MD SPORTS DH18409 Nero Air Powered Hockey Table Instruction Manual
- June 17, 2024
- MD SPORTS
Table of Contents
ASSEMBLY INSTRUCTIONS
Please contact us before returning the product to the store.
Toll Free: 877-472-4296
MODEL: DH18409
LIMITED 90 DAYS WARRANTY
This product is covered by a limited warranty that is effective for 90 days
from the date of purchase. The warranty covers any defects in parts and
workmanship.
This Limited Warranty gives you specific legal rights and you may also have
other rights which very from one state (province) to another.
If, during the limited warranty period, a part is found to be defective or
breaks, we will offer replacement part at no cost to you, the customer. The
only exceptions to the warranty include main frames, tabletops, playing
surfaces, batteries or tools.
The above warranty will not apply in cases of damages due to improper usage,
alteration, misuse, abuse, accidental damage or neglect.
Attention: Since you build all tables upside down, please inspect table
tops and playing surfaces right away before putting together.
“PLEASE SAVE THESE INSTRUCTIONS AND PURCHASE RECEIPT!”
A PURCHASE RECEIPT (or other proof of purchase date) will be required before
any warranty service is initiated. All requests for warranty service can be
submitted by email, in writing or by contacting our Consumer service
Department at:
TOLL FREE: 877-472-4296
WEBSITE: www.medalsports.com.tw
Please do not call our 800 NUMBER as well as email us. This will result in duplicate orders and charges will occur.
Please note that all damaged table tops need to be returned to the store.
We do not replace any tabletops or playing surfaces.
PLEASE CONTACT US BEFORE RETURNING THE PRODUCT TO THE STORE. THANK YOU VERY
MUCH!
IMPORTANT NOTICE! Please contact us before returning the product to the
store.
Please Keep Your Instructions! Your Model number is necessary should you need
to contact us.
Please read through this instruction manual book to familiarize yourself with
all parts and assembly steps. Kindly refer to the parts list below and be sure
that all parts have been included.
Although we are dedicated to giving our customers the best product possible, a
question may arise or parts may be missing. If you are missing parts, or, if
you have any questions, please contact our fast and friendly service centre
on: 877-472-4296
TOOLS REQUIRED:
Phillips Screwdriver – Not Included
Standard (Flat Head Screwdriver) – Not Included
Allen Wrench – Included CAUTION !
Electric Screwdrivers may be helpful during assembly; however, please set a
low torquand use extreme caution.
ASSEMBLY TIPS:
- Please read the instructions carefully, and follow all assembly, operation or safety instructions properly in order to avoid damage or injury. For the assembly, at least two adults are required.
- Some figures or drawings may not look exactly like your product. Please read and understand the text before beginning each assembly step.
NOTICE:
- This product is intended for INDOOR use only.
- Please Do Not sit, climb or lean on the game table.
- Please Do Not drag the table when moving it in order to avoid the damaged on the legs.
- Please only use spray furniture polish to clean the exterior surfaces on the game table.
- This is not a child’s toy, adult supervision is required for children playing this game.
WARNING: Adult Assembly Required.
WARNING: CHOKING HAZARD – – This item contains small parts or / and
small balls Not suitable for children under 3 years.
DH18409 PARTS LIST
WARNING:
- Require 4pcs AA Batteries (Not included).
- Do not mix old and new batteries.
- Do not mix alkaline, standard (carbon zinc), or rechangeable (nickel-cadmium) batteries.
ASSEMBLY INSTRUCTIONS
-
Find a clean, level place to begin the assembly of your Air Hockey table. The table will be assembled upside down and then turned over on its legs once the assembly completed. This game table is heavy, and tuning it over will require at least four strong dults.
-
Remove all the parts from the box and verify that you have all of the listed parts as shown on the parts list. Carefully cut or tear the four corners of the box so that the bottom of the box can be used as your work surface.
FIG.1 -
Attach the Leg End Panel – A (#5) between the Right Leg (#2) and Left Leg (#3) using eight Screws (#8) per Panel.
-
Screw the Leg Levelers (#7) into the bottom of each Leg.FIG.2
-
Attach the Leg End Panel – B (#6) to the Legs using four Bolts (#9) per Panel.FIG.3
-
Attach the Leg Side Panel (#4) to the Legs using four Bolts (#10) per Panel as shown in FIG.3.FIG.4
-
Attach the pre – assembled Legs/Leg panels to the Main Cabinet (#1) using eight Bolts (#11).FIG.5
-
Lift the table assembly from the floor with four strong adults, turn it over, and set table on its legs in the location where you play. Go back and make sure that all connections are tight.
CAUTION: Four strong adults are recommended to turn the table over as shown.
1. Lift the table off the ground.
2. Turn the table over.
3. Place it on all four feet at the same time on the ground. -
Tear off the backside paper of the Felt Pad (#13) and stick them at the bottom of the Pushers (#12).
-
Plug the Adaptor (#16) to the Control Box (#18).
Electronic Connections Diagram
YOU ARE NOW READY TO PLAY!
