MotoMotion CH13-R Remote Control Instructions
- June 12, 2024
- MotoMotion
Table of Contents
CH13-R Remote Control Instructions
Product Overview
Product Name：Remote Control
Product Model No.：CH13-R
FCC ID: 2BA76CH13MNT007
Environment requirement
Operation temperature: 0℃~ +40℃.
Storage temperature: －10℃~65℃.
Operating Humidity：10%~80%RH，non-condensing.
Storage Humidity：10%~ 85%RH，non-condensing.
Directions for Operation
3.1 Pairing Remote
3.2 ADJUST: The button lift the headlbacklfoot section of the
foundation.
The button lower the head/back/foot section of the foundation.
3.3 ONE TOUCH BUTTON:
One touch flat position.
One touch Select button.Select head or foot zone.
One touch ANTI-SNORE preset position.
One touch TV preset position.
One touch ZERO G preset position. ZERO G adjusts your legs to a higher level
than your heart, helping to relieve pressure of the lower back and promote
circulation.
One touch underneath LED lighting on/off.
3.4 MASSAGE FEATURES：
Turn on the head massage. Cycle through 3 massage intensities.
Turn on the foot massage. Cycle through 3 massage intensities.
Turn off the head/foot massage.
Matters needing attention：
4.1 The function will only work normally in proper working power conditions.
4.2 Remote Control needs three AAA batteries.
4.3 The control box is needed for proper control.
4.4 If problems are identified, they must be treated by professional
personnel.
Additional attention for user：
5.1 This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help.
5.2 This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
5.3 For Intentional and unintentional radiators the manual shall caution the
user and manufacturer that changes or modifications not expressly approved by
the party responsible for compliance could void the users authority to operate
the equipment.