oraimo OHP-610 BoomPop 2 Wireless Headphones User Manual

OHP-610 BoomPop 2 Wireless Headphones
User Manual

PACKAGE CONTENTS

PRODUCT OVERVIEW

1. Button + (Volume Up / Next Track)
2. Button O (Play/Pause/Call)
3. Button – (Volume Down / Last Track)
4. Power Switch
5. LED Indicator
6. 3.5mm AUX Input
7. Microphone
8. Type-C Charging Port

USING YOUR HEADSET

1. Turn on / off
   Toggle the power switch to power on/off.LED Indicator| Status
   ---|---
   | Steady blue for 1 second with voice prompt saying “power on”| Power on
   | Steady red for 2 seconds with voice prompt saying “power off”| Power off
2. Pair with your device
   When power on, the Headset will enter pairing mode automatically. Open the Bluetooth function and connect the Bluetooth named as BoomPop 2 on your device to finish the pair.

3. How to connect to another device

1. Disconnect the Bluetooth connection with the last device:
   a. Disconnect directly from your device.
   b. Or press the button + and button – simultaneously for 3 seconds.
2. Enter the pairing mode to achieve the connection again.
   Make sure the distance of the headphone and your device is less than 1 meter / 3.3 feet at the first time of connection.
   The headphone will automatically connect to the last connected device if available. If not, the headphone will enter pairing mode.

4. Connected via AUXThe speaker will enter AUX mode once the cable is plugged in.
   (Mic will be banned when using AUX mode)
   + Microphone will be enabled in AUX mode

5. Controls
   Play/Pause music: Short press the button O once.
   Volume up/down: Short press the button + / button – once.
   Next track/Last track: Long press the button + / button – for 1 second.
   Answer/End a call: Short press the button O once.
   Reject a call: Long press the button O for 1 second.

6. Three-party calling
   Answer/End a call: Short press the button O once.
   Reject a call: Long press the button O for 1 second.
   After connecting to a third-party call, switch between two calls: Long press the button O for 1 second.

7. Charge your Headset

8. Reset
   Long Press the Button O while the Headset is beir,g charged .| LED Indicator| Status
   ---|---|---
   | Slowly flashing red with voice prompt| Low battery
   | Slowly flashing red| Being recharged
   | Steady blue| Fully recharged

BASIC PRODUCT SPECIFICATIONS

ATTENTION

1. To preserve battery lifespan, fully charge at least once a month
2. Use original or certified cables
3. Do not expose to liquids
4. Do not disassemble
5. Avoid dropping
6. Avoid extreme temperatures
7. Do not use the product outdoors during a thunderstorm
8. Do not use any corrosive cleaner/oil to clean

TROUBLE SHOOTING

the battery.
Toggle the power switch again.
Recharging function fails.| The recharging port is not properly connected.| Reconnect the charging port.
The headphone pairing fails.| cannot be searched or  The headphone does not
enter into the pairing mode.
The Bluetooth function of the device is in error.| Turn on the headphone again to enable it enter into the pairing mode.
Restart the device and the Bluetooth and then pair with the headphone again.

CONSIDERATE HINTS

1. Do not turn up the volume to a fair high level constantly as this could shorten the service life of this product or impair your hearing.
2. When encounter any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage to the product or other components.
3. The wireless transmission range or connectivity could be affected by low battery power. In that case, please recharge immediately.

Wireless Headset
Model: OHP-610
Hereby, ORAIMO TECHNOLOGY LIMITED.
Declares that this Wireless Headset is in compliance with the essential requirements and other relevant provisions of directive 2014/53/EU.
CAUTION

1. Use careful with the earphone maybe excessive sound pressure from earphones and headphones can cause hearing loss.

2. Risk of explosion if battery is replaced by an incorrect type, dispose of used batteries according to the instructions.
   — disposal of a battery into fre or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion.
   — leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
   — a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.

