LUCCI AIR 72 Inch Atlanta Dc Ceiling Fan User Manual

LUCCI AIR
72”ATLANTA
DC CEILING FAN

72 Inch Atlanta Dc Ceiling Fan

Beacon International Ltd
Hong Kong Head Office: Room 05, 18/F, Kimberland Center, 55 Wing Hong Street, Cheung Sha Wan Kowloon, Hong Kong
Tel +852 34915904 Fax +852 34915917
China showroom / Office: 11/Fl, Guzhen Lighting Building B, Mid Zhongxing Road, Guzhen, Zhongshan, GuangDong, China.
Tel: +86 760 8986 6388 Fax: +86 760 8986 6380
info@beaconinternational.com
www.beaconinternational.com
Beacon Lighting Europe GmbH
Campus Fichtenhain 42, 47807 Krefeld, Germany
TEL +49 (2151) 325 82 39 FAX +49 (2151) 325 70 65
sales@beaconlighting.eu

SAFETY PRECAUTIONS

1. NOTE: Read instructions carefully for safe installation and fan operation.

2. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction  concerning the use of the appliance in a safe way and understand the hazards involved.
   Cleaning and maintenance shall not be undertaken by children without supervision.

3. Children should be supervised to ensure that they do not play with the appliance.

4. An all-pole disconnection switch must be incorporated into the fixed wiring, in accordance with local wiring rules.

5. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
   Contact your local government for information regarding the collection systems available. If electrical appliances are disposed of in landfills or dumps, hazardous substances can leak into the ground water and get into the food chain, damaging your health and well-being.

6. The structure to which the fan is to be mounted must be capable of supporting a weight of 36kg.

7. The fan should be mounted so that the blades are more than 2.3 m above the floor.

8. This fan is suitable for indoor and alfresco areas where the fan is fully undercover with a minimum of 2 walls. This fan is not waterproof. When installed in an alfresco area, the ceiling fan must be positioned in a location protected  from water, wind, dust and salt. Exposure to these elements will void the warranty.
   Mounting the fan in a situation where it is subject to water or moisture is dangerous and may increase the risk of damage, injury or electrical shock.

9. Electrical installation should be performed by a qualified licensed electrician

10. WARNING: If unusual wobbling or oscillating movement is observed, immediately stop using the ceiling fan and contact the manufacturer, its service agent or suitably qualified persons.

11. The replacement of parts of the safety suspension system device shall be performed by the manufacturer, its service agent or suitably qualified persons.

12. The fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a sufficient strength to withstand 4 times the weight of the ceiling fan; that the mounting of the suspension system shall be performed  by the manufacturer, its service agent or suitably qualified persons.

13. NOTE: This fan hanging system supports a maximum 9 degree angled ceiling installation.

14. NOTE: The bracket screws provided are for use with wooden structures only. For structures other than wood, the appropriate screw type MUST be used. Ensure the screws used are suitable for the mounting surface and the  surrounding environment.

15. NOTE: If there are two or more DC ceiling fans installed in the one location, an Isolation switch is required for each ceiling fan, this is required when programming the remote and receiver to pair together.

16. NOTE: Don’t run the motor without blades installed!

17. Take note the correct side of the blades with the marking “THIS SIDE UP” faces the cceiling.

18. NOTE: The fan don’t include lamp(O), Fan installation step 10, install the Non-Light decoration plate (I) on the fan assembly. If lamp (O) is required, install the lamp(O) on the fan assembly.
    Remark: lamp(O) sold separately.

19. NOTE: when use with extension down rod, use the light kit extension cable (H).

PARTS LIST

INSTALLATION GUIDE

USING YOUR CEILING FAN

REMOTE CONTROL

1. Test the remote by pressing and hold any button. A blue LED will be lit up at the top of the remote to indicate that there is power to the remote and it is ready for use to control the fan.
2. Follow the guide below to operate the fan and learn the functions.
   

