WICKED AUDIO WI-BTS10 Outcry Bluetooth Single Speaker User Manual
- June 16, 2024
- WICKED AUDIO
Table of Contents
WICKED AUDIO WI-BTS10 Outcry Bluetooth Single Speaker
PRODUCT OVERVIEW
USING INSTRUCTION
-
CHARGING
- Plug the USB end of the charging cord into a power supply, then plug the Micro USB end into the Micro USB port on the the Outcry.
- L.E.D. will flash red to begin charge.
- L.E.D. will flash green as nears fully charged.
- L.E.D. will change to a solid green when fully charged.
- The L.E.D. will only turn a solid green if the speaker is turned off.
-
BLUEYOOTH
- Make sure that the speaker is charged and your Bluetooth device is turned on with the Bluetooth feature enabled.
- Turn on the speaker and the L.E.D. will flash blue.
- Your Bluetooh device should detect “WICKED OUTCRY.”
- Select “WICKED OUTCRY” to pair. Once succesfully paired, the L.E.D. will switch to a solid blue.
(Note: Bluetooth mode will not activate while aux cord is connected).
-
AUX
Connect one end of the AUX cord to the Outcry and the other end to your music device. -
PHONE
- Press the Button to answer the incoming call.
- Press the Button to hang up the call.
(Note: Must be in Bluetooth mode) .
L.E.D. STATES
- SOLID BLUE BLUETOOTH PAIRED / BLUETOOTH PLAY MODE / AUX-IN MODE / ANSWERING INCOMING CALL.
- FLASHING BLUE BLUETOOTH PAIRING / BLUETOOTH IS DISCONNECTED / INCOMING CALL.
- SOLID RED CHARGING.
- SOLID GREEN FULLY CHARGED (Green light only shows when speaker is off.)
Bluetooth®
The Bluetooth® word mark and logos are registered trademarks owned by
Bluetooth SIG, Inc. and any use of such marks by Wicked Audio Inc. is under
license. Other trademarks and trade names are those of their respective
owners.
SPECIFICATIONS
- RANGE 32FT
- DRIVER 40MM
- AUX IN / POWER CORD 3FT
- LITHIUM ION BATTERY LIFE 3hrs
- CHARGE TIME 1.5hrs
- DC 5V 250MAH INPUT
- 4 OHM 3 WATT SPEAKER
1 YEAR WARRANTY
- Keep your receipt to obtain warranty service.
- Go to www.wickedaudio.com for more details.
- Model Number: WI-BTS10
- IC ID:20526-WIBTS10
- FCC ID:2AFM7WI-BTS10
- WICKED AUDIO, INC.
- 875 W 325 N
- Lindon, UT 84042
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions (1)this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation
Limitation of Liability
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. In no event, under any cause of action of theory of liability, shall Wicked Audio Inc., its distributors or suppliers be liable to you or any third party for indirect, incidental, consequential, special, exemplary or punitive damages, of any and all nature whatsoever, arising out of use of or inability to use a product. This includes without limitation, property damage, loss of value of the product or any third party products that are used in or with the Wicked Audio products, even if the Wicked Audio product has been advised of the possibility of such damages that one may encounter. Without limiting the foregoing, you understand and agree that Wicked Audio has no liability for any damages or destruction to the consumer electronics devices or other personal property that are contained in inside or outside the Wicked Audio products. This includes without limitation, laptops, cellular phones, or other hand-held devices, or any loss of data contained on the foreign device. Notwithstanding any damages that you might incur for general damages in contract, tort (including negligence) or otherwise), the entire aggregate liability of Wicked Audio and any of its distributors and/or suppliers shall be limited to the amount actually paid by you for the Wicked Audio product giving rise to liability. Some states and/or jurisdictions do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you. The limitations of liability set forth above shall apply to the maximum extent permitted under applicable law.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>