ELECTRONIC SCORER OPERATION
- Plug in the power cord and switch power to “ON”. “Time” board will show “15:00” accompaning with sound “fifteen minutes” after music stops.
- Press the button “MINUTES” to set up playing time.
- Press “START/RESET” to begin game play and music is accompanied. “Time” start to countdown when music stops.
- When the “HOME” player scores, “HOME” indicator will show 1 point.
- When the “VISITOR” player scores, “VISITOR” indicator will show 1 point.
- Score only counts when goal made after cheering sound is finished.
- In game play, press “MINUTES” is invalid.
- In game play, press “START/RESET” will set scorer to zero and timer back to the beginning status.
- The scorer will turn off automatically when it is not used for 5 minutes.
- Press “MINUTES” or ” START/RESET” to turn on the scorer.
This device complies with the part 15 of the FCC rules. Operation is subject to the following two conditions :
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
Inlay Electronic Scorer Trouble Shooting Guides
NO | Conditions | Trouble Shooting | Solvent |
---|---|---|---|
A | No sound on Control Box and no numbers displayed on Scorers | 1. Pls check | |
the “power switch of Battery Box” if it is turned on. | Turn on the power |
switch of Battery Box.
2. Pls check the “power switch of Control Box” if it is turned on.| Turn on
the power switch of Control Box.
3. Pls check the “battery box wire” if it is plugged into the Control Box and
connected well.| Plug or Re-plug the battery box wire into the Control Box.
Pls check if batteries are installed in the Battery Box.
Result: If it’s failed as above 3 steps, and then…| Replace a new Control Box
and Battery Box.
B| No sound on Control Box| 1. Pls check the button-“SOUND ON /OFF” on the
Control Box if it is turned on.| Re-press the button-“SOUND ON /OFF” on the
Control Box.
If this fails to resolve the problem,| Replace a new Control Box.
C| No numbers displayed on Timer/Scorers| 1. Pls check the “Time Display Wire
and Scorer Display Wire” if both are plugged into the Control Box well.| Re-
plug the Time Display Wire and Scorer Display Wire into the Control Box.
2. No numbers displayed on “Timer” but on 1 or 2 pcs Scorers.| Interchange
the Time Display Wire and Scorer Display Wire, and plug into the Control Box,
it will come out the conditions as following a/b:
a) If numbers are displayed: Replace a new Time Display and Time Display Wire.
b) If no numbers on Timer: Replace a new Control Box.
3. No numbers displayed on “1 pc Scorer” but on Timer and 1 pc Scorer.|
Interchange both of two Scorer Display Wires and plug into the Control Box:
a) If numbers are displayed: Replace a new Scorer Display Wire.
b) If no numbers on Scorer: Replace a new Control Box.
4. No numbers displayed on “2 pcs Scorers” but on Timer.| Interchange the
Time Display Wire and Scorer Display Wire, and plug into the Control Box.
a) If numbers are displayed: Replace new Scorer Display and Scorer Display
Wire.b) If no numbers on Scorers: Replace a new Control Box.
D| Incomplete Numbers displayed on Scorers/Timer| 1. Pls check if the “Time
Display Wire” and “Scorer Display Wire” are connected well into the Control
Box.| Replug the Time Display Wire and Scorer Display Wire and connect them to
the Control Box.
2. Incomplete numbers on “1pc Scorer” only.| Take out both of Scorer Display
and interchange to re-install:
a) If numbers are displayed: Replace a new Scorer Display Wire.
b) If it still is not working: Replace a new Scorer Display and Scorer Display
Wire.
3. Incomplete numbesr on “2pcs Scorers” with the same character or different
numbers.| Replace new Scorer Displays, Scorer Display Wire and Control Box.
4. Incomplete numbers on Timer only.| Replace a new Time Display and Time
Display Wire .
5. Incomplete numbers on all of the Scorer Displays and Time Display with the
same character .| Replace a new Control Box.
6. Incompete numbers on “2pcs Scorer Display & Time Display”. As same as the
image below-| Please re-check the Scorer
Display Wire and Time Display Wire if they are plugged in the correct socket
on the Control box.
E| No counting on Scorers| 1. Pls check the button-“START” on the Control Box
if it is turned on.| Re-press the button-“START” on the Control Box.
2. Pls check the “Puck Catcher Wire with Sensor-1 & 2” if both are connected
with the Control Box well.| Re-plug the Puck Catcher Wire with Sensor-1 & 2 on
the Control Box and connected well.
3. “1 pc Scorer”: Failed to keep the score.| Interchange the Puck Catcher
Wire with Sensor-1 & 2, and then plug into the Control Box, it will come out
conditions as following a/b:
a) If scorer keep score: Replace a new Puck Catcher Wire with Sensor.
b) If it’s unworkable: Replace a new Control Box.
4. “2 pcs Scorers”: Failed to keep the score.| Replace a new Control Box.
F| Unworkable button on the Control Box| Pls check the “Electronic Scorer
Operation Guides” on the Assembly Instruction.| Refer to the Electronic Scorer
Operation Guides and re-operate. If still, inoperable, please replace a new
Control Box.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>