The remote has memory function. If the fan or light is turned off by the isolating switch over 7 seconds, the next time to turn on the fan or light will be on last setting

REPAIRING THE FAN RECEIVER & REMOTE PAIRING
NOTE: The pairing of the remote and receiver has been done at the factory.
When the ceiling fan is installed, pairing the fan receiver and remote is NOT required.
Should the remote and receiver lose control after installation or during use, the pairing of the remote and the receiver must be repaired. Below are the operating symptoms and method to repair the pairing of the DC ceiling fan remote and receiver.
Issues:

• Loss of control – Fan is only running at high speed after installation
• Loss of control – No reverse function after installation
• Loss of control – Remote cannot communicate with the receiver Solution:
• Switch off the main power of ceiling fan.
• Switch on the main power of the ceiling fan. Press and hold the On/Off button on the remote for 5 seconds within 30 seconds after switching on. There will be a notification ‘beep’ sound from the receiver to indicate that the paring  process is successful.
• Turn on and select the different speed of the ceiling fan to check the operation of the fan.

AFTER INSTALLATION

NOTE: Ceiling fans tend to move during operation due to the fact that they are mounted on a rubber grommet.
If the fan was mounted rigidly to the ceiling it would cause excessive vibration. Movement of a few centimetres is quite acceptable and DOES NOT suggest any problem.
TO REDUCE THE FAN WOBBLE: Please check that all screws which fix the mounting bracket and down rod are secure.
BALANCING KIT: A balancing kit (E) is provided to balance the ceiling fan on initial installation. Please refer to the instruction on how to use the balancing kit. The balancing kit can be used to assist re-balancing should the ceiling fan  become un-balanced again. Store your balancing kit away after installation for future use if required.

NOISE:
When it is quiet (especially at night) you may hear occasional small noises. Slight power fluctuations and frequency signals superimposed in the electricity for off-peak hot water control, may cause a change in fan motor noise. This is  normal. Please allow a 24-hour “settling-in” period, most noises associated with a new fan disappear during this time.
The manufacturer’s warranty covers actual faults that may develop and NOT minor complaints such as hearing the motor run – All electric motors are audible to some extent.

CARE & CLEANING

NOTE: Always turn OFF the power at the mains switch before performing any maintenance or attempting to clean your fan.

• Every 6 months periodic cleaning of your ceiling fan is the only maintenance required. Use a soft brush or lint free cloth to avoid scratching the paint finish. Please turn off electricity power when you do so.
• Do not soak or immerse your ceiling fan in the water or other liquids. It could damage the motor or the blades and create the possibility of an electrical shock.
• Ensure that the fan does not come in contact with any organic solvents or cleaners.
• To clean the fan blade, wipe with only a damp clean cloth with NO organic solvents or cleaners.
• The motor has a permanently lubricated ball bearing so there is no need to oil.

SAFETY PRECAUTIONS FOR BATTERY

• WARNING – Keep new and used batteries away from children.

• CAUTION – Do not ingest battery—Chemical burn hazard.

• Always use 2 x AAA battery type with this ceiling fan remote controller.

• Ensure the batteries are inserted with the correct polarity.

• To prevent false operation during battery insertion or replacement, this ceiling fan must be disconnected from the supply mains.

• non-rechargeable batteries are not to be recharged;

• different types of batteries or new and used batteries are not to be mixed;

• Remove batteries from the product when not in use for long periods of time.

• Batteries must be removed from the remote transmitter before it is discarded.

• Dispose of exhausted batteries immediately and safely (so they cannot be retrieved by children).
  Batteries can still be dangerous. Contact your local council to safely dispose of the battery.

• Regularly check the product and make sure the battery box lid is correctly secured. If the battery compartment does not close securely, stop using the product and keep it away from children.

• If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. If you suspect your child has swallowed or inserted a button battery, call the emergency number of your  country if you are in Europe for fast, expert advice.

• Battery Leaks: Battery contains chemicals and should be treated as any chemical would. Take precautions when handling leaked battery chemicals. Battery chemicals should not be placed near the eyes or ingested. call the  emergency number of your country if you are in Europe for fast, expert advice.

TECHNICAL INFORMATION

Also compatible with
SKU# 121359: GX53,12W, 4000K, 3 step-dIm (Not Included)
Battery for remote| 2 x AAA (Not Included)
Receiver Model| FC989RS-EW
Weight| 9kg
Canopy Dimensions| H:51mm Dia:140mm

WARRANTY INFORMATION

IN EUROPE – If you are a European customer, please contact the retail outlet where the fan was purchased for warranty service.

References

• Homepage
• Beacon Lighting Europe – Fans and More!

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>