MAYTAG MVWC360A Top Loading Automatic Washer Instruction Manual
- June 17, 2024
- Maytag
Table of Contents
Top-Loading Automatic Washer
PRODUCT MODEL NUMBERS
MVWC200X, MVWC400X, MVWC450X, MVWX500X, MVWX600X, MVWX700X, MVWC300X,
MVWX550X, MVWC350A, MVWC360A, MVWC200B, MVWC300B, MVWC425B, MVWC215E,
MVWC415E, MVWP475E, MVWC416F
Washer dimensions
Recessed area or closet
installation
Dimensions show recommended spacing
allowed, except for closet door ventilation openings which are minimum
required. This washer has been tested for installation with spacing of 0″ (0
mm) clearance on the sides. Consider allowing more space for ease of
installation and servicing, and spacing for companion appliances and
clearances for walls, doors, and floor moldings. Add spacing of 1″ (25 mm) on
all sides of washer to reduce noise transfer. If a closet door or louvered
door is installed, top and bottom air openings in door are required.
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.
DRAIN SYSTEM
Drain system can be installed using a floor drain, wall standpipe, floor
standpipe, or laundry tub. Select method you need.
Floor standpipe drain system
Minimum diameter for a
standpipe drain: 2″ (51 mm). Minimum carry-away capacity: 17 gal. (64 L) per
minute. Top of standpipe must be at least 39″ (990 mm) high; install no higher
than 96″ (2.44 m) from bottom of washer. If you must install higher than 96″
(2.44 m), you will need a sump pump system.
Wall standpipe drain system Floor drain system Floor drain system
requires a Siphon Break Kit (Part Number 285834), 2 Connector Kits (Part
Number 285835), and an Extension Drain Hose (Part Number 285863) that may be
purchased separately. To order, please see toll-free phone numbers in your Use
and Care Guide. Minimum siphon break: 28″ (710 mm) from bottom of washer.
(Additional hoses may be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of
laundry tub must be at least 39″ (990 mm) above floor; install no higher than
96″ (2.44 m) from bottom of washer.
IMPORTANT: To avoid siphoning, no more than 4.5″ (114 mm) of drain hose should be inside standpipe or below the top of wash tub. Secure drain hose with cable tie.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
W10240509D
05/2015
https://manual-hub.com/
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>