POWERCOME MWRA37V Remote Control User Manual
- June 16, 2024
- POWERCOME
Table of Contents
POWERCOME MWRA37V Remote Control
Remote control specification
-
Outline structure drawing
-
Key and light display
No| Remote control instructions| Remarks
---|---|---
1| Key LED| Red indicator light|
2| H gear| High gear| 100% heating mode
3| M gear| Middle gear| 66% heating mode
4| L gear| Low gear| 33% heating mode
5| Off| Power switch| -
Instructions for use
-
Pairing method
Press the power button for 10S, LED1 and LED2 blink at 1HZ, press any key of the remote control for pairing within 30S, LED1 and LED2 will be extinguished after pairing, and exit automatically after 30S without pairing； -
When you press H/M/L gear respectively with the remote control button, the corresponding LED gear lights up. 30S, the load is not connected, and the LED light goes out
-
Code clearing method
Press the power button for 10S, LED1 and LED2 perform 1HZ flash mode for 10 times, the code is cleared successfully, and the LED lamp will automatically turn off. -
Transmission distance
Transmission distance between the remote control and the power supply: ≥10 M
FCC Statement
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment. The
device has evaluated to meet general RF exposure requirement. The device can
be used be in portable exposure without restriction.
IC Statement
This device complies with Industry Canada license exempt RSS standard (s).
Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause
undesired operation of the device.
The device has evaluated to meet general RF exposure requirement. The device can be used be in portable exposure without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>