3. The product shall only be connected to a USB interface of version USB Zo. 4

4. EUT Temperature: OC ~ +45 T (Standalone).0C ~+40C (with adapter).

5. To prevent possible hearing damage, do not listen at high volume levels for long periods.

6. USB cable is shielded.

Frequency Range(RF): Max RF output power : BT: 2400-2483, 5MHz (TX/RX); BT(BDR): 2.70dBm —_ BLE: 2.48dBm
High sound preseure vith hearing damage risk.
FCC Warning: Do not fisten at high volume bevels for long periods.
Ghenges of modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate 1e equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection ogainst harmful interforence in residential instellation. This equipment generates uses and can radiate radio frequency energy and, if not installed end used in accordance with the instructions, may couse harmful interference to radio communications. However, there is no guarantee that interference will not occur in a porticuler installation.
If this equipment does cause harmful interference to redio or television reception, which can be determined by tuming the equipment off and on, the user is encouraged to try to correct the interference by one or more af the following measures:
— Reorient or relocate the receiving antenne.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an autlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
The device has been evaluated to meet general RF exposure requirement. The device cen be used in portable exposure condition without restriction.
EU DECLARATION OF CONFORMITY
in accordance with
Annex VI of Directive 2014/53/EU of the European Parliament and of the Council

1. For the following Radio equipment: Model: OHP-4610, Product: Wireless Headset, Trade name or Brand: oraimo Software / Hardwere number: V017/ VO2

2. Name end eddress of the manufacturer or his authorized representative: Manufacturer. ORAIMO TECHNOLOGY UMITED Address: FLAT N 16/F BLOCK B UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT HONGKONG

3. This declaration of conformity is issued under the sole responsibility of the Manufacturer.

4. Object of the declaration (identification of the redio equipment allowing traceability; it may include a colour image of sufficient clarity where necessary for the identification of the radio equipment):

5. The object of the declaration described above is in conformity with the relevant Union harmonization legislation: Directive 2014/53/EU (RED)

6. References to the relevant harmonised standards used or references to the other technical specifications in relation to which conformity is declared:
   Article 3.1a Health: EN 62479:2010
   Article 3.1a Electrical Safety: EN62368-1:2014+A11:2017 EN IEC 62368-1:2020+A11:2020
   Article 3.1b: ETS! EN 301 489-1 V2.2.3 (2019-11) ETSI EN 301 489-17 V3.2.4 (2020-09)
   Article 3.2: ETSI EN 300 328 V2.2.2 (2019-07)

7. Notified Body Name: Eurofins Electrical and Electronic Testing NA, Inc.
   Notified Body Number: 0980, Notified Body Assessment Performed: Module B/C on Article 3.1a, 3.1b, 3.2 Technical File Identification Number: N/A

8. Where applicable, description of accessories and components, including software, which allow the radio equipment to operate es intended and covered by the EU declaration of conformity: User instructions are provided in the User Manual. The Software and Hardware versions are specified above.

9. Additional information:Referring to Article 10.2 of the Directive, this equipment is so constructed that it can be operated in all Member States, without infringing applicable requirements on the use of vodio spectrum. Referring to Article 10.10 of the Direstive, there are no restrictions on putting this equipment into service or of requirements for authorisation of use. Please refer to the User Manual for details.

On behalf of:
Manufacturer: ORAIMO TECHNOLOGY LIMITED
Address: FLAT N 16/F BLOCK 8 UNIVERSAL INDUSTRIAL CENTRE 19-25 SHAN MEI STREET FOTAN NT HONGKONG
fplace and date of issue):Shenzhen, 2023-07-20
name, function): Nengyong.Wu/ Manager
(signature): (Name and signature of person responsible)

CUSTOMER SERVICE

365 DAYS WARRANTY
****Email:service@carlcare.com
India: care@oraimo.com

1. All quality-related defects on items sold directly by oraimo or oraimo’s authorized resellers are covered by an extensive warranty, starting from the date of purchase.
2. oraimo’s limited warranty is restricted to the country of purchase. The limited warranty is void on items taken outside the country they were originally bought in or shipped to directly from an authorized online purchase.
3. This warranty covers only original oraimo products. It is not applicable to normal wear and tear, or any defects arising from damage caused by misuse of this product.
4. Warranty is for the primary product only nor transferable. Any free additional product(s) are not covered in this warranty.
5. If the product fails regardless of usage in compliance with the instruction manual and other written precaution, replacement will be provided free of charge.
6. To receive replacement, bring the warranty certificate and the product itself to the store from where you have purchased the product.

WARRANTY CERTIFICATE

Name:
Address:
Tel. No.:
Date of purchase(dd/mm/yy):
Store name:
Warranty period:

BoomPop 2 | OHP-610 |

• For safety issue, the product remains low capacity during shipping.
  Please fully charge the product before initial use!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>