Dimplex MCF15 Mini Cube Electric Fire Heater Instruction Manual
- June 17, 2024
- Dimplex
Table of Contents
Instruction Manual
MINICUBE
AUS/NZ
MCF15 Mini Cube Electric Fire Heater
IMPORTANT : THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Important Safety Advice
When using electrical appliances, basic precautions should be followed to
reduce the risk of fire, electric shock, and injury to persons, including the
following:
Do not use it there are visible signs of damage, check immediately with the
supplier before installation and operation.
Do not use this appliance in the immediate surroundings of a bath, shower or
swimming pool.
Do not use outdoors.
Do not use this heater if it has been dropped.
This appliance must not be located immediately above or below a fixed socket
outlet or connection box.
WARNING : The appliance carries the Warning Symbol indicating that it must
not be covered or has a Do not cover label. Do not cover or obstruct in any
way the heat outlet grille located underneath the appliance, overheating will
result if the appliance is accidentally covered. Do not place material or
garments on the appliance, or obstruct the air circulation around the
appliance, for instance by curtains or furniture, as this could cause
overheating and a fire risk.
In the event of a fault unplug the heater. Unplug the appliance when not
required for long periods.The supply cord must be placed on the right hand
side of the heater away from the heat outlet underneath the appliance.
This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not play with the
appliance.
Cleaning and user maintenance shall not be made by Children.
The appliance must be positioned so that the plug is accessible.
If the supply cord is damaged it must be replaced by the manufacturer or
service agent or similarly qualified person in order to avoid a hazard.
Use this applaince on a horizontal and stable surface, or fix to the wall, as
applicable.
Although this heater complies with safety standards, we do not recommend its
use on deep pile carpets or on long hair type of rugs.
Warning: Do not use the heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant
supervision is provided.
CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer, or connected to a circuit that is regularly
switched on and off by the utility.
Warning: To reduce the risk of fire, keep textiles,curtains, or other
flammable material a minimum distance of 1m from the air outlet.
CAUTION – Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are
present.
This instruction can be found at
www.dimplex.com.au &
www.dimplex.co.nz
Technical Information
Model No: MCF15, MINICUBE
General
Unpack the heater carefully and retain the packaging for possible future use,
in the event of moving or returning the fire to your supplier.
The fire incorporates a flame effect, which can be used with or without
heating, so that the comforting effect may be enjoyed at any time of the year.
Using the flame effect on its own requires very little electricity.
These models are designed to be free standing and are normally positioned
against a wall.
Before connecting the heater check that the supply voltage is the same as that
stated on the heater.
Please note: Used in an environment where background noise is very low, it may
be possible to hear a sound which is related to the operation of the flame
effect.
This is normal and should not be a cause for concern.
Electrical connection
WARNING – THIS APPLIANCE MUST BE EARTHED.
This heater must be used on an AC ~ supply only and the voltage marked on the
heater must correspond to the supply voltage.
Before switching on, please read the safety warnings and operating
Instructions.
Controls – see Fig. 2
Three switches provide a choice of heat settings. A switch is in the ON
position when the side with the markings on (i.e. I, I, or II) is pushed in.
Switch 1 (I) Controls the electricity supply to the heater and the flame
effect.
Note: This switch must be in the ON (I) position for heater to operate
with or without heat.
Switch 2 (I) Provides 750W heat output
Switch 3 (II) Provides 1500W heat output with switch 2 in the ON positon also.
Thermal Safety Cut-out
The built-in overheat cut-out switches off the appliance automatically in the
event of a fault. Switch off the appliance or disconnect the mains plug from
the socket. After a short cooling down phase, the appliance is ready for use
again. If the fault should occur again, see your local dealer.
WARNING: This heater is not equipped with a device to control the room
temperature. Do not use this heater in small rooms when they are occupied by
persons not capable of leaving the room on their own, unless constant
supervision is provided.
Maintenance
WARNING: ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE ATTEMPTING ANY
MAINTENANCE. Light Emitting Diode
This fire is fitted with LED (Light Emitting Diode) bulbs in place of
traditional incandescent bulbs. These generate the same light levels as
traditional bulbs, but use a fraction of the energy consumed.
Recycling
**** At the end of the electrical product’s useful life it should not be
disposed of with household waste.
Please recycle where facilities exist. Check with your Local Authority or
retailer for recycling advice in your country.
Cleaning
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE
HEATER.
For general cleaning use a soft clean duster – never use abrasive cleaners.
The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT
use proprietary glass cleaners.
To remove any accumulation of dust or fluff the soft brush attachment of a
vacuum cleaner should occasionally be used to clean the outlet grille of the
fan heater.
After Sales Service
Please see the separate Warranty leaflet for details of your Warranty & After
Sales Service including contact details.
Should you require after sales information or assistance with this product,
please contact Glen Dimplex Australia on 1300 556 816 (AUS) / 09 274 8265 (NZ)
or visit our website at www.dimplex.com.au (AUS)
/ www.dimplex.co.nz (NZ).
Glen Dimplex Australia
8 Lakeview Drive,Scoresby,
VIC 3179,
Australia
www.dimplex.com.au
sales@glendimplex.com.au
Ph: 1300 556 816
Glen Dimplex Australasia Ltd.
38 Harris Road,
East Tamaki,
Auckland 2013
New Zealand
www.dimplex.co.nz
sales@glendimplex.co.nz
Ph: +61 9 274 8265
This product is protected by Intellectual property rights and patents owned by
the Glen Dimplex Group on an international basis.
The Glen Dimplex Group of Companies will actively protect these rights.
© Glen Dimplex.
All rights reserved. Material contained in this publication may not be
reproduced in whole or in part, without prior permission in writing from Glen
Dimplex.
References
- Welcome to Dimplex New Zealand | Dimplex
- Welcome to Dimplex Australia | Dimplex
- Manual-Hub.com – Free PDF manuals!
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>