Crosley CR55 302 Wall Phone Instruction Manual

Crosley CR55 302 Wall Phone

Crosley 302 Wall Phone

www.crosleyradio.com

IMPORTANT SAFETY INSTRUCTIONS

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:

1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
4. Do not place this product on an unstable cart, stand, or table. The product may fall, causing serious damage to the product.
5. Slots and openings in the cabinet and back or bottom are provided for ventilation, to protect it from overheating, these openings must not be blocked or covered. The openings should never be blocked by placing the product on the bed, sofa, rug, or other similar surface. This product should never be placed near or over a radiator or heat register. This product should not be placed in a built-in installation.
6. Never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage points or short out parts that could result in a risk of fire or electric shock. Never spill liquid of any kind on the product.
7.  To reduce the risk of electric shock, do not disassemble this product. Take it to a qualified serviceman when some service or repair work is required. Opening or removing covers may expose you to dangerous voltages or other risks. Incorrect re-assembly can cause electric shock when the appliance is subsequently used.
8. Unplug this product from the wall outlet and refer servicing to qualified service personnel in the following cases:
   • When the power supply cord or plug is damaged or frayed.
   • If liquid has been spilled into the product.
   • If the product has been exposed to rain or water.
   • If the product does not operate normally by following the operating instructions. Adjust only those controls, that are covered by the operating instructions because improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product to normal operation.
   • If the product has been dropped or the cabinet has been damaged.
   • If the product exhibits a distinct change in performance.
9. Do not allow anything to rest on the power cord. Do not locate this product where the cord will be abused by persons walking on it.
10. Do not use this product near water, for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near swimming pool.
11. Avoid using a telephone (other than a cordless type) during an electric storm. There may be a remote risk of electric shock from lightning.
12. Do not use the telephone to report a gas leak in the vicinity of the leak.
13. Use only the power cord and batteries indicated in this manual. Do not dispose of batteries in a fire. They may explode. Check with local codes for possible special disposal instructions.

SAVE THESE INSTRUCTIONS

PARTS INCLUDED

Your new telephone includes the following items:

• 1 – Telephone Handset
• 1 – Handset coil cord
• 1 – Telephone body
• 1 – 7 Foot line cord
• 1 – 15 Inch line cord
• 2 – Screws with wall anchors
• 1 – Wall mounting template.
• 4 – Rubber spacer pads.
• 2 – Tapping screw
• 1 – Template (See above picture and instructions)

MOUNTING HOLE A

• USE THIS TEMPLATE TO DETERMINE THE POSITION OF THE TELEPHONE ON WALL, AND WHERE TO LOCATE SCREW HOLES.
• REMOVE TEMPLATE FROM WALL BEFORE INSERTING PLASTIC ANCHORS OR SCREWS USE ONLY FOR WALL

INSTALLATION OF TELEPHONE SET

MOUNTING HOLE B

SET UP

• DIAL MODE
• The DIAL MODE switch is located at the back of the telephone. Slide the switch to TONE unless you have Dial-Pulse (Rotary) telephone service in your area, in which case, slide the switch to the PULSE position.

MECHANICAL BELL RINGER CONTROL

• The RINGER CONTROL switch at the back of the telephone allows you to turn the ringer ON or OFF. You can still make or receive calls with the ringer in the OFF position, however, you will not hear the incoming ring.

RECEIVER VOLUME

• The RECEIVER VOLUME CONTROL switch, located on the bottom of the telephone, allows you to adjust the volume of the receiver earphone from LOW and HI.

INSTALLATION

• To connect the telephone, connect the line cord from the back of the telephone to the wall jack.

MAKING AND ANSWERING CALLS

• To get a dial tone or answer an incoming call, lift the handset.
• To hang up, either replace the handset or press the HANDSET CRADLE manually.

FLASH

• Pressing FLASH sends the electronic equivalent of a switchhook signal. Use FLASH with special phone company services such as call waiting.

