Whisker Litter-Robot 4 Camera Mount Kit Installation Guide
- June 17, 2024
- whisker
Table of Contents
Whisker Litter-Robot 4 Camera Mount Kit Installation Guide
Installing the Litter-Robot 4 Camera Mount
Litter-Robot 4 can be equipped with a webcam to further monitor cats’ usage habits. Install your webcam of choice using our camera mount kit. What’s included: (1) bracket, (1) hinge, (1) ring magnet, (1) 1/4″-20 nylon screw, (1) wire cover
While facing your Litter-Robot 4, hook the comara mount bracket banind the bezet as shown
Snap the front of the bracket forward to secure it onto the bezel. (You will hear a snap.) NOTE: Ensure the bracket is positioned above (not obstructing the lasers) and is centered on the bezel.
Mount the hinge by carefully snapping it onto the bracket. (This may require some force or twisting.)
You have two options for mounting your camera: 1) Use the included ring magnet: Add the magnet to the washer that is attached to the hinge, and check polarity with the magnet that comes with your camera- the magnets should stick together, not repel. 2) Use the included 1/4″-20 nylon screw.
Mount your camera to the hinge and plug it into the USB port behind the control panel. NOTE: The camera mount has many different configurations. Now would be a good time to check your desired camera angle. You can adjust the angle by flipping the hinge, flipping the side the magnet is on, or flipping the camera. Be careful not to pinch your fingers!
Route the camera wire through the channel and arrange any excess wire Into a small, clean bundle as shown.
Place the bundle of wire in the wire cover pocket and route the wire attached to the camera end through the slot. NOTE: Keep the bundle of wire as low as possible in the wire cover pocket to avold Interference with the bezel.
While keeping the wire in the wire cover pocket, snap the wire cover onto the bracket using the slots provided. (Be careful not to dislodge the bracket from the bezel at this step.) NOTE: Ensure the wire cover sits cleanly on the bezel. If It does not, the wire may come loose from the wire cover pocket and Interfere with the bezel.
Setup complete! You are now ready to watch your kittles use Litter-Robot 4.
Questions? Visit whiskersupport.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>