EPSOLAR EPHC10-EC Solar Charge Controller Instruction Manual

Table of Contents

EPSOLAR EPHC10-EC Solar Charge Controller

EPSOLAR EPHC10-EC Solar Charge Controller

Note : carefully check before making each connection to be certain the polarity is correct

Green ON when solar is charging battery. Green blink when the system over voltage.
Green ON when battery level in the right range. Green slowly flashing when battery level full. Yellow ON when battery level low. Red ON when loads cut of.
Red slowly flashing when it’s over load (The load amps is 1.25 times of rated current for 60 seconds, or the load amps is 1.5 times of rated current for 5 seconds) Red fast flashing when the load is short-circuit.
Red ON when the switch is ON. Red OFF when the switch is OFF. The default status is ON.

The output will be cut off once there is over load or short circuit.
While short circuit occurs, the controller will have 4 automatic loads reconnect attempts. There will be 10s between the first three attempts and 20s between the 3rd and 4th attempts. For the fifth short circuit, the load can be only reconnected after 24hours.Anytime, please check the load and press the switch to reset the controller immediately.
While the over load occurs within 20s, press the switch and the load will be reconnected after 10s.
While the over load occurs over 20s, press the switch and the load will be reconnected immediately.
After over discharged, the load will be reconnected automatically when the battery is charged to 13.1V. (For 12V system only, for 24V, it is 26.2V) After over discharged, the load will be reconnected while you press the power switch. Please note the battery voltage needs to be over 12.5V. (For 12V system only, for 24V, it is 25V. )

EPHC10-EC 170W or 10 A for Solar and Load
NOTES : For use with solar panels only

Equalization voltage (60 minutes) 14.8 V
Boost voltage (60 minutes) 14.4 V
Float Voltage 13.7V
Low voltage Disconnect 11.1 V
Low voltage Reconnect 13.1 V
Note: all is for 12V system only, use 2x for 24 V system
Microcontroller digital accuracy
Type of Charging Series PWM Temperature compensation charging
Electronic protections: Short circuit and over current- load |Reverse polarity- battery |Reverse current at night |Limits high voltage to protect loads |Lightning protection
Topicalization Conformal coated printed circuit board
Terminals For wire sizes to 2.5mm²
Weights 250g
Dimension 140*89mm
Self-consumption 6mA maximum
Temperature -35℃to +55℃
Enclosure IP30
Warranty 1 year
Compliance CE