WICKED AUDIO WI-BTR4X Make Every Headphone Wireless Audio Receiver User Manual
- June 16, 2024
- WICKED AUDIO
Table of Contents
WICKED AUDIO WI-BTR4X Make Every Headphone Wireless Audio Receiver
QUICK SETUP
- Make sure The Reach is charged.
- Have your phone (or other Bluetooth device on with the Bluetooth feature enabled.
- Turn on The Reach. Hold down center button until the LED flashes red and blue.
- Your phone (or other Bluetooth device) will detect “Wicked Reach.”
- Select “Wicked Reach” to pair. Once successfully paired, the LED will slowly flash blue.
FEATURED
HOW TO USE THE REACH
CHARGING
WARRANTY
LIMITED ONE-YEAR WARRANTY
Keep your receipt to obtain warranty service. Go to WickedAudio.com for more
details.
PRECAUTIONS
LISTENING TO AUDIO AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE.
USE AS LOW A VOLUME AS POSSIBLE.
on maximum time exposure to sound pressure levels before hearing damage
occurs.
SAFE USE & HAZARD WARNINGS
90 dB SPL at 8 hours, 9b dB SPL at 4 hours, 100 dB SPL at 2 hours, 105 dB SPL
at 1 hours, 110 dB SPL at 30
min, 115 dB SPL at 15 min, 120 dB SPL: Avoid as damage may occur
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation
Limitation of Liability Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.
In no event, under any cause of action of a theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential, special, exemplary or punitive damages, of any nature whatsoever, arising out of the use of or inability to use a product.
This includes without limitation, property damage, and loss of value of the product or any third-party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages that one may encounter. Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics devices or other personal property that are contained inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held devices, or any loss of data contained on the foreign device. Notwithstanding any damages that you might incur for the Wicked Audio product giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.
WICKED AUDIO, INC.
875 W 325 N
Lindon, UT 84042
Developed in Utah, U.S.A. / Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>