MD SPORTS SC54805 48 Inch 12 in 1 Multi Game Table Instruction Manual
- June 17, 2024
- MD SPORTS
Table of Contents
ASSEMBLY INSTRUCTIONS
Please contact us before returning the product to the store.
Toll Free: 877-472-4296
MODEL: 54805
LIMITED 90 DAYS WARRANTY
This product is covered by a limited warranty that is effective for 90 days
from the date of purchase. The warranty covers any defects in parts and
workmanship.
This Limited Warranty gives you specific legal rights and you may also have
other rights which very from one state (province) to another.
If, during the limited warranty period, a part is found to be defective or
breaks, we will offer replacement part at no cost to you, the customer. The
only exceptions to the warranty include main frames, tabletops, playing
surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage,
alteration, misuse, abuse, accidental damage or neglect.
Attention: Since you build all tables upside down, please inspect table
tops and playing surfaces right away before putting together.
“PLEASE SAVE THESE INSTRUCTIONS AND PURCHASE RECEIPT!”
A PURCHASE RECEIPT (or other proof of purchase date) will be required before
any warranty service is initiated. All requests for warranty service can be
submitted by email, in writing or by contacting our Consumer service
Department at:
TOLL FREE: 877-472-4296
WEBSITE: www.medalsports.com.tw
Please do not call our 800 NUMBER as well as email us. This will result in duplicate orders and charges will occur.
Please note that all damaged table tops need to be returned to the store.
We do not replace any tabletops or playing surfaces.
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE. THANK YOU VERY
MUCH!
IMPORTANT NOTICE! Please contact us before returning the product to the
store.
Please Keep Your Instructions! Your Model number is necessary should you need
to contact us. Please read through this instruction manual book to familiarize
yourself with all parts and assembly steps. Kindly refer to the parts
identifier below and be sure that all parts have been included.
Although we are dedicated to giving our customers the best product possible, a
question may arise or parts may be missing. If you are missing parts, or, if
you have any questions, please contact our fast and friendly service centre
on: 877-472-4296
TOOLS REQUIRED:
Phillips Screwdriver – Not Included
Standard (Flat Head Screwdriver) – Not Included
Allen Wrench – Included CAUTION !
Electric Screwdrivers may be helpful during assembly; however, please set a
low torque and use extreme caution.
ASSEMBLY TIPS:
- Please read the instructions carefully, and follow all assembly, operation or safety instructions properly in order to avoid damage or injury. For the assembly, at least two adults are required.
- Some figures or drawings may not look exactly like your product. Please read and understand the text before beginning each assembly step.
NOTICE!:
- This product is intended for INDOOR use only.
- Please Do Not sit, climb or lean on the game table.
- Please Do Not drag the table when moving it in order to avoid the damaged on the legs.
- Please only use spray furniture polish to clean the exterior surfaces on the game table.
- This is not a child’s toy, adult supervision is required for children playing this game.
WARNING: Adult Assembly Required.
WARNING:
CHOKING HAZARD – – This item contains small parts or / and small balls Not
suitable for children under 3 years.
54805 PARTS IDENTIFIER
ASSEMBLY INSTRUCTIONS
-
Find a clean, level place to begin the assembly of your Combo Table. The table will be assembled upside down and then turned over on its legs once the assembly completed.
This game table is heavy, and turning it over will require at least two strong adults. -
Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts identifier below. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.
FIG.1 POCKET ASSEMBLY -
Attach the Side Pocket (#21) to the bottom of Billiard Cabinet (#1) using four Screws (#17) per Side Pocket. See FIG.1.
-
Attach the Corner Pocket (#22) to the bottom of Billiard Cabinet (#1) using two Screws (#18) per Corner Pocket. See FIG.1.
-
Repeat the steps above for the other pockets. FIG.2 LEG ASSEMBLY
-
Attach the Plastic Leg Base (#27) to bottom of the Left (#4) and Right(#5) Leg using two Plastic Screws (#14) per Leg Base. See FIG.2.
