OPTONICALED 15801 LED Flood Light User Manual
- June 16, 2024
- OptonicaLED
Table of Contents
OPTONICALED 15801 LED Flood Light
LED FLOODLIGHT
Please take time to read this leaflet carefully and retain it for future reference.
DIAGRAM
IMPORTANT SAFETY INFORMATION
- Do not wire this floodlight into the lighting circuit – use a switched fused spur.
- Before installation and servicingm disconnect the electrical supply at the mains.
- Carefully observe all instructions or warnings that are labelled on, or supplied with your product.
- This product is suitable for outdoor use. If in any doubt, consult a qualified electrician.
FIXING INSTRUCTIONS
Do not wire this floodlights into the lighting circuit – use a switched fused spur. This fitting must be earthed, contact a qualified electrician to install a suitable earth facility. Ensure the electricity is turned off at the mains before installing or maintaining any electrical fitting.
NOTE
For new installations, check for any electrical cables or pipe work (gas/water) in the vicinity of the intended mounting point for this product, before proceeding with the installation.
GENERAL INFORMATION
Do not mount ceiling/wall fittings onto damp surfaces such as newly painted or plastered areas as this may cause discolouration of the finish.
Tolls which may be required:
-
Drill
-
Cross Head Screwdriver
-
Small Electrical Slotted Screwdriver
-
Insulation Tape
INSTALLATION
-
Fasten the adjustable bracket with stainless sell screws.
-
Connect the Main Line to the power wire of the lamp.
-
Install the LED Flood light in the ground, wall and ceiling.
This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. (Waste Electrical and Electronics Equipment Directive).
IMPORTER : Prima Group 2004 LTD, Bulgaria, 1784 Soda, Maddest 1, bl. 144, Ground Floor; Phone : +359 2 988 45 72;
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>