**Benjara BM300716 Ville 23 Inch Round Side End Table User Manual

**

INTRODUCTION

We understand building ready-to-assemble furniture can be a challenging experience for some. To help avoid confusion, we have provided some helpful tips that may speed up the process.

Teamwork
ALWAYS have at least two people to help with transporting and assembling the product to avoid potential injury and/or damage.

Suitable Location
Assembling near the area of the intended location is highly recommended. Sufficient Space Make sure you have enough space to move around during the assembly.

Sufficient Space
Make sure you have enough space to move around during the assembly.

Avoid Scratches
Use cardboard, blankets or a carpeted area while assembling furniture to prevent to prevent scratches and damages.

Flat Surface
Make sure the furniture rests on a flat and level surface with each leg evenly touching the floor.

ASSEMBLY AND CARE ADVICE

FAILURE TO FOLLOW THE GUIDELINES BELOW MAY RESULT IN INJURY AND/OR PROPERTY DAMAGE.

Position each part correctly and insert screws or bolts into their respective holes.

Turn clockwise to tighten and only tighten when step is completed or when instructed to do so.

Use the appropriate hand tools or power tools for assembly. Select steps, such as tightening screws and/or bolts, may require hand tools to avoid causing damage during assembly.

Save the instructions and store any supplied tools for later maintenance

After two weeks, check and tighten any loose hardware and repeat again every six months thereafter.

IT IS THE USER’S RESPONSIBILITY TO MAINTAIN THE FURNITURE. THE HARDWARE MAY LOOSEN OVER TIME AND MAY CAUSE THE FURNITURE TO BE WOBBLY AND UNABLE TO SUPPORT ITS INTENDED WEIGHT CAPACITY. THIS MAY LEAD TO COLLAPSE AND MAY CAUSE SERIOUS INJURY.

PARTS

11pc| Table Top|

---|---|---

2 1pc| Table Bottom|

34pcs| Leg|

A) 16pcs| Bolt 1/4″ x 5/8″|

B) 1pc| Allen Wrench|

ASSEMBLY INSTRUCTIONS

Align three legs (#3) to the top (#1), then secure by using bolts (#A).

Part #1 x 1pc
Part #3 x 3pcs
Hardware #A) x 6pcs

ASSEMBLY COMPLETED

Please ensure the fumiture resta on an even and flat surface. If the product wobbles or feels loose, double check all bots and/or screws are properly tightened and secured.

Part x1pc Part3 x1pc Hardware #A x12pcs

Align shelf (#2) to legs (#3), and last leg (#3) onto top and shelf (#2). Secure by using bolts (

Keep this handy!
Phase on this instruction menual and any
Lift, don’t drag!
To avoid damage to product waj LIFT the product when transporting of Her hacement

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>