ropelux UFO Solar Light User Guide
- June 17, 2024
- ropelux
Table of Contents
ropelux UFO Solar Light
INTRODUCTION
Thank you for purchasing the UFO Solar light，we hope you enjoy our solar lighting solution. To ensure proper operation of this solar light, please read this user manual carefully and keep it for future reference.
SPECIFICATIONS
| Model NO. | XHY – UFO |
|---|---|
| Solar Panel | 6.5V |
| Solar Panel Material | Polycrystalline Silicon |
| Color Temperature | 6000K-6500K |
| Waterproof | IP65 |
| Charging Time | 6-8Hrs |
FEATURES
PRODUCT DETAILS
Remark : Use two AAA batteries, please distinguish + the – poles of the batteries and install them correctly.
INSTALLATION
Installation accessories
Step 1. Install the solar panel
We recommended installing it within 16.4ft from the UFO light and in a
direct sunlight place.
- Make 2 marks on the wall where you want to install, drill holes, and insert the large plastic anchor.
- Mount the solar panel to the wall with large screws. And adjust the best angle of the solar panel to receive sunlight.
Step 2. Install UFO light
- Make 2 marks on the wall where you want to install, drill holes, and insert the small plastic anchor.
- Mount the base to the wall with a small screw.
- Snap the two ends of the light pole into the base and the light body respectively. Fix them with flat tail screws and nuts.
Step 3. Connect Cable Connect and tighten cables of solar panel and UFO light.
5 MODES
Tips
- There is a built-in light sensor, so for Mode 1,2 and 3, the solar light only operates at night.
- Please fully cover the solar panel when testing the light during daytime when at mode 1/2/3.
- Mode 1/2/3 only light up at night, Mode 4 and Auto Mode light up both in day and night.
Mode 1
Stay on as dim light, gets brighter when detects a motion, back on dim light
after 16s.
Mode 2
Auto on when detects a motion, auto off after 16s.
Mode 3
Always on as dim light.
Mode 4
Light sensor is off, for both daytime and nighttime, light will
automatically turn on when detects a motion， auto off after 16s.
AUTO Mode
The light sensor is off, for both daytime and nighttime, Always on and switch
to mode 4 when 50% power left, the next day cycle.
NOTICE
- When using it for the first time, place the product in a sunny place for charging for several hours.
- When the product is not used for a long time, please place the product in a sunny place for charging for 1 day.To maintain the function of the battery,it is better to put it in the sufficient sunlight once a month.
- The charging time and charging efficiency of solar panels may be affected by weather and installation location.
- The product is equipped with an internal battery, please do NOT: 1） Replace it by yourself. 2）Put it with household garbage .3) place it near sources of heat. It should be taken to your local battery disposal center. A full charge requires up to 8 hours of sunlight. Mounting location, weather conditions, and seasonal variation will directly influence the actual run time experienced.
Email : support@ropelux.net Web :
www.ropelux.net
MADE IN CHINA
eVatmaster Consulting GmbH Bettinastr. 30
60325 Frankfurt am Main, Germany
contact@evatmaster.com
EVATOST CONSULTING LTD
Suite 11, First Floor, Moy Road Business Centre, Taffs Well, Cardiff, Wales,
CF15 7QR contact@evatmaster.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>