SCOTT 2024 RANSOM Bicycle User Manual
- June 17, 2024
- SCOTT
Table of Contents
2024 SCOTT
RANSOM MANUAL
THE RANSOM SHOULD BE ADJUSTED EXACTLY TO THE RIDER FOR MAXIMUM SAFETY AND
RIDEABILITY.
Please contact your authorized SCOTT dealer for advice in order to avoid
technical problems or any harm.
LEGEND
| TORQUE REQUIRED| | GREASE REQUIRED
---|---|---|---
| TASK DIFFICULTY| | NO GREASE
| TORX TOOL SIZE| | CARBON GREASE
| HEX TOOL SIZE| | THREADLOC REQUERIDA
| TORQUE AMOUNT| | BEARING FIT REQUERIDA
GEOMETRY & TECHNICAL DATA
| SEATPOST | mm | 31.6 |
|---|---|---|
| SEATPOST CLAMP | mm | 34.9 |
| TRAVEL | mm | 170 Rr 170 Fr |
| SHOCK LENGTH | mm | 205 |
| SHOCK STROKE | mm | 65 |
| HARDWARE M.FRAME | mm | Trunnion |
| HARDWARE LINKAGE | mm | 8 x 20 |
| MAX TYRE WIDTH | in | 2.5 |
| CHAINLINE | mm | 55 |
| MAX CHAINRING | Tooth | 34 |
| MAX ROTOR | mm | 203 Rr 203 Fr (200m Direct) |
| 2024 RANSOM | SM | |
| --- | --- | --- |
| A | Head tube angle | ° |
| B | Head tube length | mm |
| C | Top tube horizontal | mm |
| D | standover height | mm |
| E | BB offset | mm |
| F | BB height | mm |
| G | Wheelbase | mm |
| I | BB center to TST | mm |
| J | Seat angle | ° |
| K | Chainstay | mm |
| L | Reach | mm |
| M | Stack | mm |
| Fork Length | mm | 581 |
| Trail | mm | 135.5 |
RANSOM
Please observe the maximum seatpost insertion so not to damage the frame.
Small: 184 mm Max Insertion
Medium: 214 mm Max Insertion
Large: 244 mm Max Insertion
XL: 273 mm Max insertion
Please note on small sized frames it si only possible to use a 500ml water bottle, with a side entry cage. ****
COMPATIBLE SHOCK OPTIONS:
⚠ Always check there is enough
clearance before riding.
FOX: Float X/Float X2/DHX/DHX 2
ROCKSHOX: Superdeluxe Air
OHLINS: TTX22 Coil / TTX2 Air
Marzocchi: Bomber Air + Coil
HEADSET ADJUSTMENT
It is important to install the headset correctly depending on the set up
required. There are two types of headset cups.
0° & 0.6° ( 64° & 65°) These can be indentified from the stamp on the inner
surface of the headset cup.
The headset is available in two options:
288251 SYN HEADSET ZS56/28.6-ZS56/40 MTB 290060 SCO HEADSET CUP KIT SPARK 22
Do not use a standard headset tool to remove these plastic headset cups.
Slacker
Steeper
SETTING SAG
-
Put the Tracloc lever in the OPEN position.
Wear your normal riding gear, set the sage meter to zero. -
Gently sit on the bike allowing the sag meter to move. Once completed dismount the bike gently. Check the value.
If the sag value is not to your liking within the sag range indicated, access the shock by removing the cover and adjusting the pressure as indicated.
TRACLOC ONLY
| BOLD TRACLOC LINKIN 22 | P/N: 291219 |
|---|---|
| SCO TWINLOC ADAPTER OFFSET 23 | P/N: 421286 |
| SCO TWINLOC ADAPTER INLINE 23 | P/N: 421287 |
| SCO TWINLOC BAR CLAMP 22 | P/N: 292621 |
LINKAGE BEARINGS
| LOWER LINKAGE / CHAINSTAY | 61802 |
|---|---|
| LINKAGE / SEAT TUBE | 61802 |
| LINKAGE / SEATSTAY | 61802 |
| SEATSTAY / CHAINSTAY | 61802 |
| BOTTOM BRACKET | 61810 |
| TIE LINKS (TOP AND BOTTOM) | 61810 |
FLIP CHIP
CABLE ROUTING
GENERAL SPARE PARTS
421611 SCO SAG INDICATOR RANSOM 24
421610 SCO Link Tie Ransom 24
421589 SCO LINK LOWER OUTER LINK RANSOM 24
421612 SCO SWINGARM REP KIT RANSOM 24
421623 SCO M/P COVER RANSOM 24
421621 SCO CABLE/SHOCK DT COVER RANSOM 24
421624 SCO CABLEGUIDE SET RANSOM 24
286000 SCO DROPOUT SRAM UDH 21
Reverse Thread
296609 SCO AXLE RWS REAR 148X12 GENSCAL PLUG 23
297522 SCO STEM SPACER/TOP CAP GENIUS 23
421622 SCO CHAINGUIDE RANSOM 24
297086 SCO STEM ACCESSORY COVER COMBO 22
421614 SCO DT INTERNAL STORAGE SLEEVE RANSOM 24 420546 SCO DT TOOL BAG RANSOM 24
414155 SCO LINK LOWER INNER RANSOM 24
414151 SCO LINK UPPER RANSOM 900 RC 24
414152 SCO LINK UPPER RANSOM 910 24
414153 SCO LINK UPPER RANSOM 920 24
414154 SCO LINK UPPER RANSOM 930 24
414165 SCO LINK UPPER CONTESSA RANSOM 910 24
MANUFACTURER’S GUARANTEE
When purchasing a new SCOTT bicycle from an authorized SCOTT dealer, SCOTT
grants a manufacturer’s guarantee subject to the following provisions.
