DREMEL 575 Right Angle Attachment Instruction Manual

June 17, 2024
DREMEL

DREMEL 575 Right Angle Attachment

Tools

Right Angle Attachment Instructions

  • Before you begin, remove the black protective cap on your attachment. If cap does not slide off easily, insert the shank portion of any accessory (1/8″ recommended) through the housing opening of the attachment to hold the shaft from rotating. Then twist off.

CAUTION
Do not use the rotary tool shaft lock button. Internal damage to the attachment may occur.

  • Remove the housing cap from your existing rotary tool as shown in fig. 2. Then press the shaft lock button on your rotary tool, unscrew the collet nut and remove the collet.DREMEL-575-Right-Angle-Attachment-FIG-1

  • Install the drive adapter, included with your right-angle attachment, on the motor shaft as shown in Fig. 3 and tighten. Set your collet nut and collet aside it will be reinstalled later in step 4.
    CAUTION
    Do not over-tighten the drive adapter. Tighten the drive adapter finger tight and then tighten an additional 1/3 turn with the wrench. (Wrench included with your rotary tool kit.)

  • Screw the attachment onto your rotary tool. Hand tighten only. Reassemble the collet and the collet nut from step 2, on to the output shaft of the attachment.DREMEL-575-Right-Angle-Attachment-FIG-3

  • The Right Angle Attachment can be oriented on your rotary tool in 12 different positions. The attachment should be positioned so the on/off speed control switch is easy to access. To reposition, unscrew the collar from the attachment until disengaged. Slide the attachment off. Then, reposition, slide the attachment back on the tool and retighten the collar.

  • To change an accessory, insert the shank portion of any accessory (1/8″ recommended) through the housing opening of the attachment to hold the shaft from rotating. With the shaft secured, loosen the collet nut and insert an accessory as deeply as possible to avoid wobble during use.(You may need to pull back the shank from the housing opening to provide clearance while inserting the accessory.) Retighten the collet nut.
    CAUTION
    Do not use the rotary tool shaft lock button. Internal damage to the attachment may occur.DREMEL-575-Right-Angle-Attachment-
FIG-4

Parts

DREMEL-575-Right-Angle-Attachment-FIG-6

4915 21st Street, Racine, WI 53406 1-800-4-DREMEL

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals