andis ACM-1 Hair Dryer User Guide
- June 17, 2024
- Andis
Table of Contents
**andis ACM-1 Hair Dryer User Guide
**
important safeguards
When using electrical appliances, especially when children are present, basic safety precautions should always be followed, including the following
Read all instructions before using
KEEP AWAY FROM WATER
DANGER : As with most electrical appliances, electrical parts are electrically live even when the switch is off. To reduce the risk of death by electric shock:
- Always “unplug it” immediately after using.
- Do not use while bathing.
- Do not place or store appliance where it can fall or be pulled into a tub or sink.
- Do not place in or drop into water or other liquid.
- If an appliance falls into water, “unplug it” immediately. Do not reach into the water
WARNING : To reduce the risk of burns, electrocution, fire, or injury to persons:
- An appliance should never be left unattended when plugged in.
- Close supervision is necessary when this appliance is used by, on or near children or individuals with certain disabilities.
- Use this appliance only for its intended use as described in this manual. Do not use attachments not recommended by Andis.
- Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been damaged, or dropped into water. Return the appliance to an Andis Service Center for examination and repair.
- Keep the cord away from heated surfaces. Do not wrap the cord around the appliance.
- Never block the air openings of the appliance or place it on a soft surface such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, etc.
- Never use while sleeping.
- Never drop or insert any object into any openings.
- Do not use outdoors, or operate where aerosol (spray) products are being used or where oxygen is being administered.
- Do not use an extension cord with this appliance.
- Do not direct hot air toward eyes or other heat sensitive areas.
- Attachments may be hot during use. Allow them to cool before handling.
- Do not place appliance on any surface while it is operating.
- While using the appliance– keep your hair away from the air inlets.
- Do not operate with a voltage converter.
SAVE THESE INSTRUCTIONS
This appliance is intended for professional use
OPERATING INSTRUCTIONS
This appliance has a polarized plug (one blade is wider than the other). As a
safety feature, the plug will fit in a polarized outlet only one way. If the
plug does not fit fully in the outlet, reverse the plug. If it still doesn’t
fit, contact a qualified electrician. Do not attempt to defeat this safety
feature. If this unit shuts itself off, first press the reset button on the
ALCI. If it still does not run, the thermal protectors that are built into
this dryer may have operated. If the unit still does not run after being
allowed to cool, return the unit for servicing.
Heat Selections and Cool Shot
This dryer is equipped with a cool shot button. To achieve the cool shot of
air, just press the button located on the front top portion of the handle. The
cool shot is ideal for locking in curl for longer lasting style. Just
concentrate cool air on desired curl until set.
How your Andes Dryer with Shock
Protection Works
This Andes hair dryer has been manufactured with an APPLIANCE LEAKAGE CIRCUIT
INTERRUPTER (ALCI). This mechanism will shut the dryer off (making it
inoperable) under abnormal conditions, such as falling or being immersed in
water. If this appliance becomes inoperable, return it to an Andes Authorized
Service Station for examination and repair. The ALCI Shock Protection is
equipped with a test and a reset button. Below are instructions on their use
TEST BEFORE EACH USE
- Plug the dryer into a 110-120 volt electrical outlet (ordinary household current). Do not attempt to use any other electrical outlet.
- Before attempting to switch the dryer on, perform the following test: Press the test button, the reset button should pop up. This confirms that the safety plug is working properly.
- Now press the reset button and your dryer with the Shock Protection in the handle will be operable and the power switch of your dryer may be turned on for normal use.
- If this appliance does not operate in the proper functioning condition, it should be either returned to an Andis Authorized Service Station for examination and repair, or discarded.
To Remove Air Intake Grill
This Andis dryer is equipped with a removable air intake grill. This grill may
be removed for ease of cleaning excess hair and lint that can clog up a hair
dryer. To remove the grill, simply depress the wing tabs on the side of the
grill. Grill and foam filter are two separate pieces– be sure not to lose
filter when cleaning. To clean grill that has been removed from the dryer,
take a small brush and mild cleaning solution and lightly brush away excess
lint and hair. Rinse and dry both pieces. Be sure that both pieces are
completely dry before returning it to the dryer. Once they are completely dry,
position the foam filter in place and snap grill back into place
For ACM-5 Models Only
Andis’ ACM-5 model dryers are equipped with 12 LED lights around the barrel.
These LED lights are controlled by a switch on the side of the dryer. First,
plug the dryer into the outlet. To turn the lights “on”, move the switch to
the left. To turn the lights “off”, move the switch to the right. After you
are finished using the dryer, make sure the LED lights and the fan setting are
turned to “off.” Unplug dryer, rewrap cord, and store in a safe place.
The LED lights provide you with these features:
- Exclusive Andes LED circuit for maximized LED life.
- Twelve LEDs for full hair coverage.
- Durable LEDs withstand professional dryer use without burning out.
- Ultra-bright white LED light source generates no hear
USER-MAINTENANCE INSTRUCTIONS
This appliance does not require special maintenance, cleaning or lubrication. Service only through authorized Andes repair stations. Untwist cord before use. After use, re-wrap cord and store unit in a safe place. Do not wrap cord tightly around appliance. Do not hang the unit by the power cord.
Cleaning
- The hair dryer must be unplugged before it is cleaned.
- Clean the external surfaces of the hair dryer with sponge or soft rag moistened with a mild soap and water solution. Do not use harsh cleaners, detergents, or solvents.
- Dry the hair dryer thoroughly before use.
- Clean screen with vacuum cleaner.
How to Blow Dry
Towel-pat wet hair to remove excess water and to shorten drying time; untangle
hair. Part hair into sections; blow dry hair section by section.
Choose setting that is most comfortable and that gives best results. Heat
molds and puffs up hair to give it body and fullness. The way you lift and dry
damp hair at scalp, and turn the ends, will determine the direction of the
hair.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>