CONDITIONS
The manufacturer’s guarantee is only granted to the first-time buyer of a
SCOTT bicycle who has purchased it from an authorized SCOTT dealer. The
manufacturer’s guarantee only applies if the bicycle is registered to the
first buyer at www.scott-sports.com within ten days of purchase.
DURATION
The manufacturer’s guarantee is granted from the date of purchase for a period
of five years on bicycle frames and rear ends. The guarantee period is reduced
to three years, if the SCOTT bicycle is not serviced at least once a year by
an authorized SCOTT dealer. Maintenance services must be carried out in
accordance with the maintenance instructions in the SCOTT manual and must be
confirmed there by the stamp and signature of the authorized SCOTT dealer.
For frames and rear ends of Category 5 bicycle models and for rigid forks
manufactured by SCOTT, the duration of the manufacturer’s guarantee is limited
to two years.
If a defect on the SCOTT bicycle is remedied within the scope of a
manufacturer’s guarantee or a warranty claim, the duration of the
manufacturer’s guarantee is not extended. The manufacturer’s guarantee ends,
when the first-time buyer transfers ownership of the SCOTT bicycle to a third
person.
ASSERTION
The manufacturer’s guarantee is provided by SCOTT Sports SA, Route du Crochet
11, 1762 Givisiez, Switzerland. The buyer must inspect the SCOTT bicycle
immediately after purchase and notify his authorized SCOTT dealer at once in
writing of any obvious defects. Hidden defects must be reported immediately
after their discovery. In the event of a guarantee claim, the SCOTT bicycle
must be handed over to an authorized SCOTT dealer. The latter will contact
SCOTT to remedy the defect. The assertion of a guarantee claim always
requires the presentation of the original proof of purchase as well as the
proof of maintenance service in the SCOTT manual.
Performance of SCOTT in the event of a guarantee claim
In the event of a guarantee claim, SCOTT will, at its own discretion, repair
the defect or replace the defective product with a product of similar quality,
whereby colour and model deviations are possible. If a repair or replacement
is not possible, a purchase price refund will be made taking into account
previous use. SCOTT is entitled to commission third parties to remedy the
defect.
LIMITATIONS
The manufacturer’s guarantee applies exclusively to frames, swingarms and
rigid forks of SCOTT bicycles. Bicycle components are excluded from this
manufacturer’s guarantee.
The manufacturer’s guarantee does not apply to normal wear and tear, damage
caused by accidents or other excessive force on the SCOTT bicycle, corrosion,
improper maintenance, incorrect assembly and assembly of unsuitable components
or accessories as well as cosmetic defects, for example in the varnish.
The manufacturer’s guarantee does not apply to SCOTT bicycles that have been
used in a rental shop.
MISCELLANEOUS
These manufacturer’s guarantee provisions apply to all SCOTT bicycles as of
model year 2023.
Statutory warranty rights of the buyer and guarantees of component
manufacturers (Shimano, SRAM etc.) remain unaffected by this manufacturer’s
guarantee. The place of jurisdiction for all disputes in connection with this
manufacturer’s guarantee is Freiburg, Switzerland. This manufacturer’s
guarantee BIKE WARRANTY PERIODS SCOTT Bikes Gambler, Voltage FR, Volt-X is
subject to Swiss law to the exclusion of all Regular Warranty Period
legislation that refers to foreign law.
All rights reserved
© 2023 SCOTT Sports SA
Distribution:
SSG (Europe) Distribution Center SA
P.E.D. Zone Cl
Rue du Kiell 60
6790 Aubange
Belgium
SCOTT Sports SA
Route du Crochet 11
1762 Givisiez
Switzerland
webmaster.marketing@scott-sports.com
www.scott-sports.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>