how to use them,
• please visit: www.aspirecig.com Building 3, Xinhongtai Industrial Park, 14 Jian’an Rd, Tangwei, Fuyong Town, Baoan District, Shenzhen, China
• Tel: +86-755-81499783
• Email: service@aspirecig.com
• Shenzhen Eigate Technology Co., Ltd. Manufactured By Eigate

MADE IN CHINA

References

• Manual-Hub.com – Free PDF manuals!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>