AUBIKA Fast Charging Excellence Head Strap User Manual

AUBIKA Fast Charging Excellence Head Strap User Manual

SAFETY INSTRUCTIONS

⚠ AWARNING

Before using this product, please read all the instructions.

• To avoid transferring contagious conditions (like pink eye}, do not share the heat or ell hero’ these accessories with persons with contagious conditions, infections or diseases, particularly of the eyes, skin, or scalp. The headset and accessories hold cleaned be-t111eer e11ch use with skln-1r1endly non-.<1lcohol, non-abreast\le antibacteri•I wipes. Replace the battery-powered Cxoellence Strep if it be-comes worn or annoy be cleaned.
• The head5et and the Fast Charging Excellence Head Strap artwork dose to your $,dn and Sylph. Stop wing the headset if you note?: swelling, itchiness, skin irritation, loss of hair or ochre skin ,-.actions. If $Yml)!Oms persist. contact a doctor.
• Store the product in a goof and dry polao,.
• Do not store the product in high temperatures, high humidity, or dir…:t sunlight.
• Do not leave or dispose of the product In both extremify low air pressure and extreme Hartsuch sunshine, fire. Etc.
• Do not place heavy object on this product.
• Do not throw or droplet.
• Avoid mechanical smocks, oomp~ion, or rutting of die prefect.
• Do not allow the product: ocomefntocontactwitll ankle doff liquid. Do not leave the product out in the rain or near a source of moisture. If the Inside of the botte, ycomes lntoccntactwfth water, chemical decomposition may occur, potentially resulting in the battler catching on flare, and may even lead to an explosion.
• Do not clean the prow<t with harm chemicafsor detrgenl5.

PRODUCT OVERVIEW

1. Right Side Strap
2. Top Strap
3. Battery Cable
4. Cable Clip
5. Left Side Strap
6. Rear Fit Wheel
7. Charging Port
8. Power Button

INSTALLATION NOTES

Step 1 Attach the Rear Brace to the Strap

Clip the rear brace into the strap according to the corresponding R and L letters – you will hear a clear “click” as it attaches.
(Note: the installation of the Rear Brace is one-time, and cannot be removed after installation.)

Step 2 Install the Top Strap

Thread the top strap through The bracket of the rear brace. Smooth side down.

Step 3 Remove the Facial Interface

Remove the facial interface of the Quest 3 headset.

Step 4 Thread and Fasten the Top Strap

Thread the top strap through the bracket on the front of the Quest 3 to fasten it.

Step 5 Attach Side Straps

Hook the side 5′:raps onto the <1rms of the headset by Applying pressure .and pushing down.

Step 6 Install the facial interface

Re-insert the facial interface and snap it into place.

Friendly Note

1. The power button is designed for activating fast charging on Quest 3. To charge the step individually, please press twice to stop charging Quest 3 headset and keep the battery strap charged.
   Due to the protective mechanism of the Ambika Fast Charging Head Strap, when you press the head strap button to charge the powered-off Quest 3 headset, press it again when the orange light on the headset turns on to initiate the charging process.
   The head strap keeps charging the headset when the orange light stays illuminated.

2. To charge the Quest 3 headset and head strap hatter at the same time, make sure to connect the battery cable from the strap to the headset’s USB-C port, and press the power button once after plugging it into the charger.

3. For optimal usage, It’s recommended to keep the strap connected to the Quest3 at all times. Activate the strap during Quest 3 gameplay and deactivate it when not in use.

4. This product does not offer individual accessory sales, including Right/Left Side Straps, Top Straps, and more.

PRODUCT SPECIFICATIONS

FCC Statement

This device complies with Part 15 of the FCC Rule!:. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including intcrfcrcna: that may c.iusc undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Note: This equipment has been tested and Found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment Coll rc1diare1i:1ui<1 frequency energy and, If not installed and used ln accordance with the instructions, may abuse harmful interference to radio communications. However’, there is no guarantee that interference will not occur in a particular installation. If this equipment i:toes cause harmful interference to radio or television receptor, which can be determined by turning the equipmentint and on, the user is encouraged to try to footrest the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/ TV technician for help.

This symbol means the product must not be discarded as household waste, and should be delivered to an appropriate collection facility for recycling. Follow local rules and never dispose of the product and rechargeable batteries with normal household waste. Cortex disposal of old products and rechargeable batteries helps prevent negative cones Quinces for the ~nvir1Jnmentanu human healtl1.

If you have any suggestions you would like to share, please contact our support team: info@aubika.storehttps://aubika.store/

Facebook
Instagram
X.com
YouTube
Pinterest

For more information: aubika.store
Work with us: sponsorships@aubika.store
Dealer authorization: sales@aubikab2b.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>