IF THERE IS NO DIAL TONE

• Make sure that all plugs are connected properly. Check the connections at the wall jack, the telephone cabinet, and the handset.
• Try another modular jack within your home which you know to be working properly.

IF CALLS CAN BE DIALED OR DIALED SLOWLY

• Check to make sure that the DIAL MODE switch is in the correct position for the type of service (TONE/PULSE)available in your area.

IF THE TELEPHONE DOES NOT RING

• Check that the RINGER CONTROL switch is not set to OFF.
• If there are several telephones connected to the same line, try disconnecting some of the other telephones. Having too many telephones connected to the same line can cause low ringer volume or poor sound quality during calls.

CARE AND MAINTENANCE

Avoid rough treatment to the telephone. Do not drop the handset and always place it gently back in the cradle. Clean only with a slightly dampened cloth. Do not use detergent, wax, solvent, spray, alcohol, or excessive water.

FCC Requirements

1. This equipment complies with 47CFRPart 68 and ACTA technical requirements. On the bottom of this equipment is a label that contains, among other information, the registration number and ringer equivalence number (REN) for this equipment. If requested, this information must be provided to the telephone company.
2. The USOC number of the registration jack for the equipment is RJ11C/RJ11W.
3. An FCC-compliant telephone cord and modular plug are provided with this equipment. This equipment is designed to be connected to the telephone network or premises wiring using a compatible modular jack that is TIA/EIA-IS-968 compliant. See Installation Instructions details.
4. The REN is used to determine the quantity of devices that may be connected to the telephone line. Excessive RENs on the telephone line may result in the devices not ringing is response to an incoming call. In most, but not all areas, the sum of RENs should not exceed five (5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company.
5. If this terminal equipment causes harm to the telephone network, the telephone company will notify you in advance that temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customer as soon as possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
6. The telephone company may make changes in its facilities, equipment, operations, or procedures that could affect the operation of the equipment. If this happens the telephone company will provide advance notice for you to make necessary modifications to maintain uninterrupted services.
7. The equipment cannot be used on public coin phone service provided by the telephone company. Connection to party line service is subject to state tariffs.
8. Please follow instructions for repairing if any (e.g. battery replacement section), otherwise do not alternate or repair any parts of the device except specified.
9. This equipment if it uses a telephone handset is hearing aid compatible.
10. If trouble is experienced with this equipment, for repair or warranty information, please contact the service center at the below. If the equipment is causing harm to the telephone network, the telephone company may request that you disconnect the equipment until the problem is resolved.

LIMITED MANUFACTURERS WARRANTY

Crosley Radio, Inc. warrants the product to be free from defects in material and workmanship under normal use for a period of one year from the original date of purchase. This warranty is not transferable. If the product is determined to be defective during the warranty period, the unit will be repaired or replaced at Crosley Radio’s sole discretion.

This warranty covers manufacturing defects and normal consumer use and does NOT cover damage or failure as a result of abuse, accident, alterations, misuse, neglect, abnormal wear and tear, inadequate maintenance, commercial or unreasonable use, damage caused by power surges, mishandling, accident, acts of God or attempted repair by an unauthorized service agent. Also not covered are cosmetic damages, cords, and antennas.

Should this product fail to function satisfactorily, it is best to first return it to the store or retailer where it was originally purchased. If additional service is still needed, the original purchaser must FIRST contact our offices to obtain an RA (Return Authorization) Number.

TO OBTAIN AN RA NUMBER

CALL:

• 1.888.CROSLEY
• (1.888.276.7539)

Send the unit prepaid to the address below in the original packaging (or a reasonable substitute to prevent damage). Clearly mark your RA number on the outside packaging and include the original sales receipt (or a copy) indicating the date of purchase, amount paid, and place of purchase. You must also include your full name, shipping address and daytime contact number. Please include a check or money order in the amount of $19.95, made payable to Crosley Radio, to cover handling and return shipping charges. Returned products will not be shipped to PO Boxes. Crosley Radio will not be responsible for delays or unprocessed claims resulting from a purchaser’s failure to provide any or all of the necessary information.

