DREMEL A576 Sanding Grinding Guide Attachment Instruction Manual

June 17, 2024
DREMEL

Sanding/Grinding Guide Attachment Model A576

A576 Sanding Grinding Guide Attachment

WARNING
Read and understand the manual for the use of the tool with this accessory.
SAVE THESE INSTRUCTIONS

WARNING For use with 1/2” or less sanding and grinding stone accessories only.
Attachment for use with Dremel Rotary Tool Models 100, 200, 300, 400, 4000, 770, 800, 275, 285, 395, 398.
The guide comes completely assembled and ready to use for sanding and grinding applications up to ½” ( 13 mm) thick.
WARNING Router bits are not allowed for use with the Sanding/Grinding Guide attachment.

Sanding/Grinding Guide Attachment Installation instructions:

Step 1: Remove the housing cap A from the end of the tool and set housing cap aside. The original housing cap must be reinstalled when this attachment is not used (Fig. 1).

Step 2 & 3: Loosen the collet nut and place your accessory in and tighten. Note: The attachment is for ½” diameter accessories or smaller.
Please refer to the owner’s manual for proper collet nut assembly instructions and accessory operation instructions.
CAUTION When inserting a bit into your Dremel Rotary Tool be sure that the bit is securely inserted into the collet. Always use the wrench to tighen the collet nut to prevent the bit from loosening within the collet. Do not use the Dremel Chuck.
Step 4: Thread the attachment B onto the threaded portion of the housing collar C (Fig. 2).

Step 5: Adjust the attachment B to the desired depth by loosening the wing knob D (Fig. 3).

Using the Sanding/Grinding Guide Attachment

The guide has a 90 and 45 degree bevel for various sanding applications. The tool with the guide attached can be taken to a secure work piece or can be stationary in the Dremel MultiVise.

Installation instructions to Dremel Multi-Vise:

The tool with the guide attached can be taken to a secure workpiece or can be stationary in the Dremel Multi-Vise 2500-01 (Sold Separately).
Step 1: Set up Dremel Multi-Vise on secure workbench. Place the tool holder into the Dremel Multi-Vise according to Dremel MultiVise instructions.
Step 2: Place tool with accessory secure through the tool holder F (Fig. 4).
Step 3: Hold the Sanding/Grinding Guide B firm and thread onto front end of tool until tightly secure (Fig. 4).

Step 4: The guide can be adjusted from the 90 degree side to the 45 degree side by loosening the wing nut D and sliding the attachment B off the cylinder E (Fig. 5).
Step 5: Turn the attachment B 180 degrees and slide the attachment B onto the cylinder E and tighten wing knob D at desired depth (Fig. 5).

P.O. Box 1468 Racine, Wisconsin 53401
1-800-437-3635
http://www.dremel.com
2610958467 04/09
Printed in Mexico
DM 2610958467 04-09:DM 2610958467 04-09 4/22/09 12:52 PM

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals