SINGCALL P829 Wireless Passive Infrared Detector User Manual
- June 17, 2024
- SINGCALL
Table of Contents
User Manual
Wireless passive infrared detector
(for indoor use)
Features
Passive infrared detector applies digital dual-core fuzzy logic nfrared control processmg technology and intelligent analysis algorithm to effectively resolve interference signals and human body movement signals to prevent false alarms. Built-in spiral high-frequency spring antenna has a long transmission distance and is environmentally friendly, safe, rehab le. and easy to install.
Appearance
Working Indicator
LED mdicator flashes once: the detector alarms.
LED indicator flashes once every 3 seconds: An under-voltage
warning: replace the battery as soon as possible
Functions Descnption
Low voltage reminder· When the passive infrared detector’s battery voltage s lower than 2.4V, the mdicator flashes once every 3 seconds and the detector sends a low voltage signal to the plug-in receiver;
When the plug-in receiver receives the signal, it sends the signal to your
mobile phone, reminding you to replace the battery.
Anti -dismantle functun The passive infrared detector comes with an anti-
dismantle button on its back. When the detector is removed, the button will be
triggered, and the instantaneous indicator will flash for 1 second, while an
alarm signal will be transmitted to the plug-in receiver immediately The plug-
in receiver will send the signal to your mobile phone.
Mode Settings
- Turn the switch to the SS/ON position. The detector enters a normal working mode. The interval time of the detector s 5 seconds. The LED lights up, as shown in Figure 1
- Turn the switch to the SM n/OFF position. The detector enters a power saving mode. The interval time at the detector is 5 minutes. The LED does not light up, as shown in Figure 2.
Installation
The detector should not be nstalled close to windows, air conditioners, fluorescent lamps, heaters, refrigerators, stoves, sunlight, etc . where the temperature may rapidly change and where the air flow rate is high. If two detectors are installed within the same detection range. adjust the position to avoid interference with each other and false alarms.
Fix the detector on the mounting bracket and change the detection angle and
distance by adjusting the mounting height or and Justing the detector bracket.
Infrared detector is highly sensitive to lateral movement of people, and
slightly less sensitive to longitudinal movement, so it is best to mount the
detector perpendicular to the persons walking direction.
Test
- After installa1ion rs completed. toggle power ON/OFF switch of the detector to the ON position. and walk (from left to right or from right to left) within the detection indtcations to ensure that the detector works properly.
- When human body motion s detected, the LED flashes once.
- Adjust the detector angte to achieve the best detection range
Detection range
Technical Specifications
Power supply: The detector can use two power supply modes, 1.e. external
adapter or internal battery. They can be used together, while the adapter will
not charge the battery
External adapter: DCSV
Internal battery: 2 “AA” batteries
Standby current <50uA
Operating current: <25MA
Detection range: 4-8 meters/110 degrees
Wireless distance: 100 meters (open space)
Shell material: ABS
Operating hurmdtty- <80%
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>