CROSLEY RADIO

• ATTN: RETURNS DEPT 2001 PRODUCTION DRIVE Louisville, KY 40299
• For additional support: Crosley Radio Consumer Service Department 24 hours a day / 7 days a week
• Telephone: 1.888.CROSLEY (1.888.276.7539)

There are no express warranties except as listed above.

• The purchaser’s bill of sale is the only proof of warranty entitlement.
• This warranty gives the purchaser specified legal rights in addition to any rights which may vary from state to state.
• By the “Moss-Magnuson Warranty Act” of July 10, 1975, this is termed a “limited warranty” which in no way compromises Crosley Radio’s high standards of quality and workmanship.

Frequently Asked Questions

What safety precautions should I follow when using the Crosley CR55 302 Wall Phone?

Follow basic safety precautions to reduce the risk of fire, electric shock, and injury to persons. Read and understand all instructions provided with the phone. Ensure proper ventilation and avoid blocking openings.

What parts are included with the Crosley CR55 302 Wall Phone?

The phone comes with a handset, handset coil cord, telephone body, line cords, screws with wall anchors, rubber spacer pads, and a wall mounting template.

How do I set up the Crosley CR55 302 Wall Phone?

Connect the line cord from the back of the telephone to the wall jack. Adjust the DIAL MODE switch and the RINGER CONTROL switch as needed. Refer to the provided installation instructions for details.

How do I make and answer calls with the Crosley CR55 302 Wall Phone?

Lift the handset to get a dial tone or answer an incoming call. Replace the handset or press the HANDSET CRADLE to hang up. Use the FLASH button for special phone company services like call waiting.

What should I do if I encounter issues with my Crosley CR55 302 Wall Phone?

Check the connections, ensure the DIAL MODE switch is in the correct position, and verify the RINGER CONTROL switch is not set to OFF. If problems persist, refer to the troubleshooting section in the manual or contact customer service.

How should I care for and maintain my Crosley CR55 302 Wall Phone?

Avoid rough treatment, clean with a slightly damp cloth, and do not use detergents or solvents. Always handle the handset gently and ensure it's placed back in the cradle properly after use.

What should I do if I need repair or warranty service for my Crosley CR55 302 Wall Phone?

Contact Crosley Radio's Consumer Service Department to obtain an RA (Return Authorization) Number. Follow the provided instructions for returning the product for repair or replacement under warranty.

Is the Crosley CR55 302 Wall Phone compatible with different types of telephone services?

The CR55 302 Wall Phone is compatible with both tone and pulse dialing systems. Ensure the DIAL MODE switch is set correctly based on the type of service available in your area.

Can I adjust the volume of the ringer and receiver on the Crosley CR55 302 Wall Phone?

Yes, the phone features a RINGER CONTROL switch for turning the ringer ON or OFF, and a RECEIVER VOLUME CONTROL switch for adjusting the volume of the receiver earphone between LOW and HI settings.

What should I do if my Crosley CR55 302 Wall Phone doesn't ring?

Check that the RINGER CONTROL switch is not set to OFF. If multiple phones are connected to the same line, disconnecting some may help improve ringer volume. Additionally, ensure that the phone is set to the correct DIAL MODE for your service and that all connections are secure.

How many devices can I connect to the same telephone line as the Crosley CR55 302 Wall Phone?

The number of devices that can be connected to a line, as determined by the sum of RENs (Ringer Equivalence Numbers), should not exceed five (5.0) in most areas. Contact your local telephone company for specific information regarding the maximum number of devices allowed on your line.

What should I do if I experience trouble with my Crosley CR55 302 Wall Phone?

If you encounter any issues with your phone, including damage, malfunctions, or performance changes, contact Crosley Radio's Consumer Service Department for assistance and possible repair options.

Download The PDF link:Crosley CR55 302 Wall Phone Instruction Manual

Reference:Crosley CR55 302 Wall Phone Instruction Manual- device.report

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>