MAYTAG MVWC300B Top Loading Automatic Washer User Manual
- June 16, 2024
- Maytag
Table of Contents
MAYTAG MVWC300B Top Loading Automatic Washer
PRODUCT MODEL NUMBERS
- MVWC200X,
- MVWC400X,
- MVWC450X,
- MVWX500X,
- MVWX600X,
- MVWX700X,
- MVWC300X,
- MVWX550X,
- MVWC350A,
- MVWC360A,
- MVWC200B,
- MVWC300B,
- MVWC425B,
- MVWC215E,
- MVWC415E,
- MVWP475E,
- MVWC416F
Washer Dimensions
Recessed Area Or Closet Installation
Dimensions show recommended spacing allowed, except for closet door
ventilation openings which are minimum required. This washer has been tested
for installation with spacing of 0″ (0 mm) clearance on the sides. Consider
allowing more space for ease of installation and servicing, and spacing for
companion appliances and clearances for walls, doors, and floor moldings.
Add spacing of 1″ (25 mm) on all sides of washer to reduce noise transfer. If
a closet door or louvered door is installed, top and bottom air openings in
door are required.
ELECTRICAL REQUIREMENTS
A 120 volt, 60 Hz., AC only, 15- or 20-amp, fused electrical supply is required. A time-delay fuse or circuit breaker is recommended. It is recommended that a separate circuit serving only this appliance be provided.
DRAIN SYSTEM
Drain system can be installed using a floor drain, wall standpipe, floor standpipe, or laundry tub. Select method you need.
Floor standpipe drain system
Minimum diameter for a standpipe drain: 2″ (51 mm). Minimum carry-away
capacity: 17 gal. (64 L) per minute. Top of standpipe must be at least 39″
(990 mm) high; install no higher than 96″ (2.44 m) from bottom of washer. If
you must install higher than 96″ (2.44 m), you will need a sump pump system.
Wall standpipe drain system
See requirements for floor standpipe drain system.
Floor drain system
Floor drain system requires a Siphon Break Kit (Part Number 285834), 2
Connector Kits (Part Number 285835), and an Extension Drain Hose (Part Number
285863) that may be purchased separately. To order, please see toll-free phone
numbers in your Use and Care Guide. Minimum siphon break: 28″ (710 mm) from
bottom of washer. (Additional hoses may be needed.)
Laundry tub drain system
Minimum capacity: 20 gal. (76 L). Top of laundry tub must be at least 39″ (990
mm) above floor; install no higher than 96″ (2.44 m) from bottom of washer.
IMPORTANT : To avoid siphoning, no more than 4.5″ (114 mm) of drain hose
should be inside standpipe or below the top of wash tub. Secure drain hose
with cable tie.
Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation Instructions packed with product. Specifications subject to change without notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>