HITACHI RAK-15QPE Performance Wall Mounted Instruction Manual
- June 1, 2024
- Hitachi
Table of Contents
HITACHI RAK-15QPE Performance Wall Mounted
Product Specifications
- Models: RAK-15QPE, RAK-18RPE, RAK-42RPE, RAK-50RPE
- Power Source: AAA Batteries
- Installation: Wall Mount
- Dimensions: Vary based on model
Product Usage Instructions
1. Mounting Location Selection:
Ensure proper spacing for installation and use of sealant as indicated in the manual.
2. Wall Mount Installation:
Follow the specific measurements and instructions provided to install the wall mount securely.
3. Perforating the Wall and Tube Installation:
Drill holes in the wall, insert anchors, and proceed with the installation of tubes following the guidelines.
4. Gas Piping Connection:
Connect the gas piping following the recommended bending radius and sealing techniques.
5. Insulation and Finishing:
Apply insulation materials and finish off the piping connections as instructed to prevent condensation.
Installation Procedures and Precautions
- Drill holes in the wall.
- Insert plugs into the holes.
- Fix the wall bracket using screws as shown.
- For external walls, ensure the protective tube is angled slightly downward towards the outside to allow for proper drainage.
Mounting the Wall Bracket
Use a level to ensure the bracket is straight. Secure it with the screws provided, making sure it can support the weight of the unit.
Installation of the Remote Control Holder
Install the remote control holder within reach for easy operation.
Connecting the Refrigerant Tubing and Air Removal
- Prepare the copper tubing using a reamer or deburring tool to prevent gas leaks.
- Connect the tubing ensuring the use of the correct torque to avoid leaks.
Power Cable Connection
Detail the steps to strip the power cable correctly and connect it to the terminal block, grounding it as necessary.
Final Steps of Installation
- Remove the front panel by pushing the arms and sliding the panel as shown.
- Secure the front panel by screwing in the hooks and fastening the electrical compartment cover.
Frequently Asked Questions
What type of batteries does the product use?
The product uses AAA batteries for power.
How should I connect the gas piping?
Follow the bending radius guidelines and ensure proper sealing during gas piping connection.
What is the recommended wall mounting procedure?
Drill holes, insert anchors, and securely mount the unit following the provided measurements and instructions.
What is the minimum clearance required for installation?
A minimum clearance of 50 mm from walls and 150 mm from corners is required.
How should the external wall protective tube be installed?
It should be angled slightly downward towards the outside for proper drainage.
How do you ensure the refrigerant tubing does not leak?
Use a reamer or deburring tool to prepare the tubing and ensure the correct torque is used during connection.
What should be done if the front panel does not fit properly?
Reposition the panel according to the instructions, ensuring not to damage the ECO sensor.
“`
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>