tuya V-MT Matter Switch Module Instruction Manual

tuya V-MT Matter Switch Module

Wiring Instructions and Diagrams

1. Turn off the power supply before carrying out any electrical installation work.
2. Connect wires according to the wiring diagram.
3. Insert the module into the junction box.
4. Turn on the power supply and follow switch module configuration instructions.
   

Without Switch

TECHNICAL SPECIFICATIONS

with mounting clip

1CH Matter Switch Module

• Single Control
  

• Double Switch
  

INSTALLATION

Warnings:

1. Installation must be carried out by a qualified electrician in accordance with local regulations.
2. Keep the device out of reach of children.
3. Keep the device away from water , damp or hot environment.
4. Install the device away from strong signal sources such as microwave oven that may cause signal interruption resulted to abnormal operation of the device.
5. Obstruction by concrete wall or metallic materials may reduce the effective operation range of the device and should be avoided.
6. Do NOT attempt to disassemble, repair or modify the device.

2 CH Matter Switch Module

• Without Switch
  

• Single Control
  

• Double Switch
  

FAQ

Q1: What should I do if I can’t configure the switch module?

a. Please check whether device is powered on.
b. Make sure your mobile and switch module are under the same 2.4 Ghz WIFI network.
c. Whether it’s in good internet conditions.
d. Make sure the password entered in App is correct. e. Make sure the wiring is correct.

Q2: What device can be connected to this Wi-Fi switch module?

Most of your household electrical appliances can be, such as lamps, laundry machine, coffee maker, etc.

Q3: What happens if the WIFI goes off?

You can still control the device connected the switch module with your traditional switch and once WIFI is active again the device connected to module will connect automatically to your WIFI network.

Q4: What should I do if I change the WIFI network or change the password?

You have to re-connect our Wi-Fi switch module to the new Wi-Fi network accordingly as per the App User Manual.

Q5: How do I reset the device?

press the reset key for about 10 seconds until the indicator light inside the module is flashing quickly for pairing.

3CH Matter Switch Module

• Without Switch
  

• Single Control
  
  

4CH Matter Switch Module

• Without Switch
  

• Single Control
  

• Double Switch
  

Home APP Instruction

Pay attention:

① The mobile phone IOS system version must be 16.0 or later.
② A home hub (such as Home Pod, Home Pod mini, App ble TV, or iPad)must be set up to add the Matter accessory to the home App;
③ The Wi-Fi configured when pairing must be in the LAN with the hub.

Download App

1. Open the APP Store, search the “Home kit” and download the APP.
2. After the download, open the APP and log in using the local iCloud account.

Add device

Be default, the device is in standby mode(the pairing indicator flashes); without the network status, please press the reset key for 5 seconds, and then add the device.
The Device only supports 2.4GHz Wi-Fi signal, need to use the home hub to add.

1. Scan the device QR code to add
   

2. Add via Serial number
   a, The APP automatically searches for the nearby devices, clicks the device icon, and input the serial number to add
   
   b. If no device is found, clicks“ My Accessory Isn’t Shown Here”
   

3. Share device

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>