-
Next, screw the Leg Leveler (#26) into the top of the Leg Base (#27). See FIG.2. FIG.3 BILLIARD TABLE ASSEMBLY
-
Attach two previously-assembled Legs (#4 and #5) to the end of Billiard Cabinet(#1) using four Bolts (#8) per Leg. See FIG.3.
-
Attach the other two previously-assembled Legs (#4 and #5) to the other end of Billiard Cabinet(#1) but using only two Bolts (#8) on the sides of each Leg. See FIG.3.
Note: Please do not use any screws on the holes in the end apron of Billiard at this step.
The bolts will be added later for the crooked Pole (#19). See FIG.5A -
Attach the Leg Side Panel (#6) between the inside of Left and Right Legs using four Screws (#18) per Leg Side Panel. See FIG.3.
-
Lift the table assembly from the floor with two strong adults, turn it over, and set table on its legs in the location where you play. Go back and make sure that all connections are tight.
FIG.4 BASKET OF BILLIARD TABLE ASSEMBLY -
Attach the Corner Basket (#23) and Side Basket (#24) to Billiard Cabinet (#1) using two Screws (#15) per Basket. See FIG.4
Note: Repeat the steps above for the other baskets.
CAUTION: Two strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground.
FIG.5 BASKETBALL ASSEMBLY -
Attach the Crooked Pole (#19) to the end of Billiard Table using two Butterfly Bolts (#11) per Crooked Pole. See FIG.5A.
Note: The butterfly Bolts (#11) assembled on the holes in the end apron of Billiard.
See point 9 on page 5. -
Attach the Rim (#30) to the Basketball Board (#7) using four Bolts (#10) and four Nuts (#13).
See FIG. 5B. -
Attach the Short Pole (#20) to the back of the Basketball Board (#7) using four Bolts (#9) and four Nuts (#12). And then install the Rod Cap (#28) on the top of the Short Pole (#20).
See FIG.5C. -
Attach the previously-assembled Basketball Board (#7) to the Crooked Pole (#19) using two Screws (#16) per side.
See FIG.5D. -
Attach the Basketball Net (#29) to the Rim (#30) by slipping the top of the Net over the Rim hooks.
See FIG.5E. -
Attach the Basketball Return Net (#31) to the Short Pole (#20) using the Velcro strips. Secure the bottom of it to the Billiard Table using two Rivet Plugs (#25).
See FIG.5F FIG.6 PUSHER ASSEMBLY -
Tear off the backside paper of the Felt Pad (#34) and stick them at the bottom of the Pushers (#33).
DIRECTIONS FOR PLAYING VARIOUS GAMES
- Billiard – Play the game as assembled using the Cue (#39), Triangle (#38), Pool Balls (#37) and Chalk (#36).
- Glide Hockey – Place the Hockey Table with Ta ble Tennis (#2) on the top of the Billiard Cabinet to play Glide Hockey using the Pusher (#33) an d Puck (#35).
- Table Tennis – Reverse side of the Hockey Table with Table Tennis (#2) and install the Net (#40) and Post (#56). Use the Table Tennis Paddles (# 42) and Table Tennis Balls (#41).
- Bowling – Place the Backgammon with Bowling Board (#3) in the center of the Hockey Table with Table Tennis and use the Bowling Pin (#43) and Bowling (#44).
- Chess.
- Checker.
- Backgammon – Reverse side of the Backgammon with Bowling Board (#3) to play these games use the Chess Set(#49), Ba ckgammon/Checker Set (#50), Dice Box (#51) and Dice (#52).
- Basketball – Attach the Basketball system and use the Basketball (#53).
- Bean Bag Toss – Throw Bean Bags (#46) against the pre-attached Target on the Basketball Return Net (#31).
- Baseball Toss – Play Baseball (#47) into the lar ge opening on the Basketball Return Net.
- Football – Throw Football (#48) against the pre attached Target on the Basketball Return Net (#31).
- Tic–Tac–Toe – Play on the Tic-Tac-Toe(#45).
- Stick Hockey – Place the Hockey Table with Table Tennis (#2) on the top of the Billiard Cabinet to play Stick Hockey using the Hockey Stick (#55) and Puck (#35).
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>